Roberts RadioメーカーCRD-51の使用説明書/サービス説明書
ページ先へ移動 of 32
CRD-51 FM RDS/DAB Digital Clock Radio Please read this manual before use ROBER TS Sound for Generations.
Controls ........................................................................... 2-3 Using your clock radio for the rst time ...............................4 Operating your clock radio - DAB ........................................5 Selecting a station - DAB.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 2 Controls (T op) 4 7. Snooze button 8. Preset button 9. Menu / Display button 10. Select button 1 1. T uning Up / Down buttons 1 1 3 5 6 7 8 9 10 1 2 1.
3 Controls (left side) 24. Headphone socket 27.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 4 Using your clock radio for the rst time 1. Placeyourclockradioonaatsurface. 2. Fully extend the wire aerial located on the rear of your clock radio.
5 Operating your clock radio - DAB 1. Press the On/off button to switch on your clock radio. The display will show "TUNING" for a few seconds. 2. If your clock radio has been used before, the last used station will be selected. 3. The rststation in the listof stations foundwill be played.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 6 Selecting a station – DAB 1. The display shows the name of the station currently selected. 2. Press the Tuning up or down buttons to step through the list of available stations.
Display modes - DAB Y our radio has seven display modes:- 1. Press the Display button to cycle through the various modes. a. Scrolling text Displays scrolling text messages such as artist/track name, phone in number , etc. b. Programme type Displays type of station being listened to e.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 8 Finding new stations - DAB autoscan As time passes new stations may becomeavailable. T ond newstations proceed as follows:- 1.
9 Manual tuning - DAB Manual tuning allows you to tune and add the various DAB Band III channels to your station list. UK DAB stations are located in the range 1 1B to 12D.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 10 Dynamic range control (DRC) DRC can make quieter sounds easier to hear when your radio is used in a noisy environment. There are three levels of compression: DRC 0 No compression applied.
1 1 Operating your radio – FM autotune 1. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the radio. 2. Press the On/Off button to switch on your radio.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 12 Operating your radio – FM manual tune 1. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the radio.
13 Display modes – FM Y our radio has four display modes for FM listening:- The Radio Data System (RDS) is a system in which inaudible digital information is transmitted in addition to the normal FM radio programme. RDS offers several useful features.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 14 Presetting stations There are 20 memory presets, 10 for DAB and 10 for FM. 1. Press the On/Off button to switch on the radio. 2. Press the FM/DAB button to select the desired waveband.
15 Recalling a preset station 1. Press the On/Off button to switch on the radio. 2. Press the FM/DAB button to select the desired waveband. 3. Press the Preset button . 4. Press the Tuning Up or down buttons to select the desired preset station. 5. Press the Select button .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 16 Setting alarm times Y our clock radio has two alarms which can be set to wake you to either radio or beep type alarm. Each alarm can be set to sound once, daily , weekdays and weekends.
17 Setting alarm times - cont. 7. Press the Select button to enter the alarm hour . The display will show the current time in 24 hour format. The hour digit will be selected. 8. Press the Tuning up or down buttons to set the correct hour . 9. Press Select button to enter the alarm minutes.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 18 Setting alarm times - cont. 15. Press the Tuning up or down buttons to select the correct year 16. Press the Select button to enter the alarm month option 17.
T o view alarm time 1. Press the Alarm button to enter the alarm setup. 2. Press the Select button , then press the Tuning up or down buttons to view alarms 1 or 2. 3. Press the Select button to cycle through the various settings for the chosen alarm.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 20 Snooze function When the radio or buzzer alarm sounds, pressing the Snooze button will silenced the alarm for the selected number of minutes. The Snooze setting can be adjusted between 5 and 20 minutes in 5 minute increments.
Sleep function Y our clock radio can be set to turn off after a preset time has elapsed. The sleep setting can be adjusted between 5 and 90 minutes in 5 minute increments. 1. T o set the desired sleep time, press the Sleep button to enter the sleep setup.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) 22 Setting the clock Normally your clock radio will set its clock automatically via the DAB signal. If no DAB signal is available and you need to set the time manually , please follow the procedure shown below .
23 Setting the clock cont. 10. Press the Select button to enter the set month option. 1 1. Press the Tuning up or down buttons to select the correct month. 12. Press the Select button to conrmtime settings and return to normal radio mode.
Dimmer 1. In order to adapt the intensity of the display to suit the ambient room lighting, press Dimmer button on the top of your clock radio to select the dimmer brightness from High-Mid-Low and Off.
25 Headphone socket A 3.5mm Headphone socket located on the left side of your clock radio is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker . Important: Excessive sound pressure from the earphones or headphones can cause hearing loss.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) Factory Reset If your radio fails to operate correctly , or some digits on the display are missing or incomplete, carry out the following procedure. 1. Press and hold down the Menu/Display button for 2 seconds, 2.
1 Software V ersion This is provided as a reference when servicing is required. 1. Press the On/Off button to turn on the radio. 2. Press and hold the Menu/Display button . 3. Press the Tuning up or down button . until the software version of the unit appears on the display .
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) General Do not allow your clock radio to be exposed to water , steam or sand.
The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK. The wire coloured BROWN must be connected to the terminal marked L or coloured RED. Mains supply The CRD51 will operate from a supply of AC 230 volts, 50Hz only . DO NOT cut off the mains plug from this equipment.
If you need any further advice, please call our T echnical Helpline on :- 020 8758 0338 (Mon-Fri) Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below .
ROBERTS RADIO TECHNICAL SER VICES 97-99 Worton Road Isleworth Middlesex TW7 6EG T echnical Helpline :- 020 8758 0338 (Mon-Fri during ofce hours) Website: http://www .
デバイスRoberts Radio CRD-51の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Roberts Radio CRD-51をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRoberts Radio CRD-51の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Roberts Radio CRD-51の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Roberts Radio CRD-51で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Roberts Radio CRD-51を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRoberts Radio CRD-51の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Roberts Radio CRD-51に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRoberts Radio CRD-51デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
