MieleメーカーDA362-110の使用説明書/サービス説明書
ページ先へ移動 of 36
Operating and Installation Instr uctions V entilation System D A 362-110 T o pr event accidents and machine damage, read these instructions before installation or use.
IMPORT ANT SAFETY INSTR UCTIONS Functional description Guide to the hood Operation Main power switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Joystick . . . . . . . . . . . . . . . . . . . . .
Read these Operating Instructions carefully bef ore installing or using the V entilation System. This appliance is intended for residential use only . Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood.
This equipment is not designed for maritime use or for use in mobile installations such as caravans or aircraft. However , under certain conditions it may be possible for an installation in these applications. Please contact the nearest Miele dealer or the T echnical Service Department with specific requir ements.
, W ARNING - T O REDUCE THE RISK OF A RANGE T OP GREASE FIRE: Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers may ignite. Heat oils slowly on low or medium settings. Always turn the hood “ON” when cooking at high heat or when cooking flaming foods.
Installation , W ARNING T o reduce the risk of fire only use metal ductwork. When installing the hood, follow the recommended minimum safety distances between a Miele cooktop and the hood: – 22" (55 cm) above electric cooktops, – 26" (65 cm) above gas cooktops, – 26" (65 cm) above an open grill.
The ventilation hood offers two modes of operation: . . . Air extraction: The air is drawn in and cleaned by the grease filters and dir ected outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur .
Guide to the hood 8.
a Joystic k The fan and light can be operated with the joystick. b Overhead lighting c Grease filter d Main power s witch e Fan po wer scale f Delay Shut Do wn This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes.
Main power s witch Press the main power switch to "I" to use the fan and lighting. If the appliance is not going to be used for a long period of time (e.g. while vacationing) it should be turned off ("0") at the main power switch. The next time it is turned on, the hood will operate at the level previously used.
T urning on the fan ^ Press the joystick once to the right. The fan runs at power level “lI” and the second indicator of the fan power scale lights. Selecting the power le vel ^ Press the joystick to the right, to increase the fan speed. The corresponding indicator of the fan power scale lights.
Delay ed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes.
Filter timers Grease filter timer A timer monitors the hours of operation. The indicator for the grease filter will light after 30 hours of fan operation. The grease filters must then be cleaned. After the grease filter has been cleaned and put back in place, the grease filter timer must be reset.
Reprogramming the timer s The grease filter timer is pr eset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. – A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. – A time of 20 hours should also be programmed if the kitchen is only used occasionally .
Reprogramming the c harcoal filter timer The active charcoal filter can only be used in recir culation mode and can not be used to exhaust fumes. The charcoal filter timer is not preset . Before using the hood in r ecirculation mode, the charcoal filter timer must be programmed.
Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker . Cleaning the casing W arning: Never use abrasive cleansers, scouring pads, steel wool or caustic (oven) cleaners on the hood.
Grease filters The reusable metal gr ease filters remove solid particles from the vented kitchen air (grease, dust, etc). The grease filters should be cleaned every 3-4 weeks or whenever the grease filter indicator lights. A dirty filter is a fire hazard.
Inserting the grease filters When putting the grease filters back make sure that the locking clips ar e visible facing down towards the cooking surface. If the filters are incorr ectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing.
Active char coal filters In recir culation mode four active charcoal filters must be used in addition to the grease filters. The charcoal filters ar e designed to absorb cooking odors. The are placed in the canopy above the grease filters. Active charcoal filters can be or dered from T echnical Service.
Changing the light bulb Before changing the light bulb, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit br eaker . When in use halogen bulbs become extremely hot, and they can burn your hands.
In the event of a fault which you can not correct yourself please contact: – Y our Miele Dealer or – The Miele T echnical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the T echnical Service Department, please quote the model and serial number of your appliance.
22.
Installation Instr uctions.
Disposal of packing material The cardboar d box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. T o prevent suf focation of children, ensure that any plastic wrappings, bags etc.
All electrical work should be perfor med by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufactur er can not be held responsible for unauthorized work.
*Cut out dimensions A depth T , min. 1 9 / 16 " (40 mm), is necessary in the rear of the cabinet. Appliance dimensions 26.
Do not install this hood over any appliance that burns solid fuel. The minimum safety distance allowed between the top of a Miele cooking surface and the bottom of the hood is: – 22" (55 cm) ab.
The hood is designed to be installed within cabinetry and kitchen islands. The top half (motor and fan assembly) should be accessible after installation. If the motor and fan assembly are not accessible, assemble the ductwork and the electical connection before the installation.
Air extraction mode Non-return flaps ^ Place the non-return flaps into the exhaust connections at the top of the motor assembly so that the flaps open in the "up" direction. ^ T urn the non-return flaps slightly to the left to lock them in place.
Recirculation mode If site conditions are not suitable for the hood to be used for air extraction, the appliance must be converted for recir culation. For recir culation mode the following accessories.
Installing the joystic k ^ Insert the lower half of the joystick into the socket and loosely secure in place with the screw and spring washer . ^ T urn the printed par t of the joystick so that the m -symbol faces front. ^ Tighten the screw with an allen wrench.
Electrical connection Before connecting the appliance to power read the "Important Safety Instructions". ^ Plug in the power cord. ^ Before using the appliance r emove the grease filters and r emove the protective foil fr om the filter frame.
Danger of toxic fumes! Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. The exhaust gases extracted b y the hood should be vented outside of the building onl y . Do not terminate the exhaust ducts in attics, garages, crawlspaces, etc.
Never connect an exhaust hood to an active chimney , dryer vent, vent flue, or room venting ductwork. Seek professional advice befor e connecting an exhaust hood vent to an existing, inactive chimney or vent flue. Important: If the ductwork runs through r ooms, ceilings, garages, etc.
35.
M.-Nr . 05 810 900 / 01 Alteration rights reserved / 4503 This paper was bleached without the use of chlorine..
デバイスMiele DA362-110の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Miele DA362-110をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMiele DA362-110の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Miele DA362-110の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Miele DA362-110で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Miele DA362-110を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMiele DA362-110の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Miele DA362-110に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMiele DA362-110デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
