Plinius Audioメーカー8100の使用説明書/サービス説明書
ページ先へ移動 of 18
Class AB Integrated Amplifier.
2.
3 CONGRATULATIONS CONGRATULATIONS CONGRATULATIONS CONGRATULATIONS on your decision to become the proud owner of this Plinius 8100 Integrated Amplifier. This manual has been prepared to help you understand the operation of your amplifier, and to provide information about its design and the variety of ways it may be used.
4 Introduction .................................................................................................................. ................. Page 3 Precautions ....................................................................................
5 Please take special note of the following precautions before operating your new amplifier: • The Plinius 8100 Integrated Amplifier can deliver in excess of 100 watts into 8 ohms. This amplifier is also capable of a very large peak current delivery.
6 PLINIU S RECOR D SOURCE VOLUM E xx x TUNER V CR T APE 1 TA P E 2 AUX CD 81 0 0 The front of the Plinius 8100 Integrated Amplifier incorporates all the facilities you will require on a daily basis.
7 RECORD SELECTOR This rotary switch allows recording of any of the six different inputs available on the back panel. Note that when recording, the source that is being listened to will not be interfered with. For example, it is possible to be listening to the CD input whilst recording from the TUNER input.
8 This panel incorporates all the terminals for connecting the input signals from your CD player, tuner, etc, and the outputs to the loudspeakers and mains supply. Please remember that your Plinius 8100 Integrated Amplifier is a high quality electronic instrument capable of an exceptional level of performance.
9 TAPE OUTPUTS These RCA outputs are situated next to the tape RCA inputs, and are provided to interface to a pair of line level recording devices. The position of the record selector on the front panel determines from which device a recording is being made.
10 PLACEMENT AND VENTILATION Your Plinius 8100 operates at a moderately high temperature, especially when being driven hard. The ideal location is upon a rigid stand, or floor mounted away from direct contact with any temperature sensitive materials or deep pile carpets.
11 It is important that you connect your loudspeakers (outputs) and source components (inputs) to the Plinius 8100 Integrated Amplifier correctly to ensure the amplifier is not damaged, and sounds its best with your system.
12 BI-WIRING Bi-wiring uses two pairs of loudspeaker cables for each channel loudspeaker. You will notice that the rear panel of your Plinius 8100 has two pairs of output terminals for this purpose. When using bi-wires, always connect positive (+) to positive (+) and the same for the negative (-) terminals.
13 REMOTE CONTROL Provided with your Plinius 8100 is a three function remote control. The two buttons at the top of the remote adjust the volume level, and the button below switches the amplifier in and out of mute. Two AAA batteries power the remote, and these are replaced by removing the two posi-drive screws holding the bottom plate in place.
14 MAINS/LINE FUSE A Mains/Line fuse is fitted within the IEC socket on the rear of the amplifier. A small drawer at the bottom of this socket may be removed (after the IEC plug is removed) by levering it out with a flat blade screwdriver. The fuse fitted should be rated at no greater than 5 amps slow blow.
15 Your Plinius 8100 Integrated Amplifier is designed for use with high fidelity loudspeakers. It should not be used to operate with any other type of appliance or equipment. Choice of loudspeakers is one of personal taste, providing the chosen loudspeakers are suitable for use with your amplifier.
16 100-WATTS RMS PER CHANNEL INTO 8 OHMS. 140-WATTS RMS PER CHANNEL INTO 4 OHMS. BOTH CHANNELS DRIVEN FROM 20Hz TO 20kHz AT LESS THAN 0.1% TOTAL HARMONIC DISTORTION. S D D D D YNAMIC YNAMIC YNAMIC YNAMIC H H H H EADROOM EADROOM EADROOM EADROOM : :: : 1dB or greater at 8 Ω with music.
17 Bi-wiring ...................................................................................................................... ................ Page 12 Date of Manufacture ..........................................................................
18 All operational, technical and descriptive material published here is subject to change at any time without notice. For further product information or queries, please contact us at the address below. PLINIUS PLINIUS PLINIUS PLINIUS products are designed and manufactured by: Audible Technologies Ltd.
デバイスPlinius Audio 8100の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Plinius Audio 8100をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはPlinius Audio 8100の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Plinius Audio 8100の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Plinius Audio 8100で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Plinius Audio 8100を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はPlinius Audio 8100の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Plinius Audio 8100に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちPlinius Audio 8100デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。