PentairメーカーLegend IIの使用説明書/サービス説明書
ページ先へ移動 of 20
LEGEND® II INST ALLA TION MANUAL IMPOR T ANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SA VE THESE INSTRUCTIONS Installation Guide Pressure Side Pool Cleaner ®.
LEGEND® II INST ALLA TION MANUAL © 2007 Pentair W ater Pool and Spa, Inc. All rights reserved. This document is subject to change without notice. 1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 • (919) 566-8000 10951 West Los Angeles A ve.
LEGEND® II INST ALLA TION MANUAL ® Important Information: The Legend ® II automatic pool cleaner comes ready to connect into a female threaded 1-1/2" dedicated return line. Other connections are possible, but they require additional fittings. For more information, please contact our T echnical Support Department at 1-800-831-7133.
LEGEND® II INST ALLATION MANUAL T ABLE OF CONTENTS I. Introduction ............................................................................................................................... .1 A. Thank Y ou for Choosing the Legend ® II ........
LEGEND® II INST ALLA TION MANUAL I. Introduction A . Thank You for Choosing the Legend ® II Pool Cleaner Congratulations on the purchase of your new automatic pool cleaner . The Legend ® II is designed to give you years of dependable and efficient service.
LEGEND® II INST ALLATION MANUAL II. Installation Instructions A. Legend ® II Components The Legend ® II Box Contains: 1 . Cleaner Head 2 . Sand & Silt Bag 3 . Sweep Hose 4 . Complete Feed Hose a . 1 - 18 in. hose b . 1 - 2 ft. hose c . 1 - 4½ ft.
LEGEND® II INST ALLA TION MANUAL D. Pressure T esting Instructions 1 . Make sure the pool filter is clean before conducting this pressure test. 2. T wist lock the W all Fitting with Feeder Hose into the W all Adapter . 3. Have someone hold the Pressure T ester end of the Feed Hose beneath the water while you turn on the pool pump.
LEGEND® II INST ALLATION MANUAL F . Hooking up the Legend ® II 1. Remove the Pressure T ester from the free end of the Feeder Hose by unscrewing the Hose Nut. Left hand thread (reverse), (see illustration previous page). 2 . Place mender nut on Legend ® II Swivel Mast.
LEGEND® II INST ALLA TION MANUAL H. Fine Tuning the Legend ® II 1. Thrust Jet Adjustment There are two Thrust Jets located in the back of the Legend ® II. These Thrust Jets alter the direction of the cleaner . The factory standard position for the jets is set slightly to the right.
LEGEND® II INST ALLATION MANUAL 3. Checking RPM - (cont.) 1 . Clean the Screen located inside the W all Fitting. A small amount of debris will significantly affect the performance of the cleaner . 2. Clean the skimmer basket, pump basket and pool filter .
LEGEND® II INST ALLA TION MANUAL III. Operation/Periodic Maintenance A. Connecting/Disconnecting the Legend ® II T urn off pool pump. Then take the W all Fitting and twist lock the W all Fitting clockwise into the W all Adapter . T o disconnect the Legend ® II, unlock and twist counter clockwise.
LEGEND® II INST ALLATION MANUAL III. Operation/Periodic Maintenance - (cont.) 2. Tires & Bearings The tires are designed to protect the bottom of your pool and provide better traction. Y ou need to rotate or replace the tires when edges become rounded.
LEGEND® II INST ALLA TION MANUAL III. Operation/Periodic Maintenance - (cont.) F . Storage and Winterizing Never leave or store the Legend ® II in direct sunlight. When storing the Legend ® II for the winter , be sure to drain all the water from it.
LEGEND® II INST ALLATION MANUAL T o insure the best performance from your cleaner , follow the troubleshooting guide listed below . IV . TROUBLESHOOTING AND PERFORMANCE TIPS Problem: Legend ® II will not back up. Solution: 1 . Determine if the Back-Up V alve is cycling.
LEGEND® II INST ALLA TION MANUAL IV . TROUBLESHOOTING AND PERFORMANCE TIPS A. PROBLEMS & SOLUTIONS - (cont.) Problem: Sweep Hose is sucked into the cleaner . Solution: 1 . Adjust the Sweep Hose using the Adjustment Screw located on the bottom of the Swivel Mast.
LEGEND® II INST ALLATION MANUAL 1. Tips on Hose Cutting for Larger Pools. If the hose is short of the farthest end of the pool, add an additional section of hose (Part # LX17), one Swivel (Part # LX19), two Mender Nuts w/O-Rings (Part # LX20), and one Hose Float (Part # LXD10).
LEGEND® II INST ALLA TION MANUAL Part # LXU5 LXU145N EU10N LXU6 EC86 EC83 EC80 EA40 LXC110 EX120 EC120 EC120 EB5L EB10 EB25 EB20 EA20 EH07 EU15 EU16 EU9 EU7 E18 EC130 EC135 EC65 EC70 EC45 EC6L EC60 E.
LEGEND® II INST ALLATION MANUAL LEGEND ® II P ARTS LIST Part # EB15 EA40 EA40 EC64 EH09C EC131 EA30 EU76 EU147 EU79 LXU8 EU80 LX10 LX11 E12 E13 E14 E15 LX16 LXD10 LX17 LX18 LX20 LX19 LXW22 E21 E23 E.
LEGEND® II INST ALLA TION MANUAL LEGEND ® II EXPLODED VIEW SA VE THESE INSTRUCTIONS. 15.
LEGEND® II INST ALLATION MANUAL 1 1/20/07 P/N YYLXMAN REV . C © Pentair Water Pool and Spa, Inc. All rights reserved..
デバイスPentair Legend IIの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Pentair Legend IIをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはPentair Legend IIの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Pentair Legend IIの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Pentair Legend IIで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Pentair Legend IIを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はPentair Legend IIの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Pentair Legend IIに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちPentair Legend IIデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
