Rolandメーカーgp-7の使用説明書/サービス説明書
ページ先へ移動 of 14
Digital Piano Model: V-Piano Grand Date: Jun. 1, 2011 Version: 1.00 1 (GP-7) MIDI Implementation 1. Receive data * “†” marked parameters are recognized by only GM2 sound generator. ■ Channel Voice Messages ● Note off Status 2nd byte 3rd byte 8nH kkH vvH 9nH kkH 00H n = MIDI channel number: 0H - FH (ch.
2 MIDI Implementation ❍ Resonance (Controller number 71) † Status 2nd byte 3rd byte BnH 47H vvH n = MIDI channel number: 0H - FH (ch.1 - 16) vv= Resonance value (relative change): 00H - 7FH (-64 - 0 - +63) ❍ Release Time (Controller number 72) † Status 2nd byte 3rd byte BnH 48H vvH n = MIDI channel number: 0H - FH (ch.
3 MIDI Implementation ■ Channel Mode Messages ● All Sounds Off (Controller number 120) Status 2nd byte 3rd byte BnH 78H 00H n = MIDI channel number: 0H - FH (ch.1 - 16) * When this message is received, all notes currently sounding on the corresponding channel will be turned off.
4 MIDI Implementation ❍ GM System Off † Status Data byte Status F0H 7EH, 7F, 09H, 02H F7H Byte Explanation F0H Exclusive status 7EH ID number (Universal Non-realtime Message) 7FH Device ID (Broadc.
5 MIDI Implementation ❍ Channel Pressure † Status Data byte Status F0H 7FH, 7FH, 09H, 01H, 0nH, ppH, rrH F7H Byte Explanation F0H Exclusive status 7FH ID number (universal realtime message) 7FH De.
6 MIDI Implementation ❍ Data set 1 (DT1) This is the message that actually performs data transmission, and is used when you wish to transmit the data.
7 MIDI Implementation ● Active Sensing Status FEH * This message is transmitted at intervals of approximately 250 msec. ■ System Exclusive Messages Universal Non-realtime System Exclusive Message and Data Set 1 (DT1) are the only System Exclusive messages transmitted by the V-Piano Grand.
8 MIDI Implementation | | | A0 - C8 | |# 01 76 | 0000 0000 | | | | 0aaa aaaa | Tone EQ Zone 3 Key Upper (21 - 108) | | | | A0 - C8 | |# 01 78 | 0000 0000 | | | | 000a aaaa | Tone EQ Zone 3 Frequency (.
9 MIDI Implementation | 00 19 | 000a aaaa | System Center Pedal Assign 2 (0 - 17) | | | | OFF, SOFT, SOSTENUTO, | | | | MASTER VOLUME, EXPRESSION, | | | | AMBIENCE LEVEL, | | | | SOUND LIFT, STRING RE.
10 MIDI Implementation | | | DECAY TIME, TONE COLOR, | | | | DAMPING TIME, DAMPER NOISE LEVEL | | 01 22 | | <Reserved> | | 01 23 | | <Reserved> | | 01 24 | 000a aaaa | Setup FC2 Assign 2 (.
11 MIDI Implementation ■ Decimal and Hexadecimal Table (An “H” is appended to the end of numbers in hexadecimal notation.) In MIDI documentation, data values and addresses/sizes of Exclusive messages, etc. are expressed as hexadecimal values for each 7 bits.
12 MIDI Implementation ■ Example of an Exclusive Message and Calculating a Checksum Roland Exclusive messages (RQ1, DT1) are transmitted with a checksum at the end (before F7) to make sure that the message was correctly received. The value of the checksum is determined by the address and data (or size) of the transmitted Exclusive message.
13 Function... Basic Channel Mode Note Number : Velocity After Touch Pitch Bend Control Change Transmitted Recognized Remarks Default Changed Default Messages Altered True Voice Note On Note Off Key.
14 Correspondence Between Preset Tones and Program Changes To select any of the sounds listed below, transmit the relevant Program Change on the channel that's been set for V-Piano Rx Channel (default value: ch.
デバイスRoland gp-7の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Roland gp-7をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRoland gp-7の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Roland gp-7の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Roland gp-7で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Roland gp-7を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRoland gp-7の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Roland gp-7に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRoland gp-7デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。