Napoleon FireplacesメーカーNZ6000の使用説明書/サービス説明書
ページ先へ移動 of 32
W415-0594 / A / 02.15.07 1 W415-0442 / C / 09.01.03.
W415-0594 / A / 02.15.07 2 WARNINGS & SAFETY PRECA UTIONS.
W415-0594 / A / 02.15.07 3 T ABLE of CONTENTS PLEASE RET AIN THIS MANU AL FOR FUTURE REFERENCE PG 2 -6 INTRODUCTION Warnings and safety precautions Warranty General Instructions General Information Ca.
W415-0594 / A / 02.15.07 4 NAPOLEON products are manufactured under the strict Standard of the World Recognized ISO 9001 : 2000 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in their work.
W415-0594 / A / 02.15.07 5 INTRODUCTION GENERAL INSTRUCTIONS 1. Combustion and dilution air is brought into the unit through the fresh air intake collars located on the top rear of the unit. 2. The combustion air is brought into the firebox through many small holes in the airwash located at the top and sides of the opening.
W415-0594 / A / 02.15.07 6 If the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot fire will clean the glass.
W415-0594 / A / 02.15.07 7 4 3 / 8 " 19 3 / 8 " 25 3 / 16 " 51 1 / 2 " 50 1 / 4 " 43" 6 1 / 2 " 29 1 / 2 " 48 5 / 8 " 27 1 / 2 " 41 " 49 1 / 2 &q.
W415-0594 / A / 02.15.07 8 Note: In order to avoid the possibility of exposed insulation or vapour barrier coming in contact with the fireplace body , it is recommended that the walls of the fireplace enclosure be “finished” (ie: drywall/sheetrock), as you would finish any other outside wall of a home.
W415-0594 / A / 02.15.07 9 The fireplace face and enclosure ceiling must be framed using 2x4 metal studs. The minimum enclosure ceiling height is 7 feet.
W415-0594 / A / 02.15.07 10 The Napoleon Model NZ6000 takes outside air directly into the fireplace through the openings in the left and right hand sides. Decide on the most convenient lo- cation for the fresh air inlet ducts and hoods which may be installed above or below floor level.
W415-0594 / A / 02.15.07 11 An acceptable 61½" x 20" non-combustible (ie: brick, stone or ceramic tile) hearth extension must be installed. Hearth must extend 20" in front of the faceplate when it is not elevated (see local building codes).
W415-0594 / A / 02.15.07 12 HEARTH EXAMPLES ELEV A TED HEARTH RAISED HEARTH ELEV A TED / RAISED HEARTH.
W415-0594 / A / 02.15.07 13 FA CE PLA TE, UPPER GRILL, KEY ST ONE & DOOR INST ALLA TION 1 Remove the facing template held in place with the 12 screws shown. Dis- card the screws and template. 2 Mount the keystone and upper grill to the face- plate, as shown, using the 4 nuts supplied.
W415-0594 / A / 02.15.07 14 A raised hearth together with the fireplace built on a raised platform is recommended for easier wood loading and fire viewing. The diameter of the chimney is 8". A chimney venting the fireplace shall not vent any other appliance .
W415-0594 / A / 02.15.07 15 4 ELBOWS 2 ELBOWS STRAIGHT UP No Off-Set. Minimum overall chim- ney height is 15 feet. Single off-set with two 15°, 30° or 45° elbows. Minimum overall chimney height is 15 feet. Double off-set with four 15°, 30° or 45° elbows.
W415-0594 / A / 02.15.07 16 The first flue offset closest to the top of the unit must be a minimum distance of 12" from the top of the fireplace. Attach an elbow to the chimney section, angled toward the offset. Secure with 3 - #8X1/2" sheet met al screws.
W415-0594 / A / 02.15.07 17 The Napoleon Model NZ6000 may be connected to either a lined or unlined masonry chimney . IF THE CHIMNEY IS LINED, the flues must be made of vitrified clay and be in sizes of 8" square or 8" round (inside diameters) or 8"x12" with a minimum height of 15 feet above the fireplace.
