RegencyメーカーIG34-LPGの使用説明書/サービス説明書
ページ先へ移動 of 32
PLEASE KEEP THESE INSTR UCTIONS FOR FUTURE REFERENCE Models: IG34-NG IG34-LPG IG34-ULPG Owner s & Installation Man ual 04/28/09 LISTINGS AND CODE APPROV ALS These gas appliances have been tested i.
2 Regency IG34 Gas Inbuilt Fireplace REGENCY GAS INBUIL T FIREPLACE TO THE NEW OWNER Congratulations! Y ou are the owner of a state-of-the-art Gas Inbuilt Fireplace by FPI. The Regency Gas Fireplace Series of appliances has been designed to provide you with all the warmth and charm of a fi replace, at the fl ick of a switch.
3 Regency IG34 Gas Inbuilt Fireplace T ABLE OF CONTENTS DA T A BADGE Copy of Data Badge ..................................................... 4 INST ALLA TION Important Message ........................................................ 5 For Y our Safety .
4 Regency IG34 Gas Inbuilt Fireplace DA T A BADGE (Australia Only) This is a copy of the label that accompanies each Regency IG34 Gas Inbuilt fi replace. We have printed a copy of the contents here for your review . DA T A BADGE NOTE: Regency units are constantly being improved.
5 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION IMPORT ANT MESSAGE The Regency Gas Inbuilt must be installed in accordance with these instructions.
6 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Mantel Clearances Note: A non-combustible mantel may be installed at a lower height if the fram- ing is made of metal studs covered with a non-combustible board. CLEARANCES T O COMBUSTIBLES Minimum Clearances to Combustibles From Unit Sides A 10" / 255mm Ceiling B 47.
7 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION GAS PIPE PRESSURE TESTING The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig.
8 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION INST ALLA TION IN MASONR Y OR ZERO CLEARANCE CHIMNEY 1) Measure and record dimensions to determine total Flex Liner length requirements (see instructions below for details). 2) Carefully feed the liner down the chimney (masonry or zero clearance) and out through the damper .
9 Regency IG34 Gas Inbuilt Fireplace AERA TION SETTINGS The burner aeration is factory set but may need adjusting due to either the local gas supply , air supply or altitude. This adjustment is performed by the installer . (Close the aeration for a more yellow fl ame, or open it to make the fl ame bluer).
10 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Conversion Kit #486-968 for NG to LPG Model THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !! C onv ersion Kit 486-968 Contains: Q ty .
11 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Installer Notice: These instructions must be left with the appliance. After carr ying out all adjustments , bloc k the setting screws with paint, taking care not to obstruct the breather or ifi ce of the pressure.
12 Regency IG34 Gas Inbuilt Fireplace Conversion Kit #486-967 for NG to ULPG INST ALLA TION THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !! C onv ersion Kit 486-967 Contains: Qty .
13 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Installer Notice: These instructions must be left with the appliance. After carr ying out all adjustments , bloc k the setting screw s with paint, taking care not to obstruct the breather or ifi ce of the pressure.
14 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION OPTIONAL ST AINLESS STEEL INNER P ANEL INST ALL Before you start: Stainless panels must be inspected f or scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damage after installation will not receive consider ation.
15 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION LOG SET INST ALLA TION Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
16 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Logs D)02-46 and E)02-47 in position. 6) Place the Left T op Log D)02-46 on the pin on Log C)02-56 and on top of the cutout on Log A)02-43. 7) Place the notch in Center Log E)02-47 over Log B)02- 45 and across the cutout on Log A)02-43.
17 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION 10) Place the embers and Rockwool on the exposed front burner tray . 9) Place Front Left Log G)02-44 onto the 2 front pins as shown.
18 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION GLASS DOOR INST ALLA TION ST ANDARD FLUSH DOOR The standard fl ush door comes with a black frame. T o install the frame and glass door , simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1.
19 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION SCREEN INST ALLA TION Plinth Tri m Op tio n : Plinth Trim Kits are an option that can be used to fi nish off the installation when the bottom of the fi replace is higher than the hearth or to raise the fi replace.
