PYLE AudioメーカーPYLE Plus Series PLCD65WXMUの使用説明書/サービス説明書
ページ先へ移動 of 16
OWNER’S MANUAL Mobile Audio System • PLL Synthesizer Ster eo Radio • CD Player/MP3 Player/WMA Player • Automatic Memory Storing • Full Detachable Panel • Pr eset Equalization • Electr onic Shockpr oof (ESP) Function • USB Interface • Auxiliary Input Function • Remote Contr ol PLCD65WXMU www .
2 CONTENTS Installation ...........................................3 T ake out screw befor e installation.........3 DIN Front-Mount (Method A) ................3 Installing the unit .................................3 Removing the unit .................
3 INST ALLA TION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly .
grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel.
DIN REAR-MOUNT (Method B) If your vehicle is a Nissan, Toyota, follow these mounting instructions. Use the screw holes marked T (T oyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.
USING THE DET ACHABLE FRONT P ANEL REMOVING THE FRONT P ANEL 1. Pr ess the r elease button ( ) on the front panel and pull of f the fr ont panel. 2. Keep fr ont panel into the case. INST ALLING THE FRONT P ANEL T o install the front panel, insert the panel into the housing and make sure the panel is properly installed.
7 WIRING CONNECTION FRONT Lch SPEAKER GREEN GREEN/BLACK MEMORY BACK-UP (B+) MAIN UNIT Rch RED Lch WHITE AUX IN CABLE IGNITION SWITCH (ACC+) POWER ANTENNA RED GROUND (B – ) YELLOW BLACK BLUE RCA CABL.
8 OPERA TION LOCA TION OF KEYS 12 17 7 18 15 10 5 8 11 9 4 24 21 20 22 2 3 1 6 19 13 16 14 23.
9 OPERA TION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (7) and button (4)). When system is on, press POWER button (9) to turn off the unit. F ACEPLATE RELEASE Press button (7) to detach the removable faceplate.
10 OPERA TION CD OPERA TION • SWITCHING TO CD MODE If there is no CD inserted in the driver: Gently insert the CD with the printed side uppermost into the CD compartment until you feel some resistance. The CD is drawn into the driver automatically .
11 OPERA TION MP3 OPERA TION • SWITCHING TO CD (MP3) MODE If there is no MP3 disc inserted in the driver: Gently insert the MP3 disc with the printed side uppermost into the disc slot (5) until you feel some resistance. The MP3 disc is drawn into the driver automatically .
KEY Assigned IN Searching mode(T able 1) AUDIO KONB (ENCODER) & TUNE/TRACK UP/DOWN buttons: Searching file and dir ectory during Navigation. WMA OPERA TION The unit that can play the WMA disc and the operation is the same with MP3 operation described above.
OPERA TION in the device, the operation is the same with the MP3 operation described above. Note: • The main unit can only support the standard USB-memory disc which is approved by Micr osoft. • USB MP3 player is not a standard which means differ ent brand name or different models have their own standard.
14 REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, – , +, 0 For MP3/WMA Operation ) 3. SEL = Sound Mode Select Button (Character Shift Right For MP3/WMA Operation ) 4. VOL = V olume Up Button [Character Select (A, B ~ 8, 9, 0) For MP3/WMA Operation] 5.
15 SPECIFICATION GENERAL P ower Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 160 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ± 10 dB - T reble (at 10 KHz) : ± 10 dB Maximum Output P ow er : 4 x 50 W atts Current Drain : 15 Ampere (max.
88-C2007-02 TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is not on.
デバイスPYLE Audio PYLE Plus Series PLCD65WXMUの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
PYLE Audio PYLE Plus Series PLCD65WXMUをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはPYLE Audio PYLE Plus Series PLCD65WXMUの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。PYLE Audio PYLE Plus Series PLCD65WXMUの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。PYLE Audio PYLE Plus Series PLCD65WXMUで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
PYLE Audio PYLE Plus Series PLCD65WXMUを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はPYLE Audio PYLE Plus Series PLCD65WXMUの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、PYLE Audio PYLE Plus Series PLCD65WXMUに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちPYLE Audio PYLE Plus Series PLCD65WXMUデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。