RaypakメーカーRFSDV34RFNAUの使用説明書/サービス説明書
ページ先へ移動 of 27
RAYPAK VERMONT RFSDV34 FREESTANDING GAS LOG FIRE Installation and Operating Instructions For Models RFSDV34RFNAU (Natural Gas) & RFSDV34RFPAU (Propane) Page 1 of 27.
CONTENTS Part 1: For Your Safety Part 2: Installation Instructions • Start Up Recommendations • Locating The Fireplace • Clearance to Combustibles • Fireplace Dimensions • Gas Specifications.
Part 7: Conversion • Gas Type Conversion Instruction Part 8: Wiring Diagram • Wiring Diagram Part 9: Warranty Page 3 of 27.
Part 1: For Your Safety For your safety do not operate this appliance before readi ng this instruction book. Warning: Improper installation, adjustm ent, alt eration, service or maintenance can cause injury or pr operty damage.
Part 2: Installation Instructions This gas fireplace must be installed by a qualified installer in accordance with AS5601 and all relevant local building codes.
IMPORTANT: PLEASE READ THE FOLLOWING CAREFULLY Remove any plastic from trim parts before turning the appliance on. It is normal for fireplaces fabricated of steel to give o ff some expansion and/or contraction noises during t he start up or cool down cycle.
DIMENSION RFSDV34 A 667mm B 800mm C 492mm D 762mm E 254mm F 394mm G 114mm H 667mm I 333mm J 495mm K 162mm Page 7 of 27.
Gas Specifications Model Gas Type Gas Control Min. MJ/h Input Max. MJ/h Input RFSDV34RFN Natural Radio Freq. 22 32 RFSDV34RFP Propane Radio Freq. 24 32 Gas Inlet and Burner Pressures Natural Gas ULPG Inlet Minimum 1.1 kPa 2.75 kPa Inlet Maximum 3.50 kPa 3.
Note: When making the gas connection to the appliance inlet fitting, hold the 10mm 3/8” BSP fitting with a s panner when tightening the gas inlet pipe compression nut. For Propane installations an approved gas regulator must be fitted in accordance with AS5601.
Part 3: General Flue Installation Underside of gas cowl must be at least 500mm above highest point of the roof. This appliance is approved for an installation with a maximum flue height of 12m and a minimum flue height of 3m. Suspend a plumbline from the ceiling to the centre of the flue spigot.
Part 4: Operating Instructions NOTE: Carbon deposits maybe present on the glass and logs. This is normal and must be cleaned when the heater is serviced or the glass door is cleaned.
glass and causes lint, dust and other air-borne particles to cling. Initial paint curing may also deposit a slight film on the glass. Clean the glass two or three ti mes with a non-ammonia based household cleaner and warm water. (We recomm end gas fireplace glass cleaner.
Flame and Temperature Adjustment The appliance is fitted with the Honeywe ll Radio Frequency control valve and all adjustments are performed with t he use of a remote controller. See instructions packaged with the Remote Controller or refer to page 16 in this manual for operating instructions.
• DO NOT use any phone in the building. • IMMEDIATELY call you gas supplier from a neighbour’s phone or a mobile phone outside the build ing. Follow the gas suppliers instructions. • IF YOU CANNOT CONTACT YOU GAS SUPPLIER CALL THE FIRE BRIGADE.
13. For the RN/RP models turn the remote control ON/OFF switch to the ON position or set the thermostat to the desired setting. 14. Turn on electrical supply. To Turn Off the Heater 1. Turn the remote control ON/OFF switch to OFF or set the thermostat to the lowest setting.
remote control within 30 seconds. The LED will blink indicating the remote control will now work with the receiver valve. If the switch continues in the REMOTE position, the remote control will now control the main valve, flame modul ation level and fan control.
Fig. 7 Transmitter diagram Delay Timer Mode The shut off delay timer maximum setting is 2 hours and minimum setting is zero minutes. To change the timer le vel, press the timer key, then the arrow key. Each key press changes the setting by 10 minutes.
To Change Batteries 1. Remove cover on backside of the remote control. Install 3 AAA as shown on the cover and then re-attach the cover. 2. Once OPERATION steps 1 to 3 are completed, the receiver/valve and remote control are ready.
If an error code 8 is observed while performing the testing, complete the following: 1. Confirm that the gas valve is not in the REMOTE mode. • If the valve is producing error code 8 while in the REMOTE mode, the valve is defective and should be replaced.
Troubleshooting the Gas Control System Comfort Valve System Control Seque nce of Operation with Remote Control Local Path On Path Auto Path Move switch from manual to remote. Press any key on remote control If the manual switch is set to remote, press the mode button to display ON.
Part 6 Replacement Parts List Insert replacement parts list and parts drawing here. Part 7 Conversion Instructions 1. Disconnect power to the unit and shut off the gas supply. 2. Remove the window frame a ssembly. (see the Window Frame Assembly section) 3.
Part 8 Wiring Diagram A N 240V A C Te r m i n a l B l o c k Tr a n s f o r m er 240V AC - 110V AC 2A (50V A) Fuse - 3 Amp 240V A C 50 Hz Main Heater Supply Speed C on trol High Limit Fan RFSDV34 GAS L.
Page 23 of 27.
Page 24 of 27.
Page 25 of 27.
Part 9 Warranty RAYPAK RFSDV34RFN & RFSDV34RFP FREESTANDING GAS LOG FIRE WARANTY - AUSTRALIA ONLY – Rheem Australia * w ill: a) Repair o r, if necessary replace any Ra ypak RFSDV34 Freestan ding.
RAYPAK MAJESTIC RFSDV34RFNAU AND RFSD34RFPAU WARRANTY - AUSTRALIA ONLY – WARRANTY CON DITIONS 1. This warranty is appli cable only to the RFSDV34RFN and the RFSDV34RFP gas log fires manufactured from August 2005 2.
デバイスRaypak RFSDV34RFNAUの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Raypak RFSDV34RFNAUをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRaypak RFSDV34RFNAUの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Raypak RFSDV34RFNAUの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Raypak RFSDV34RFNAUで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Raypak RFSDV34RFNAUを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRaypak RFSDV34RFNAUの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Raypak RFSDV34RFNAUに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRaypak RFSDV34RFNAUデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。