PeaveyメーカーIRM 8150の使用説明書/サービス説明書
ページ先へ移動 of 16
1 IRM 8150 Powered Mixer.
2 Thank you for purchasing the Peavey IRM™ 8150 mixer amplifier . This is an eight-channel, easy-to-use, powered mixer . Y our IRM ™ 8150 features a rugged, heavy-gauge, cold-rolled steel and aluminum chassis, finished in oven-cured epoxy for toughness and screen-printed utilizing the latest photo- graphic film and U.
3 CHANNEL SECTION: LEVEL (1) Controls the channel output level. This signal is routed via the main bus to the main level control. The channel level also affects the signal to the AUX send control. MONITOR (MON.) (2) Controls the channel monitor mix level.
4 AUX SEND (6) Controls the channel AUX drive level. This signal is routed to the AUX master control, where AUX send signals from all channels are summed together. Controls amount of send from a particular channel to AUX output. The channel level control also affects the signal from the AUX send.
5 TAPE/AUX TO MON (14) Controls the level of tape or AUX IN signal to be sent to the mon. bus. This signal will be mixed with channel monitor signals. TAPE OUT/TAPE IN: CAUTION Before placing connected tape decks in the "record" mode, set the TAPE/AUX IN level control to "0" or off.
6 LINE INPUT JACK (18) For use with line level signal or compatible high Z microphones equipped with a 1/4" phone plug. NOTE: These input jacks (17 & 18) are typical of each channel. It is possible to use both the mic and line inputs on a single channel simultaneously.
7 VENT VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. POWER SWITCH (28) Center position is OFF.
8 SPECIFICA TIONS NOTE: All specifications are typical unless otherwise noted. 0 dBV = 1 volt RMS 0 dBu = .778 volts RMS All specs are referenced to nominal output level (0 dBV) unless otherwise noted. All measurements are wideband 20 Hz to 20 kHz unless otherwise stated.
9 Output Impedance: 100 ohms MASTER Gain: Main: = 20 dB Monitor: = 15 dB Tape: = 15 dB Aux: = 15 dB Maximum Output Level: Main: = +18 dBV (8.0 V RMS) Monitor: = +18 dBV (8.
10 XFMR 4 Ω GND LO HI Balanced (600 Ω ) 4 Ω – + Direct Output to 4 Ω Speaker T ra nsform er Output to 8 Ω Speaker (Note: Jumper must be in place.) COM 8 Ω 25V 70V NC 8 Ω + – HI XFMR 4 Ω GND LO Balanced (600 Ω ) Jumper Installed XFMR 4 Ω GND LO Balanced (600 Ω ) Jumper Installed HI T o Booster , Amplifier , etc.
11 XFMR 4 Ω GND LO HI Balanced (600 Ω ) 8 Ω – + Direct Output to Multiple Speakers in Parallel. T otal Impedance = 4 Ω 8 Ω – +.
12.
13 CHANNEL INPUT MAX (1/4") (+ 26 dBV) CHANNEL INPUT MINIMUM (1/4") (-20 dBV) CHANNEL INPUT NOMINAL (1/4") (0 dBV) CHANNEL INPUT MINIMUM (XLR) (GAIN -40 dBV) MAIN, MON, T APE, AUX OUTPU.
14 LIMITED WARRANTY Peavey Electronics Corporation warrants to the original purchaser of this new Architectural Acoustics product that it is free from defects in material and workmanship.
15 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following. 1. Read all safety and operating instructions before using this product. 2. All safety and operating instructions should be retained for future reference.
16 Features and specifications subject to change without notice. A Division of Peavey Electronics Corporation 711 A Street / Meridian, MS 39302-2898 / U.
デバイスPeavey IRM 8150の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Peavey IRM 8150をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはPeavey IRM 8150の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Peavey IRM 8150の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Peavey IRM 8150で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Peavey IRM 8150を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はPeavey IRM 8150の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Peavey IRM 8150に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちPeavey IRM 8150デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。