MioメーカーSELF CLEAN C SERIES IIの使用説明書/サービス説明書
ページ先へ移動 of 12
Aquachlor Salt Water Chlorinator Owners Manual Model Standard and Self Clean C Series II Manufactured in Australia By Monarch Pool Systems www.monarch poolsystems.
2 Aquachlor Salt Chlorinator Thankyou for purchasing a Quality Aquachlor Pool and Spa Product. Please read all information in this Manual carefully before installing or operating your AQUACHLOR SALT CHLORINATOR.
3 INSTALLATION INSTRUCTIONS FOR AQUACHLOR C and SC INSTALLING THE POWER SUPPLY : Select a convenient well-ventilated location within one metre of filter equipment and mount the Power Supply vertically onto a post or wall 1.5 metres above ground level.
4 PRE - START UP PROCEDURE : Before operating your Aquachlor Chlorinator please ensure the following items have been added to your pool: • SALT - Load salt into the pool at a minimum rate of 40kg per 10,000 litres (0.4%). Connect vacuum system and slowly vacuum until salt dispersal is complete.
5 BAR METER WARNING LED REASON/ACTION Off Green 1. Start – up delay functioning. 2. System Control set below max. Cell is turned off. (Refer System Control page 7). Off Red 1. Gas detected. Check pump/pipes for damage. 2. Gas sensor not connected to cell 4 or 5 LEDs on Green System operating normally 1 to 5 LEDs on Red 1.
6 If the Cell is OFF and you wish to check its operation, simply turn the System Control to MAX and the Cell will turn ON. Once checked, adjust the System Control back to the desired position and after a few minutes the Cell will turn OFF again. To turn the Cell OFF, simply turn the System Control to MIN.
7 Terminal Block the coloured wires from your pool light are connected. The Light Transformer is for use with 12volt pool lights, maximum power is 150Watt. Please Note: Only one light can be connected to each light transformer. If more than one light is required please refer to your Aquachlor dealer.
8 Aquachlor C Standard Aquachlor SC Self Clean C Standard Systems Model C Replacement Cell Model to order SC Self Clean Systems Model SC Replacement Cell Model to order 260 260 250 250 390 390.
9 Stabiliser should be added at the rate of 500 grams for every 10,000 litres of water. To add, place the required amount in a stocking and tie a brick to it. Place the stocking in front of the return jet. It will dissolve in 2 – 3 days. Stabiliser should be maintained at a level of 30 – 50 ppm.
10 The Aquachlor unit has a built in warning system to minimise damage resulting from insufficient salt levels, however, the ultimate responsibility is on the owner to ensure adequate salt levels are maintained all year round.
11 Aquachlor Model C (Standard) Aquachlor Model SC (Self Clean) Productio n maximum grams/hou r (100%) Production * grams/hour (65% equivalent) Chlorine produce d over 8 hours grams (100%) Equivalent in dry granulated chlorine grams (65%) Equivalent in liquid chlorine litres (12%) 220 250 16.
12 IMPORTANT: ALWAYS INSIST ON GENUINE AQUACHLOR REPLACEMENT PARTS. If it is necessary to replace the Electrolytic Cell, beware of “look alikes”. Only the Genuine Aquachlor Cell is designed and warranted to operate with the Aquachlor Power Supply.
デバイスMio SELF CLEAN C SERIES IIの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Mio SELF CLEAN C SERIES IIをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMio SELF CLEAN C SERIES IIの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Mio SELF CLEAN C SERIES IIの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Mio SELF CLEAN C SERIES IIで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Mio SELF CLEAN C SERIES IIを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMio SELF CLEAN C SERIES IIの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Mio SELF CLEAN C SERIES IIに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMio SELF CLEAN C SERIES IIデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。