Radio Shackメーカーand Speakerphoneの使用説明書/サービス説明書
ページ先へ移動 of 28
Owner’s Manual Please read before using this equ ipment. 900 MHz Digital Spread Spectrum Cordless Phone with Dual Caller ID, Dual Keypad, and Speakerphone.
2 Important Information ˆ Important Information This phone has bee n tested and found to comply with all applicable UL and FCC stan- dards. IMPORTANT CALLER ID INFORMATION To use the phone's Cal.
3 Important Information Important: • Cordless phones such as this one require AC power to operate. When the AC power is off, you cannot dial out or receive incoming calls usin g your phone. For this reason, the phone should not be your only tel ephone.
4 Important Information IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipmen t, ba- sic safety precautions should always be fol- lowed to reduce the risk of fire, electric shock and injury to persons, includ ing the following: 1. Read and understand all instructi ons.
5 Important Information • If liquid has been spill ed into the prod- uct. • If the product has been e xposed to rain or water . • If the product does not operate normally by following the operating instructions.
6 Contents ˆ Contents Features ........... .............. ................. ................. ................ ................. .............. ............ ..... ....... 8 Installation ....... .............. ................. ................. .....
7 Contents Caller ID Messages ................... ................. ................. ................ ................. ........... 23 Adding/Deleting the Area Code ................... ................. .................... ................ .........
8 Features ˆ Features Your RadioShack Digital 900 MHz Dual Key- pad Cordless Speakerphone op erates on the 900 MHz band, wh ich means less interfer- ence, clearer sound, and greater range tha n 46/49 MHz cordless telephones.
9 Installation ˆ Installation Note: The base's display is protected during shipment by a piece of film. Carefully peel off this film before using your phone for the first time. MOUNTING THE PHONE You can place the pho ne's base on a desk or table, mount it on a standard wall plate, or mount it directly on a wall.
10 Installation 5. Route the adapter ’s cord through the strain relief slot on the bottom of the bracket. 6. Plug the adapter into a standa rd AC out- let.
11 Installation CONNECTING, CHARGING, AND REPLACING THE BATTERY PACK The phone comes with a re chargeable nick- el-cadmium (Ni-Cd) battery pack in the hand- set. Before using your phone, you must connect the battery pack, then charge it for about 24 hours.
12 Installation If you have trouble replacing the battery pack, take the phone to your local Ra- dioShack store for assistance. Important: The EPA certified RBRC ® Battery Recycling Seal on the nicke.
13 Installation the handset also rings (unless you set the handset’s ringer to off). T UR NING AUTO T ALK ON/ OFF Your phone is preset so you must press TA L K when yo u lift the handset from the base to answer a call. With auto talk turned on, you can answer a call by just lifting the han d- set from the base.
14 Operation ˆ Operation Note: To use the speakerphone, you must use the base keypad; to use the handse t, you must use the handset keypad. MAKING A CALL Using the Handset To make a call, lift th e handset and press TA L K . JW b a JW b a JW b a JW b a and current volume setting appe ar on the handset's display.
15 Operation an error beep. Move closer to the base and try again. USING MUTE To talk to someone in the room while using the speakerphone with out the person on the other end of the phone line hearin g your con- versation, press MUTE/DELETE on the base.
16 Operation • The redial memory holds up to 32 digi ts, so you can redial any long-distance number as well as local numbers. • The redial memory also holds pause entries (see “Entering a Pause ” on Page 19). USING T ONE SERVICES ON A PULSE LINE Some special services, such as bank-by- phone, require tone signa ls.
17 Operation press SPEAKER . The call is released from hold and transferre d to the handset and the display changes to >WdZi[j >WdZi[j >WdZi[j >WdZi[j _d _d _d _d Ki[ Ki[ Ki[ Ki[ . To bring the base back into the conversation for a three-way conference, press SPEAKER again.
18 Operation Follow these steps to store a number an d name in the handset. 1. Lift the handset. 2. Hold down MEM until C[c ehoýIjeh[ C[cehoýIjeh[ C[cehoýIjeh[ C[cehoýIjeh[ and a list of memory location numbers (and names, if any) appear .
19 Operation Storing a Number in the Base Follow these steps to store numbers in the base: 1. Hold down MEMORY until Ijeh[ Ijeh[ Ijeh[ Ijeh[ DkcX[h DkcX[h DkcX[h DkcX[h appears on the base's display . 2. Enter the phone number and any tone or pause entries (see “Entering a Pause ”).
20 Operation Reviewing Memory Numbers Handset To review your memo ry numbers stored in the handset, press MEM . The list of memory location numbers ( &' &' &' &' .
21 Caller ID Operation ˆ Caller ID Operation If you subscribe to Caller ID service from your phone company, the phone company sends information about the call, as well as the time and da te, betwe en the first and sec- ond rings of every call you rece ive.
22 Caller ID Operation is disconnected . Je b Z Je bZ Jeb Z Je bZ 8kio 8kio 8kio 8kio appears on your phone. J Wa[ J Wa[ JWa[ J Wa[ C[iiW][ C[iiW][ C[iiW][ C[iiW][ — Send a waiting caller to your phone company’s voice mail ser- vice. Je Je Je Je Le_ Y [ Le_ Y [ Le_ Y [ Le_ Y [ CW_b CW_b CW_b CW_b appears on your phone.
23 Caller ID Operation REVIEWING CALLER ID RECORDS (Handset Only) To review the Caller ID reco rds in the hand- set's memory, lift the handset and press CID.
24 Caller ID Operation Note: If a Caller ID record do es not contain a phone number (if it was blocked by the caller, for example) you cannot dial from that record. STORING A CALLER ID RECORD TO MEMORY (Handset Only) Follow these steps to store the name an d number from a Caller ID record into a memo- ry location.
25 Troubleshooting ˆ T roubleshooting We do not expect you to have any problems with your phone, bu t if you do, these sugge stions might help. Problem Suggestion Low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone.
26 Troubleshooting If you still have proble ms, disconnect the phone. If other phones on the sa me line work proper- ly, the fault is in this phone or its installation. If you can not find the problem, take your pho ne to your local RadioShack store for assistance.
27 Notes ˆ Notes.
43-3516 UCZZ01744ZZ 07A01 Printed in China RadioShack Corporation Fort Worth, Texas 76102 Limited One-Y e ar Warranty This product is warranted by RadioShack against manufactu ring defects in material.
デバイスRadio Shack and Speakerphoneの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Radio Shack and Speakerphoneをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRadio Shack and Speakerphoneの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Radio Shack and Speakerphoneの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Radio Shack and Speakerphoneで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Radio Shack and Speakerphoneを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRadio Shack and Speakerphoneの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Radio Shack and Speakerphoneに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRadio Shack and Speakerphoneデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。