MieleメーカーT 490の使用説明書/サービス説明書
ページ先へ移動 of 36
Operating instructions for vented tumble dryer T 490 It is essential to read these operating instructions before Q} installing or using the machine to avoid the risk of accident, or damage to the machine.
Contents Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Warning and safety instructions .
Cleaning and care Fluff filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 0 Tumble dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Guide to the appliance Genera l vi ew 1 Supply cable for electrical connection 2 Control panel 3 Door 4 Venti ng conn ecti on, rea r, righ t or le ft (supp lied with the rear soc ket op en) 5 Four hei.
Control panel b “I-O n/0-Of f” butt on for switching the appliance on and off. When the machine is switched on, the drum light will come on as you op en the door. c “Door” butt on to open the door/cancel a programme. This button does not stay press ed in.
Caring for the environment Disposal of packing The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Rather than just throwing these ma- terials away, please ensure they are of- fered for recycling.
Warning and safety instructions Please read the operating instruc- tions before using the tumble dryer for the first time. They contain im- portant information about the safety, use and maintenance of the machine. This will avoid the risk of accidents and damage to the ma- chine.
For safe ty reason s, do not use an ex- ten sion ca ble . There is a dan ger of over heat ing. In the event of a fault, or for clean- ing purposes, the machine is only completely isolated from the electricity supply when: – the plug is withdrawn, or – it is switched off at the mains, or – the mains fuse is withdrawn.
In countries where there are areas which may be subject to infesta- tion by cockroaches or other vermin, pay particular attention to keeping the appliance and its surroundings in a clean condition at all times. Any dam- age which may be caused by cock- roaches or other vermin will not be covered by the appliance guarantee.
Brief instructions Brief description Programmes are selected by turning the programme selector and can be supplemented by pressing the addi- tional option buttons.
Notes on laundry care Before drying , check the drying sym- bol on the textile ca re label . Significance of symbols: q = Dry at normal temperature r = Dry at low temperature (also push in the “Low .
How to dry correctly Hints on saving energy Make sure that yo ur laun dry has been thoro ughly spun at the hi ghest ap pro- priate spin speed before drying. Spin - ning at 1600 rpm, for exampl e, saves appr oxima tely 30 % energy and tim e comp ared with 800 r pm.
2 Selecting a program me Turn the programme selector to the programme required. See the “ Programme chart ” for a de- scription of each programme. 3 Selecting additional option(s) Additional options are switched on or off by pressing the appropriate buttons.
"Clean out airways" indicator light This indicator light shows that the dryer is not working most efficiently or econ- omically. The causes of this check message can be: – the fluff filter in the door is blocked; – the vent ducting or the ventilation out- let is blocked; – the vent ducting is very long.
Altering a programme Once a programme has started, no changes to the programme or addi- tional options will be accepted. If the programme selector is turned to a different programme after a pro- gramme has begun, the “ Drying ” indi- cator light will flash.
Programme chart Programme Fabric type maximum load (2) Special notes COTTONS Extra d ry Mult i-l ayere d fabr ics, not thoroughly dried with “ Normal + ” 5 kg Do not dry jersey wear in the Extra dry program me – tendency to shrink . Normal + Mixed load of cotton fabrics, eg towelling, jerseywear, ie single and multi-layered fabrics.
Progra m m e Fabr ic type Maxi mum load (2) S pecial notes TIMED DRYING Warm air Individual items, (eg bathing cost umes , bath towel s, te a towels) 5 kg – Mult i-l ayer ed fab rics wh ose layers have different drying characteristics.
Programmable functions Notes The programmable functions can be used to create drying programmes to suit your individual requirements. They will remain in the machine ’ s memory until cancelled. One or all of the programmable func- tions can be activated or cancelled (See following page).
Activating and storing in the memory The programmable functions are acti- vated using the additional option but- tons in special combinations with the programme selector to introduce extra features not marked up on the control panel. 1 Switch the machine off and shut the door.
Cleaning and care Fluff filter The fluff which is created by the drying process is collected in the fluff filter in the door. Clean the filter af te r e v er y p rog r a mm e to reduce drying time and save en- ergy. Open the door. Grip the filter by the recessed handle and pull upwards to remove.