W415-0594 / A / 02.15.07 18 The door latch is adjusted by moving the washer from one side of the latch to the other . T ighten the outer nut to secure the latch. FINISHING Install the air control threaded rod and knob. A TT ACHING THE HANDLE AND AIR CONT OL KNOB AIR COOLED CHIMNEY INST ALLA TION 1.
W415-0594 / A / 02.15.07 19 FIREBRICK AND BAFFLE INST ALLA TION OPTIONAL NZ64 BL O WER KIT INST ALLA TION Route a 120 V olt, 60Hz electrical supply (not supplied) from the electrical box on the side of the unit to the electrical box on the blower housing.
W415-0594 / A / 02.15.07 20 3. Connect the 6” collar to the blower opening located on the side of the unit. An optional opening is covered on the other side of the unit. If this location is preferred, switch the cover plate and collar . Secure by reaching through the collar and bending the tabs.
W415-0594 / A / 02.15.07 21 6. Insert the filter into the grill. Foam gasket ( 1 / 2 ” weather stripping) between the grill and blower housing is recom- mended, but not supplied. The blower filter is washable. 7. The bottom lip of the grill latches over the bottom lip of the housing.
W415-0594 / A / 02.15.07 22 NZ64 BLOWER REPLACEMENT 1. Remove the grill and filter by removing the 2 securing screws. 2. Remove the nut securing the blower bracket to the hous- ing. 3. Lift the handles to pull the blower and bracket off of the stud. 4.
W415-0594 / A / 02.15.07 23 Roll up some newspaper , light it and place it near the fire- place flue until the chimney begins to draw . When a fire is burning, open the door slowly to avoid drawing smoke into the room. A properly installed Napoleon fireplace should not smoke.
W415-0594 / A / 02.15.07 24 5. T o maintain a brisk fire, a hot coal bed must be estab- lished and maintained. 6. Slowly add larger wood (2x4 size pieces). Lay the pieces lengthwise from side to side in the hot coal bed with a shallow trench between, so that the primary air can flow directly into this trench and ignite the fuel above.
W415-0594 / A / 02.15.07 25 Can't get the fireplace operating? Use more kindling and paper . Assuming the chimney and vent are sized correctly and there is sufficient combustion air , the lack of sufficiently dry quantities of small kindling is the problem.
W415-0594 / A / 02.15.07 26 A bed of ashes approximately 1 inch deep should be left on the firebox bottom to help maintain a hot charcoal bed. When the fire has burned down and cooled, remove any excess ashes. T o remove the ash, follow the directions below .
W415-0594 / A / 02.15.07 27 At the end of each burning season inspect the door gasket ensuring that it is not worn or loose. Replace with proper fibreglass rope. The purpose of door gasketing is to seal the firebox. If the doors are not sealed, air leaks into the firebox, creating a quick burning fire.
W415-0594 / A / 02.15.07 28 When wood is burned slowly , it produces t ar and other organic vapours which combine with expelled moisture to form creosote. These vapours condense in the relatively cooler chimney flue of a slow burning fire and when ig- nited, make an extremely hot fire.
W415-0594 / A / 02.15.07 29 # P ART N O. DESCRIPTION 1 W300-0069 DOOR GLASS 2* W562-0035 DOOR OR GLASS GASKET 3* W562-0036 DOOR GASKET - CENTRE 4* W010-1225 GLASS & GASKET 5* W690-0005 120V THERMO.
W415-0594 / A / 02.15.07 30.
W415-0594 / A / 02.15.07 31 Smoke enters the room during start- up. Cold air blockage. - burn a piece of newspaper to establish a draft. Close the doors. - if the flame is not getting enough air , first make sure the air control is open. If additional air is needed, open the doors a small crack only .
W415-0594 / A / 02.15.07 32 RA TING PLA TE RA TING PLA TE IS LOCA TED BEHIND THE FIREPLA CE F ACEPLA TE..
デバイスNapoleon Fireplaces NZ6000の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Napoleon Fireplaces NZ6000をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはNapoleon Fireplaces NZ6000の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Napoleon Fireplaces NZ6000の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Napoleon Fireplaces NZ6000で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Napoleon Fireplaces NZ6000を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はNapoleon Fireplaces NZ6000の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Napoleon Fireplaces NZ6000に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちNapoleon Fireplaces NZ6000デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
