PelcoメーカーBB5Tの使用説明書/サービス説明書
ページ先へ移動 of 20
Pelco • 3500 Pelco Way, Clovis • CA 93612-5699 USA • www.pelco.com In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150 International Customers: Tel (1-559) 292-1981 or FAX (1-5.
2 Pelco Manual C1488M-B (2/99) REVISION HISTOR Y Manual # Date Comments C1488M 6/98 Original version. C1488M-A 9/98 Rev A. Revised the manual to incorporate Spectra™ Lite material. C1448M-B 2/99 Rev B. Revised the input power ratings, certifications, and operating temperatures.
Pelco Manual C1488M-B (2/99) 3 1.0 GENERAL 1.1 IMPORT ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.
4 Pelco Manual C1488M-B (2/99) 1.2 REGULA TOR Y NOTICES NOTE: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC rules. These limits are de- signed to provide reasonable protection against harmful interference in a residen- tial installation.
Pelco Manual C1488M-B (2/99) 5 Figure 1. Back Box Parts COMPASS TOOL SAFETY BRACKET CONDUIT FITTING & LOCK NUT T -RAIL CLIP 1.3 UNP ACKING INSTRUCTIONS Unpack and inspect all parts carefully . Be sure to save the shipping box and any inserts. They are the safest material in which to make future shipments.
6 Pelco Manual C1488M-B (2/99) 2.0 DESCRIPTION The BB5A Series back boxes are used with the SD5 Series of Spectra™ (Software V ersion 3.0) domes and SD5A Series of Spectra II™ domes. The BB5T Series back boxes are used with the SD5T Series of Spectra™ Lite domes.
Pelco Manual C1488M-B (2/99) 7 3.0 INST ALLA TION FOR IN-CEILING MODELS This manual covers the installation of the BB5A-F , BB5A-PB, BB5A-PG, BB5A-PG-E, BB5T -F , BB5T -PG, and BB5T -PG-E back boxes only . For complete installation and operating instructions for the SD5 Series of Spectra™ (Software V ersion 3.
8 Pelco Manual C1488M-B (2/99) 3.1.2 Suspended Ceiling 1. Remove the ceiling tile from the ceiling. 2. Locate the center point to drill a hole in the tile. 3. Drill a hole in the ceiling tile using a 3/32-inch drill bit. 4. Remove the compass tool from the parts bag (refer to Figure 2).
Pelco Manual C1488M-B (2/99) 9 Figure 4. Installing Back Box Figure 5. Fastening Back Box HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILING TILE HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILI.
10 Pelco Manual C1488M-B (2/99) Figure 6. Wiring Diagram for Spectra™ (V er . 3.0) and Spectra II™ THUMBSCREW Figure 7. Wiring Diagram for Spectra™ Lite CONTROL (RS-422) 7 +5 to +24 VDC EXTERNAL.
Pelco Manual C1488M-B (2/99) 11 T able B. 24 V AC Wiring Distances The following are the recommended maximum distances for 24 V AC with a 10- percent voltage drop.
12 Pelco Manual C1488M-B (2/99) 3.3 BACK BOX INST ALLA TION 1. Suspended Ceiling Only (for hard ceiling, go to step 2) – Install the ceiling tile with the back box. Attach a T -rail clip on each side of the ceiling tile as shown in Figure 5. 2. Install a safety chain or cable (not supplied) that will support up to 16 pounds (7.
Pelco Manual C1488M-B (2/99) 13 3.4 BACK BOX CONNECTIONS Depending on the type of dome, refer to either Figure 10 or 1 1 to attach the wiring to the interconnect circuit board inside the back box. Also refer to Figure 6 or 7 if necessary . 1. Earth Ground - Connect earth ground to the middle connector on the power connector .
14 Pelco Manual C1488M-B (2/99) From controller T o 4-Wire terminal on circuit board RX- TX- RX+ TX+ TX- RX- TX+ RX+ 4. Control - If you are using a Coaxitron ® controller , control signals will be trans- mitted over the video coax.
Pelco Manual C1488M-B (2/99) 15 4.0 INST ALLA TION FOR PENDANT MODELS 4.1 PENDANT -MOUNT INST ALLA TION 1. Install the pendant dome mount. Refer to the instructions provided with the mount. If the mount is outdoors, make sure it is properly sealed to keep mois- ture out.
16 Pelco Manual C1488M-B (2/99) 5.0 TROUBLESHOOTING Symptom: LED does not light. If the red power LED on the door of the interconnect circuit board in the back box does not light: 1. T urn off power . 2. Open the door to the interconnect circuit board and check the fuse.
Pelco Manual C1488M-B (2/99) 17 6.0 SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Cable Entry In-Ceiling: .75" (1.91 cm) conduit fitting Pendant: Through 1.
18 Pelco Manual C1488M-B (2/99) Figure 12. SD5 Series Dimension Drawing 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) In-Ceiling Dome Pendant Dome NOTE: V ALUES IN P ARENTHESES ARE CENTIMETERS, ALL OTHERS ARE INCHES. 5.90 (14.
Pelco Manual C1488M-B (2/99) 19 NOTES.
20 Pelco Manual C1488M-B (2/99) 7.0 W ARRANTY AND RETURN INFORMA TION Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. Endura and ExSite are trademarks of Pelco. © Copyright 1999, Pelco. All rights reserved.
デバイスPelco BB5Tの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Pelco BB5Tをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはPelco BB5Tの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Pelco BB5Tの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Pelco BB5Tで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Pelco BB5Tを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はPelco BB5Tの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Pelco BB5Tに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちPelco BB5Tデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。