20 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Note: Ensure that the fl anges on the sides of the fi rebox are on the outside, when installing the faceplate (see below). Faceplate Flange on fi rebox Door Frame Glass Door Metal Lip Openings on hinge 3) Fold down the 2 hinges on the bottom frame to a fl at position.
21 Regency IG34 Gas Inbuilt Fireplace INST ALLA TION Back of Faceplate Back of Faceplate Bracket Thermodisc 1) Install faceplate and door frame as per previous page. 2) After faceplate has been installed - place the touch pad (facing out) in the knockout located on the left side of the faceplate.
22 Regency IG34 Gas Inbuilt Fireplace FINAL CHECK Before leaving this unit with the customer , the installer must ensure that the appliance is fi ring correctly . This includes: 1) Clocking the appliance to ensure the correct fi ring rate (rate noted on label) at 15 minutes.
23 Regency IG34 Gas Inbuilt Fireplace OPERA TING INSTRUCTIONS OPERA TING INSTRUCTIONS Before operating this appliance, proceed through the following check list. 1) Read and understand these Instructions before operating this appliance. 2) Check to see that all wiring is correct and enclosed to prevent possible shock.
24 Regency IG34 Gas Inbuilt Fireplace COPY OF LIGHTING INSTRUCTION PLA TE OPERA TING INSTRUCTIONS NORMAL OPERA TING SOUNDS OF GAS APPLIANCES It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance.
25 Regency IG34 Gas Inbuilt Fireplace MAINTENANCE CAUTION: ANY SAFETY SCREEN OR GUARD REMOVED FOR SERV - ICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERA T - ING THE APPLIANCE. CLOTHING OR OTHER FLAM- MABLE MA TERIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE.
26 Regency IG34 Gas Inbuilt Fireplace MAINTENANCE F AN MAINTENANCE T o Remove Fan: 1) Turn the unit off and allow it to cool to room temperature, 2) Unplug or disconnect power source to stove. 3) Open the bottom louvre. 4) Remove screws that secure protective screen.
27 Regency IG34 Gas Inbuilt Fireplace MAINTENANCE 1) Unplug or disconnect the power source to the stove and shut off gas supply . 2) open bottom louvre and remove protective screen. 3) Remove the door frame and safety screen. 4) Remove the glass door, logs, and black or stainless inner liner , if installed.
28 Regency IG34 Gas Inbuilt Fireplace P ARTS LIST ELECTRONIC COMPONENTS P ARTS LIST 910-936 910-082 910-088 910-089 910-084 910-527 910-935 910-080 910-521, 910-522, 910-523, 910-525 910-912 910-906 9.
29 Regency IG34 Gas Inbuilt Fireplace MAIN ASSEMBL Y Part # Description Part # Description 1) 910-169/P Fan Motor (240 V)** 2) 910-995 Thermodisc** 3) 486-968 LPG Conversion Kit** 486-967 ULPG Convers.
30 Regency IG34 Gas Inbuilt Fireplace P ARTS LIST F ACEPLA TE ASSEMBL Y Part # Description 14) 336-914 Faceplate & T rim Complete - Regular 15) 366-942 Plinth Kit 16) 336-532 Flush Screen Door** *Not available as a replacement part.
31 Regency IG34 Gas Inbuilt Fireplace W ARRANTY Regency ® Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance T eam carefully inspects each unit thoroughly before it leaves our door .
FIREPLACE PRODUCTS AUSTRALIA PTY . L TD. 21-23 SOUTH LINK, DANDENONG SOUTH VICTORIA, 3175 AUSTRALIA Printed in Canada © Copyright 2009, FPI Fireplace Products International Ltd.
デバイスRegency IG34-LPGの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Regency IG34-LPGをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRegency IG34-LPGの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Regency IG34-LPGの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Regency IG34-LPGで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Regency IG34-LPGを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRegency IG34-LPGの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Regency IG34-LPGに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRegency IG34-LPGデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
