ProFormメーカー831.24745.1の使用説明書/サービス説明書
ページ先へ移動 of 28
Serial Number Decal Model No. 831.24745.1 Serial No. CAUTION Read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. TREADMILL EXERCISER User ’ s Manual • Assembly • Operation • Maintenance • Part List and Drawing Sears, Roebuck and Co.
W ARNING DECAL PLACEMENT T ABLE OF CONTENTS WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . .
3 1. Before beginning this or any exercise pro- gram, consult your physician. This is espe- cially important for persons over the age of 35 or persons with pre-existing health problems.
4 2 0. Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.
5 T hank you for selecting the revolutionary PROFORM ® X P 615 TRAINER treadmill. The XP 615 TRAINER treadmill offers an impressive array of features de- signed to make your workouts at home more enjoyable and e ffect ive.
ASSEMBL Y M ake sure that the power cord is unplugged. Assembly requires two persons. S et the treadmill in a cleared area and r emov e all pack ing m ater ials . Do n ot di spose of the packing materials until assembly is completed. N ote: The underside of the treadmill walking belt is coated with high-performance lubricant.
7 4. With the help of a second person, carefully tip the treadmill down so that the Base (80) is flat on the floor. Identify the Right Upright (72) and the Right Upright Spacer (74), which are marked with stickers. Insert the Upright Wire (78) through the Right Upright Spacer as shown.
8 5. Hold a Bolt Spacer (3) inside the lower end of t he Right Upright (72). Insert a 3/8" x 4" Bolt (6) with a 3/8" Star Washer (9) into the Right Upright and the Bolt Spacer. Repeat this step with a sec- ond Bolt Spacer (3), 3/8" x 4" Bolt (6), and 3/8" S tar Washer (9).
9 8. Insert the Book Rack (84) into the console as- s embly; it may be helpful to rock the Book Rack up and down as you insert it. Attach the Book Rack with five 3/4" Screws (10); start all five Screws and then tighten them. See step 6. Tighten the two 3/8" x 4" Bolts (6).
10 12. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic .
OPERA TION AND ADJUSTMENT T HE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high- performance lubricant. IMPORTANT: Never apply sil- i cone spray or other substances to the walking b elt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear.
12 FEATURES OF THE CONSOLE The treadmill console offers an impressive array of features designed to make your workouts more effec- tive and enjoyable. When the manual mode of the console is selected, you can change the speed and incline of the treadmill with the touch of a button.
13 HOW TO TURN ON THE POWER IMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- perature before turning on the power. If you do not d o this, the console displays or other electrical components may become damaged.
14 Time display —When the manual mode is se- l ected, this display will show the elapsed time. W hen a workout is se- lected, the display will show the time remaining in the workout rather than the elapsed time. Distance/Incline dis- play —This display shows the distance that you have walked or run.
15 HOW TO USE A PRESET WORKOUT 1. Insert the key into the console. See HOW TO TURN ON THE POWER on page 13. 2. Select a preset workout. To select a preset workout, press the Select Workout button repeatedly.
16 5. Monitor your progress with the matrix and the displays. See step 5 on pages 13 and 14. 6. Measure your heart rate if desired. See step 6 on page 14.
17 THE INFORMATION MODE T he console features an information mode that keeps track of the total distance that the walking belt has m oved and the total number of hours that the treadmill has been used. The information mode also allows you to switch the console from miles to kilometers.
HOW T O FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE B efore folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the pow er cord.
19 TROUBLESHOOTING Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call the toll-free telephone number l isted on the back cover of this manual.
20 Locate the Reed Switch (64) and the Magnet (42) on the left side of the Pulley (43). Turn the Pulley u ntil the Magnet is aligned with the Reed Switch.
21 PROBLEM: The walking belt is off-center or slips when walked on S OLUTION: a . I f the walking belt is off-center, f irst remove the key and UNPLUG THE POWER CORD .
22 EXERCISE GUIDELINES The following guidelines will help you to plan your ex- ercise program. For more detailed exercise informa- tion, obtain a reputable book or consult your physician.
P ART LIST—Model No. 831.24745.1 R 1207A Key No. Qty. Description Key No. Qty. Description 1 7 1/2" Screw 2 9 3/4" Tek Screw 3 4 Bolt Spacer 4 4 3/8" x 2" Bolt 5 4 5/16" x 1.
4 4 8 8 13 13 14 14 16 16 20 20 21 21 21 21 21 21 26 26 27 27 28 28 33 33 35 35 35 2 2 21 21 36 37 38 39 41 44 42 36 43 45 47 46 39 40 41 49 48 50 52 54 55 40 38 53 49 51 95 24 EXPLODED DRA WING A—Model No.
1 12 15 15 20 20 20 22 23 23 24 29 31 32 34 3 4 3 4 2 2 2 2 57 58 60 59 61 63 70 69 64 65 66 68 67 62 10 10 10 11 EXPLODED DRA WING B—Model No. 831.24745.
56 56 56 5 5 7 6 6 6 6 7 9 9 17 18 19 19 4 4 8 8 8 8 31 31 71 73 75 5 7 5 7 77 72 81 80 79 79 79 74 81 75 83 82 78 78 76 76 25 56 79 25 9 3 3 3 97 96 26 EXPLODED DRA WING C—Model No.
1 10 10 10 10 10 10 10 10 10 10 10 20 30 30 86 89 85 84 87 92 94 93 91 8 8 90 10 10 10 1 1 1 1 27 EXPLODED DRA WING D—Model No. 831.24745.1 R 1207A.
Part No. 253299 R1207A Printed in China © 2007 ICON IP, Inc. Y our Home For repair— in your home —of all m ajor brand a pplianc es, lawn an d garden equipm ent, or heat ing an d cooli ng s y stem.
デバイスProForm 831.24745.1の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
ProForm 831.24745.1をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはProForm 831.24745.1の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。ProForm 831.24745.1の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。ProForm 831.24745.1で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
ProForm 831.24745.1を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はProForm 831.24745.1の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、ProForm 831.24745.1に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちProForm 831.24745.1デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
