Omega Vehicle Securityメーカー850iの使用説明書/サービス説明書
ページ先へ移動 of 26
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the "Company"), are warranted to be free from defects in materials and workmanship under normal use.
INSIDE FRONT COVER PRINTER’S NOTE: blank page. INSIDE BACK COVER PRINTER’S NOTE: blank page..
Page 48 Page 1 TABLE OF CONTENTS About Your New Crime Guard System .................................. 3-5 Status Light, Valet Switch, Transmitter & Transceiver Using Your Crime Guard System ........................................... 6 Remote Arming By Transmitter or Transceiver .
Page 2 # FEATURE DEFAULT #1 SecureCode Programming 1 Press (n/a) #2 30 / 60 Second Activated Alarm Cycle 30 Seconds (U) #3 3 / 45 Second Arming Delay 3 Seconds (L) #4 Last Door Arming OFF (U) #5 Autom.
Page 46 Echo is configured for “MUTE” operation (vibrates instead chirping), then in programming it will not play the musical melodies. Instead, it vibrates when the remote starting Start Melody and Stop Melody are accessed for program- ming.
Page 4 • The locked or unlocked pad- lock (windshield) reflects the true locked or unlocked status of the doors (certain pro- grammable features can auto- matically arm the system, but not lock the doors).
disarming with the transmitter/transceiver will unlock the doors unless the system is activated and sounding. • “VALET” indicates Alarm Valet Mode, replacing the “ARM” or “DISARM” icons. A musical tone occurs when placing the system into Alarm Valet Mode.
Arming the Crime Guard system turns on the antitheft protection, disables the vehicle’s starter and locks the doors (provided an interface is installed). Once the system is Armed , any intrusion attempt will Activate it, sounding the siren and flashing the lights to attract attention.
Arming Bypass: When arming the system using the transmitter or transceiver, if any pro- tected zone or sensor circuit is in a violated condition, the affected zone or circuit will be automatically bypassed. This is “Arming Bypass”, which allows the system to still arm and protect the other normal, non-violated zones.
The Last Door Arming process: 1- When the vehicle’s ignition has been turned off, the system waits until a door is opened. When the door is closed, or when the last door is closed when more than one door is opened, the siren will chirp twice, the parking lights will flash twice, and the Status Light will begin flashing Red rapidly.
While the system is in the Armed state: • The Status Light will be flashing slowly Red to confirm that the system is armed, and also serve as a visual deterrent. • The starter interrupt circuit is engaged. • All protected zones are being monitored for intrusion attempts.
Page 39 Feature #24 Door Lock/Unlock Pulse Duration (Factory Default Setting .8 Second) This feature, for the installer’s use, offers the selection of a .
Page 11 Safety Disarm Feature: Pressing and releasing the “Disarm/Unlock button while the system is activated in the alarm condition will disarm the system, but the doors will re- main locked. This is the “Safety Disarm” feature, which allows the vehicle to remain secure, even though an activated system has been disarmed.
Page 12 Automatic Rearming: Automatic Rearming is a programmable feature which ensures that your system is never inadvertently disarmed. It is possible to accidentally or unknowingly operate the transmitter from a pocket or purse.
the Vehicle Recovery operation from the transmitter or transceiver in the event that you are forced from your car. “Remote Activated” Vehicle Recovery is one three methods of activating this feature, which is explained on page 27.
Page 35 Feature #14 Ignition Activated Vehicle Recovery (Factory Default Setting Off) The Vehicle Recovery feature activates the system into an alarm condition automatically in the event that you are forced from your car. “Ignition Activated” Vehicle Recovery is one three methods of activating this feature, which is explained on page 27.
Page 34 Feature #12 Doors Lock With Last Door Arming (Factory Default Setting Off) This feature adds the automatic locking of the doors to feature #4, Last Door Arming. If this feature is turned on, the doors will lock when the system becomes armed 30 seconds after closing the last door.
* An optional doorlock interface must be installed. When Auxiliary #2 is operated, all of the doors will unlock, even if the vehicle is configured with Driver’s Door Priority.
Sensors : The Crime Guard 850i 4 e security system is equipped with a Glass Breakage and Dual-Zone Infrasonic Impact Sensor to increase the effectiveness of the system.
Feature #4 Last Door Arming (Factory Default Setting Off) This feature configures the system to automatically Arm itself 30 seconds after the vehicle’s last door is closed. Programming Last Door Arming: Follow Steps 1 to 4 on page 28; at Step 4 the Valet Switch will be pressed and released four times.
Page 19 THE PARKING LIGHTS WILL ILLUMINATE* To Activate Remote Starting: THE ENGINE STARTS To remote start the vehicle: 1- Press and release together the transmitter or Echo transceiver’s “Arm/Lock” and “Disarm/Unlock” buttons.
To Change a Feature: Step 5 After accessing the desired feature, within 10 seconds Press & Re- lease either the transmitter/transceiver’s “Arm/Lock” button or the “Disarm/Unlock” button. • Pressing the “Arm/Lock” button turns the feature on; the siren will chirp once and the Status Light will turn on.
Pit-Stop Feature: This feature allows you to turn off the ignition switch, remove your keys, leave the vehicle and lock your doors while leaving the en- gine running. To use this feature, have the engine running normally from the ignition switch, have the gear selector in “park”, and your foot off of the brake pedal.
VEHICLE RECOVERY Your system is equipped with three separately programmable Vehicle Recovery protection features, which also provide Anti-Carjacking protection. The Vehicle Recovery operation may be selectively activated by the ignition, by an open door, or by the transmitter or Echo transceiver.
and pause to indicate which protected zone was violated while the system is still armed, after it’s disarmed, and until the vehicle’s ignition is turned on.
Page 25 The Status Light visually confirms the status of the system and provides a high level of visual deterrence. Two colors are shown- Red for security operations, and Green for remote starting operations. Combinations of both colors are seen when the two operations are occurring together.
デバイスOmega Vehicle Security 850iの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Omega Vehicle Security 850iをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはOmega Vehicle Security 850iの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Omega Vehicle Security 850iの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Omega Vehicle Security 850iで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Omega Vehicle Security 850iを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はOmega Vehicle Security 850iの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Omega Vehicle Security 850iに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちOmega Vehicle Security 850iデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。