Minuteman UPSメーカーMBK-E SERIESの使用説明書/サービス説明書
ページ先へ移動 of 25
User's Manual MBK-E SERIES.
1 © Copyright Para Systems, Inc., 2003 MBK-E Series User's Manual 1 . Introduction 2 2 . Controls and Indicators 5 3. Installation 7 4. Operation 9 5 . T roubleshooting 1 1 6 . Replacing the Battery 12 7 . Obtaining Service 15 8 . Specifications 16 9 .
2 IMPORT ANT SAFETY INSTRUCTIONS SA VE THESE INSTRUCTIONS ! English Thank you for purchasing a MINUTEMAN power protection product. It has been designed and manufactured to provide many years of trouble free service.
3 CAUTION! T o reduce the risk of electrical shock in conditions where the load equipment grounding cannot be verified, disconnect the UPS from the AC wall outlet before installing a computer interface cable. Reconnect the power cord only after all signaling connections are made.
4 English Para Systems Life Support Policy As a general policy , Para Systems Inc. (Para Systems) does not recommend the use of any of its products in life support applications where failure or mal- f.
5 On-Line On-Battery Boost English On-Line/On-Battery/Boost LED Overload LED Weak/Bad Battery LED On/Off/T est Button Fault LED Press and release the ON/OFF/T est Button after 1 beep to turn the UPS ON or OFF (see section 4).
6 REAR P ANEL English 5 4 3 2 1 9 8 6 7 1. The Information/Rating Label. 2. The Battery Backup and Surge output power receptacles are NEMA 5-15R type. 3. The USB Communications Interface Port is for UPS monitoring and control. 4. The Surge ONL Y output power receptacles are NEMA 5-15R type.
7 INST ALLA TION PLACEMENT The MBK-E series is intended to be install in a temperature controlled environ- ment that is free of conductive contaminants.
8 English DO NOT plug Power Strips or Surge Protection Devices into the ”Battery Backup” Receptacles on the UPS. Plugging Power Strips or Surge Protection Devices into the “Battery Backup” Receptacles may cause internal damage to the UPS, the Power Strip, or the Surge Protection Device.
9 English TURNING THE UNIT ON/OFF ON / OFF / T est Button SELF TEST Press and release the ON/OFF/T est Button after one beep to turn the UPS ON and supply power to the load. The load is immediately powered while the UPS runs a two-second self test. Press and release the ON/OFF/T est Button after one beep to turn the UPS OFF .
10 English COMMUNICA TIONS PORT The MBK-E series comes standard with a USB communication port. NOTE: See the SentryII CD for the Power Monitoring Software installation.
11 English Possible Cause Symptom What T o Do Press and release the On/Off/ T est button to start UPS On/Off/T est button not pushed UPS will not turn on Reset circuit breaker by pressing the plunger back in.
12 English REPLACING THE BA TTER Y The MBK-E Series UPS has an easy to replace hot-swappable batteries. Please read all of the W ARNING and CAUTIONS before attempting to service the batteries. NOTE: If there is a power interruption while replacing the hot-swappable batteries, with the UPS on, the load will not be backed up.
13 English BA TTER Y REPLACEMENT PROCEDURE PLEASE READ THE CAUTIONS AND W ARNINGS BEFORE A TTEMPTING TO REPLACE THE BA TTERIES Hot-swappable batteries mean that the batteries can be replaced without powering down the whole UPS system.
14 English 9. Disconnect the positive (red) wire from the battery positve terminal. 10. Disconnect the battery negative (black) wire from the battery negative terminal. NOTE: Use CAUTION, do not touch the battery positive wire to the battery negative wire.
15 English IF THE UPS REQUIRES SERVICE 1.Use the TROUBLESHOOTING section to eliminate obvious causes. 2.V erify there are no circuit breakers tripped. A tripped circuit breaker is the most common problem.
16 English Default 120V AC (User selectable at 120/127V AC) 2-4 years, depending on discharge cycles and ambient temp 550V A/330W 750V A/450W 500 J 0 ns (instantaneous) normal mode; <5 ns common mode <5% Normal and common mode EMI/RFI suppression 1-12V7Ah 2-12V7Ah Audible noise at 1 m (3 ft.
17 English (These items may require optional software or hardware) Function Factory Default Description User Choices Set inverter output voltage Set audible alarm state Enable/ Disable auto restart Ba.
18 English Para Systems Inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials (ex- cluding batteries) or workmanship for a period of three years from the date of purchase.
19 English EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL P ARA SYSTEMS BE LIABLE FOR DIRECT , INDIRECT , SPECIAL, INCIDENT AL, OR CONSEQUEN- TIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT , EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
20 DECLARA TION OF CONFORMITY Application of Council Directive(s): 89/336/EEC, 73/23/EEC Standard(s) to which Conformity is declared: EN50091-1-1, EN50091-2 Manufacturer’s Name: Para Systems, Inc.
21 Notes: English.
22 English Notes:.
23 Page do not print.
Para Systems, Inc. 1455 Lemay Dr . Carrollton, TX 75007 Phone: 1-972-446-7363 Fax: 1-972-446-901 1 Internet: minutemanups.com UPS Sizing: sizemyups.com PN - 34000227 Rev .
デバイスMinuteman UPS MBK-E SERIESの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Minuteman UPS MBK-E SERIESをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMinuteman UPS MBK-E SERIESの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Minuteman UPS MBK-E SERIESの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Minuteman UPS MBK-E SERIESで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Minuteman UPS MBK-E SERIESを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMinuteman UPS MBK-E SERIESの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Minuteman UPS MBK-E SERIESに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMinuteman UPS MBK-E SERIESデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
