RobertsメーカーGemini 19 CRD-19の使用説明書/サービス説明書
ページ先へ移動 of 28
CRD-19 DAB digital clock radio with dual alarm Please read this manual before use ROBER TS Sound for Generations.
Controls ........................................................................... 2-3 Using the clock radio for the fi rst time .................................4 Operating your clock radio ..................................................5 Selecting a station .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 2 Controls (T op) 1. Station preset buttons 2. Speaker 3. Auto T une button 4. Advanced info button 5. Classic FM button 2 3 5 9 6. Tuning Up/Down/Snooze button 7.
3 1 1. Display dimmer control 12. V olume control 13. Headphone socket 14. Line out socket 15. Auxiliary in socket Controls (left hand side) Controls (rear) 16.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 4 Using the clock radio for the fi rst time Y our clock radio is supplied with a Mains Adaptor . 1. Place your clock radio on a fl at surface. 2. Insert the adaptor plug into the DC socket located on the rear of your clock radio.
5 Operating your clock radio 1. Press the Standby button to switch on your clock radio. The display will show "T uning" for a few seconds. 2. If the clock radio has been used before, the last used station will be selected. 3. The fi rst station in the list of stations found will be played.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 6 Selecting a station 1. The top line of the display shows the name of the station currently selected. 2. Press the Tuning up or down buttons to step through the list of available stations.
Display modes Y our radio has six display modes:- 1. Press the Advanced info button to cycle through the various modes. a. Multiplex Name Displays name of multiplex to which current station belongs. b. T ime and date Displays current time and date. c.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 8 Finding new stations As time passes new stations may become available. T o fi nd new stations proceed as follows:- 1. Press and release the Auto Tune button "Scan Services Quick scan" will show on the display .
Autoselect As an alternative to pressing the Menu/Select button to select a station your clock radio can be set so as to automatically select a station. 1. Press and hold down the Menu/Select button for 2 seconds until the display shows "Autoselect ON".
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) Manual tuning Manual tuning allows you to tune and add the various DAB Band III channels to your station list. UK DAB stations located in the range 1 1B to 12D.
11 Presetting stations There are 5 memory presets available. 1. Press the Standby button to switch on the clock radio. 2. T une to the required station as previously described. 3. Press the required Preset button , the display will show "Preset 1 Free" if there are no presets stored.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 12 Recalling a preset station 1. Press the Standby button to switch on the radio. 2. Momentarily press the required Preset button . Y our clock radio will tune to the station stored in the preset memory .
13 2 Setting the alarm time Y our clock radio has two separate alarms which can be set to wake you to either radio or beep type alarm. Each alarm can be set to sound once, everyday , weekday or weekend. The alarms can be set with the radio in the on or the off position.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 14 6. Press the Menu/Select button to enter the alarm hour . The hour digits will be selected. The display will show the current time in 24 hour format. Note: Alarm times are set using 24Hr format e.
15 T o view alarm time 1. Press the Alarm button to enter the alarm setup, settings for Alarm 1 will show on the display . 2. Press the Alarm button again to view the settings for Alarm 2.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 16 Sleep function Y our clock radio can be set to turn off after a preset time has elapsed. The sleep setting can be adjusted between 10 and 90 minutes in 10 minute increments.
17 System reset If your radio fails to operate correctly , or some digits on the display are missing or incomplete carry out the following procedure. Ensure your clock radio is switched to the On position. 1. Press and hold the Advanced info button the display will show "Sleep Set".
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 18 Software version The software display cannot be altered and is just for your reference. Ensure your clock radio is switched to the On position. 1. Press and hold the Advanced info button the display will show "Sleep Set".
19 Display backlight The display backlight can be set to automatically light for 12 seconds when any button is pressed or can be switched off permanently . 1. Press the Standby button to switch on your clock radio. 2. Press and hold the Advanced info button the display will show "Sleep Set".
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 20 6 6. Press the Tuning up or down buttons to select the desired backlight setting, Auto or Off. 7. Press and release the Menu/Select button twice to return to normal radio mode.
21 Line out socket A 3.5mm Line out socket located on the left hand side of your clock radio is provided for connecting the audio signal to an external amplifi er . Inserting a plug into the line output socket will mute the internal loudspeaker . Set the volume control to adjust the line out volume level.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 22 Line in socket (3.5mm Jack) 1. Connect a stereo or mono audio source (ie iPod, MP3 or CD player) to the Auxiliary line in socket .
23 Specifi cations Power Requirements AC Adaptor AC 230 volts, 50Hz only Frequency Coverage DAB 174.928 - 239.200MHz Circuit Features Loudspeaker 1 x 75mm Headphone socket 3.5mm dia Line out socket 3.5mm dia Auxiliary in socket 3.5mm dia Aerial System DAB Wire aerial The Company reserves the right to amend the specifi cation without notice.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 24 General Do not allow this clock radio to be exposed to water , steam or sand.
25 Notes.
Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty w orkmanship or component breakdown, subject to the procedure stated below . Should any component or part fail during this guarantee period it will be rep aired or replaced free of charge.
ROBERTS RADIO TECHNICAL SER VICES 97-99 Worton Road Isleworth Middlesex TW7 6EG T echnical Helpline :- 020 8758 0338 (Mon-Fri during offi ce hours) Website: http://www .
デバイスRoberts Gemini 19 CRD-19の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Roberts Gemini 19 CRD-19をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRoberts Gemini 19 CRD-19の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Roberts Gemini 19 CRD-19の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Roberts Gemini 19 CRD-19で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Roberts Gemini 19 CRD-19を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRoberts Gemini 19 CRD-19の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Roberts Gemini 19 CRD-19に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRoberts Gemini 19 CRD-19デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。