Problem solving guide What to do if ... Electrical appliances sho ul d only be rep air ed by qu alified perso nn el. Incorrectly repaired ma- chines may po se a considerab le risk to th e user.
Wha t to do if . . . ? Caus e . . . Rem e d y . . . . . . the drying process goes on to o lo ng Ventilation to and f rom the dryer is insufficient (eg in a small room). Open a d oor or window while the machine is in operation for increased air flow. The dryer cannot blow air out correctly.
Check and indicator lights Wha t to do if . . . Cause . . . Rem e d y . . . . . . the “ Drying ” indic a tor light flashes The programme selector was moved after the beginning of the programme, but the programme continues to run correctly. Turn the programme selector back to its original p osition and the light will go out.
The i nter ior d rum li ght ing does not come on: changing the bulb Open the door. Before changing the bulb, discon- nect the machine from the mains power supply . Unscrew the plastic cover above the door inside the drum. Replac e the b ulb. The light bulb must not exceed the maximum wattage quoted on the data plate and the light cover.
After sales service Repairs In the event of any fault which you can- not remedy yourself, please contact: – your Miele dealer or – your nearest Miele Service Depart- ment (see back cover for the ad- dress).
Installation The machine must be perfectly level to ensure safe and proper operation. Minor differences do not, however, have an adverse effect on operation. The screw feet can be adjusted to compensate for any uneveness in the floor surface. A ventil ation gap of 10 mm must be maint aine d betwee n the b otto m of the machin e an d the floor .
Installation - venting The moist air from the dryer must be vented via a ducting system. When installing avoid : – very long venting sy stems – too many bends or corners – tight corners otherwise the drying result will be les s effective and it will take longer and use more energy.
A short passage for the exp elled air is preferable to ensure the tumble dryer functions as efficiently as possible. Ex- pelled air is slowed down in the vent duct by friction against the inner walls of the duct. The shorter and smoother the inner walls, the less friction occurs.
Tabl e II Effective duct length Internal diameter 0 - 20 m 20 - 30 m 30 - 43 m 43 - 60 m 100 mm 110 mm 120 mm 130 mm Flexible ducting has been used for the following example. See Table I for addi- tional duct length factors for other types of ducting.
Insta ll ing se ve ral machi nes: We recommend that when several ma- chines are being installed each ma- chine should be fitted with a non-return flap (available from a good builders ’ merchant). This will prevent odours being transferred and the build up of condensation in the machines which are not in use.
Moist air can be ducted outside by a wall vent kit or window vent kit, both of which are available from the Miele Spare Parts Department. Example: Wall vent kit 1. Louvre frame 2. Wal l pipe 3. Connecting piece 4. Louvred grille 5. Flap 6. Wood screw 7.
Installation - example 1 Upward ducting via flexible hose to an exhaust flue (side view). 1. Wall pi pe A. = Wire spiral -wound hose 2. Connecting pipe B. = Flexible ducting 3. Flue insulated against damp Installation - example 3 Connecting plastic vent pipe to the tumble dryer (side view).
Electrical connection Electrical connection U.K. All electrical work should be carried out only by a suitably competent person, in strict accordance with national and local safety regulations. The app lianc e is s uppl ied w ith a ma ins cable with moul ded plu g for co nnec tion to a 230- 240V mai ns suppl y.
Consumption data Programmes Capa- city Final spin speed (in a domestic washing machine) Electricity consum p- tion Drying time incl. coolin g do wn tim e Minutes kg rpm kWh 10 A (2 ) 16 A (2 ) COTTONS Extra d ry 5 1200 1400 1600 3.2 3.05 2.8 98 95 87 81 78 72 Normal + 5 1200 1400 1600 2.
Technical data Height . . . . . . . . . . . . . . . . . . . . . . . . . . Width . . . . . . . . . . . . . . . . . . . . . . . . . . Depth . . . . . . . . . . . . . . . . . . . . . . . . . . Weight . . . . . . . . . . . . . . . . . . . . . . . . . Drum volume .
Alteration rights reserved/002 0600 This paper consists of cellulose which has been bl eached wihout the use of chlorine..
デバイスMiele T 490の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Miele T 490をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMiele T 490の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Miele T 490の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Miele T 490で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Miele T 490を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMiele T 490の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Miele T 490に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMiele T 490デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
