Roberts RadioメーカーR983の使用説明書/サービス説明書
ページ先へ移動 of 20
R983 3 Band Portable Radio Please read this manual before use ROBER TS Sound for Generations Ma x Ma x Mi n Mi n Dis pl ay Light Ba nd Manual/Aut o Seek Tu ni n g Bass Tre bl e R 983 FM / M W / L W PLL Dig i tal Radi o wit h Syn thes ized Tuni ng Ti me Set Lock 87.
Ma x Ma x Mi n Mi n Disp l a y Light Ba nd Manua l/Aut o Seek Tu nin g Ba ss Treble R 983 FM / M W /L W PLL Di gi tal Radi o wit h Sy nthes i zed Tuni ng Time Set Lock 87.0 -1 08MH z 52 2 - 1710 k Hz 1 44 - 281MH z Controls 1. Liquid crystal display 2.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) Pow er Al ar m M ode On / Off / RA DIO Controls (Top) 2 10 14 9. Telescopic aerial 10 . Power on/off button 11 . Preset buttons 13 12 11 9 12 . Alarm on indicator 13 .
3 T UNING VOL U M E 15 17 16 18 15 . Tuning control 16 . Lock Switch 17 . Volume control 18 . Headphone socket (Right side) Controls.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) 4 19 21 20 19 . Mains socket 20 . Reset button 21 . Battery compartment Controls (Rear) (Underside).
A. Battery level indicator B. Real time indicator C . Sleep indicator D . Snooze indicator 5 FM MW LW ALARM z z z m kHz MHz A BC DE F G H J K I E. Memory/Sleep time indicators F. Frequency units G. Key lock indicator H. Tuning indicator I. Frequency and clock segments J .
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) O N Battery operation 1. Remove the Battery cover on the rear of the unit by pushing the catches in the direction of the arrows. 2. Insert four LR20 (D size) batteries into the spaces in the compartment.
Setting the clock 1. The clock will start running when the batteries are installed or when the radio is connected to the mains supply. The display will show 0:00 together with the real time symbol . 2. Ensure that the radio switched off. 3. Press the Time set button , the hours digits will flash in the display.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) Operating the radio 1. Your radio is equipped with four tuning methods:- Scan tuning, Rotary tuning, Manual tuning, and Memory preset tuning. Scan tuning 1.
Manual tuning 1. Press the Power button to turn on the radio. 2. Select the required waveband by repeatedly pressing the Band button. For the FM waveband fully extend the Telescopic aerial and set it at an angle of 45 degrees.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) Po wer Rotary tuning 1. Press the Power button to turn on the radio. 2. Select the required waveband by repeatedly pressing the Band button. For the FM waveband fully extend the Telescopic aerial and set it at an angle of 45 degrees.
Storing stations in preset memories There are 5 memory presets for each waveband. 1. Press the Power button to turn on the radio. 2. Tune to the required station using one of the methods previously described.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) Po wer Recalling stations from preset memories 1. Press the Power button to turn on the radio. 2. Select the required waveband by repeatedly pressing the Band button.
Setting the radio alarm When the radio alarm is selected the radio will turn on and play the last station listened to. The radio alarm will sound for one hour unless turned off by pressing the Power button . Pressing the Power button whilst the alarm is sounding will cancel the alarm for 24 hours.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) Setting the HWS (Humane Wake System) alarm A bleep tone will sound when using the HWS alarm. The alarm bleep will increase in volume every 15 seconds for one minute followed by one minutes silence before repeating the cycle.
1. Whilst the alarm is sounding pressing any button (except the Power or Light button ) will activate the snooze function. The Radio or HWS alarms will be silenced for 5 minutes. 2. The Display will flash both the snooze symbol z z z and the alarm symbol .
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) FM MHz Lock Switch The Lock switch located on the right-hand side of your radio is used to prevent unintentional operation. 1. Set the Lock switch to the up 'locked' position, the symbol will appear in the display.
Reset button If the radio fails to operate correctly, or some digits on the display are missing or incomplete carry out the following procedure. 1. With the aid of a suitable implement (the end of a p.
If you need any further advice, please call our Technical Helpline on :- 0181 758 0338 (Mon-Fri) The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK. The wire coloured BROWN must be connected to the terminal marked L or coloured RED.
ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline:- 0181 758 0338 (Mon-Fri) Issue 1 Guarantee This instrument is guaranteed for twelve months.
デバイスRoberts Radio R983の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Roberts Radio R983をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRoberts Radio R983の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Roberts Radio R983の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Roberts Radio R983で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Roberts Radio R983を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRoberts Radio R983の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Roberts Radio R983に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRoberts Radio R983デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。