MK SoundメーカーS-1Cの使用説明書/サービス説明書
ページ先へ移動 of 20
Miller & Kreisel Sound Corporation 10391 Jef ferson Boule v ard Culv er Cit y , CA 90232 USA (310) 204-2854 F AX (310) 202-8782 © 1995 MILLER & KREISEL SOUND CORP.
satellite speakers page 2 1. INTRODUCTION...........................................................................................................3 2. PLACEMENT OF YOUR SATELLITE SPEAKERS.............................................................3 3.
satellite speakers page 3 1. INTRODUCTION Congratulations! Your new M&K Satellite speaker system will give you years of unmatched enjoyment and excitement while listening to your favorite musical and audio/video sources.
satellite speakers page 4 There are a very wide variety of premium speaker cables available from a number of specialist manufacturers. We do not endorse any specific brand of premium cable, but we do recommend using as high quality a cable as fits your budget.
satellite speakers page 5 FIGURE 1 WIRING WITH THE S-100B AMPLIFIER LEFT RIGHT + _ + _ MADE IN USA INPUT 4 ohms MILLER & KREISEL SOUND CORPORATION MIDRANGE CONTOUR 10391 Jefferson Blvd.
satellite speakers page 6 4. S-90 SPEAKER HOOK-UP & USAGE The sound quality that you get from your Satellites can be affected by the type of speaker wire that you use to connect them. While it is possible to use speaker wire as thin as 22 gauge to hook your Satellites up, we recommend using the largest diameter wire that you can.
satellite speakers page 7 FIGURE 2 WIRING WITH THE S-90 to a higher efficiency, it requires a higher setting of the subwoofer level. Conversely, when you switch to a lower efficiency, the subwoofer level should be set lower.
satellite speakers page 8 actually "flat", due to equalization in the recording process, and artificial alteration of high frequencies is common. 5. S-80 SPEAKER HOOK-UP & USAGE The back panel of your S-80 speakers contains two pairs of speaker terminals (instead of the usual single pair).
satellite speakers page 9 FIGURE 3 WIRING WITH THE S-80 SATELLITE S PEAKER CONNECT AM PLIFI E R TO ONL Y ONE RED AND ONE BLACK TERM INAL (see inst ructions) H IGH H IGH LOW LOW MADE I N USA TWEE TER L.
satellite speakers page 10 The HIGH EFFICIENCY input gives a bright, forward sound with great efficiency and a wider dynamic range. Particularly useful for producing maximum sound power levels, especially with low-powered amplifiers. Sometimes referred to as the "German Sound.
satellite speakers page 11 listening environment. However, getting the best tonal balance in any given room involves many variables. Therefore, your S-1C Satellites allow you to alter their tonal balance in order to get the ideal sound quality at your favorite listening location (where it counts!), through the use of two three-position switches.
satellite speakers page 12 to the LOW EFFICIENCY position. Relative to NORMAL, the LOW EFFICIENCY position has an warmer, mellower mid-bass sound with a more distant perspective. When you are locating the speaker directly on a surface such as a wall, floor or ceiling, you may find that HIGH EFFICIENCY position gives the best response.
satellite speakers page 13 AMPLIFIER + _ + _ ONE CHANNEL ONLY IS SHOWN HIGH TWEETER MADE IN USA MILLER & KREISEL SOUND CORPORATION MIDRANGE CONTOUR 10391 Jefferson Blvd.
satellite speakers page 14 A. HEIGHT (OR ANGLE) Your M&K Satellites will always deliver sound superior to conventional speakers, regardless of where you locate them.
satellite speakers page 15 in this diagram due to an optical illusion). Try to follow the formula as close as you can. You can fine tune the placement by listening to a source with an image (such as a vocalist) centered between the speakers.
satellite speakers page 16 Meter (available for less than about $40) and use it to measure the output of the speakers when playing the test tones generated by your processor or receiver. See your processor or receiver's instruction manual for how to perform the calibration.
satellite speakers page 17 to five feet or more from the back wall. An alternate location in this room might be on the back wall of the room, at the same height, a few feet from the corners. Symmetrical arrangements work best. It is best to locate them at least a few feet away from the nearest listener's head.
satellite speakers page 18 10. SPEAKER D A MA GE & HO W T O A V OID IT An important factor to consider with any loudspeaker system is the potential for speaker damage.
satellite speakers page 19 All M&K Satellite speakers carry a five year limited parts and labor warranty. This warranty is transferable to new owners up to five years from the date of original purchase.
satellite speakers page 20 FIGURE 7 SELECTING THE RIGHT OMNIMOUNT ® BRACKET S-100B S-90 (when threaded inserts are on the back of the S-90) USE OMNIMOUNT ® 75-WA Four threaded inserts are located on the back baffle of the cabinet. Mount the bracket to the speaker using 5/8" long 1/4" x 20 pan head or round head machine screws.
デバイスMK Sound S-1Cの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
MK Sound S-1Cをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMK Sound S-1Cの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。MK Sound S-1Cの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。MK Sound S-1Cで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
MK Sound S-1Cを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMK Sound S-1Cの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、MK Sound S-1Cに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMK Sound S-1Cデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
