Rose electronicメーカーCRK-2DFSPD1Dの使用説明書/サービス説明書
ページ先へ移動 of 20
CrystalView ™ DVI Fiber DIGITAL FIBER KVM EXTENDER 10707 Stancliff Road Phone: (281) 933-7673 Houston, Texas 77099 WWW.ROSE.COM INSTALLATION AND OPERATIONS MANUAL Single or Dual video / USB or PS/2 .
LIMITED WARRANTY Copyright Rose Electroni cs 2002. All righ ts reserved. No part of this manual may be reproduced, sto red in a retr ieval system, o r transcribed in any form or any means, electronic or mech anical, including photo copying and recording, wi thout the prior w ritten permission o f Rose Electronics.
FCC/IC STATEMENTS, EU D ECLARATION OF CONFORMITY FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO-FREQUENCY INTERFERE NCE STATEMENTS Models: CRK-2DFMP D1D CRK-2DFMP D2D CRK-2 DFMUD1 D CRK-2DFM UD2D CRK-2DFSPD1D CRK -2DFSUD1 D CRK-2DFSPD2D CRK -2DFSUD2D CRK-2DFMPD1 D/3.
TABLE OF CONTENTS Contents Disclaimer ......................................................................................................... 1 System intr oduction ....................................................................................
INTRODUCTION CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 1 Disclaimer While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for errors or o missions. Neither doe s the manufacturer assume any liability fo r damages resulting from the use of the information contained herein.
2 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Features Perfect image quality at resolutions up to 1920 x 1200 @ 60Hz u s ing fiber optic cable Extend a KVM station from a CPU up to 33,000 feet (10,00 0m) (6,500 feet, 2,000m for the 3.
MODELS CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 3 Models / Connectors (Single Video) PS/2 Transmitter (2-DVI-I / 1-MiniDin6 – “Y” cable needed) PS/2 Receiver (1-DVI-I / 2-MiniDi.
4 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Models (Dual Video) REAR F RONT PS/2 Transmitter (4-DVI-I / 1-MiniDin6) PS/2 Receiver (2-DVI-I / 2-MiniDin6) USB Transmitter (4-DVI-I / 1-US.
CABLES CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 5 Cables (See Attachment B for cable part numbers) Transmitter unit to CPU cable CPU cables connect from the transmi tter to a CPUs keyboard, video monitor and mouse ports. A “Y” PS/2 cable for the keyboard and mou se are needed.
INSTALLATION 6 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Installation Please refer to the safety section first before proceeding with any installation or configuration of the CrystalView DVI Fiber. When installing the CrystalView DVI Fibe r, locate the transmitter as close as possible to the CPU or switch.
CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 7 Connect the local USB model transmitter as shown below (single or dual video). A USB hub is used for local keyboard and mouse conne ctions to the computer. Transmitter to Receiver cabling Cable type Maximum distance 62,5µm Multimode-Fiber 650 ft / 200 m 50.
INSTALLATION 8 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Diagnostic LED Indicators Power (Red) Off – No power applied, device not ready On- Power applied, device ready Data E.
OPERATION INSTRUCTIONS CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 9 Operating instructions Operation of your computer is no different than having your keyboard, monitor, and mouse connected directly to the computer. All functions, applications, upgrades and other items can be done normally.
TROUBLESHOOTING 10 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Troubleshooting The troubleshooting section is used as a guide to un derstandi ng the capabilities of the CrystalView DVI Fiber and for general troublesho oting.
SERVICE AND SUPPORT CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 11 Service Information Maintenance and Repair This Unit does not contain any internal user-serviceab le parts.
SAFETY 12 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Safety The CrystalView DVI Fiber KVM extender has been te sted for conformance to safety regulations and requireme nts, and has been certified for international use. Like all electronic equipment, the CrystalView DVI Fiber should be used with care.
CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 13 Safety and EMC Regulatory Statements Safety information Documentation reference symbol. If the produ ct is marked with this symbol, refer to the product documentation to get more information about the prod uct.
APPENDICES 14 CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL Appendix A. General specifications Maximum resolution 1920 x 1200 @ 60Hz Video compatibility DVI-D Keyboard PS/2 or USB Mouse PS/2 or USB Power adapter 90-240 VAC adapter to 5VDC / app.
APPENDICES CRYSTALVIEW DVI FIBER INSTALLATION AND OP ERATIONS MANUAL 15 Appendix B. Parts and cables Part Number (Multimode) Description CRV-DLDFMPD1D DVI-D / PS/2 Single video (Transmitter) CRV-SRDFM.
10707 Stancliff Road Phone: (281) 933-7673 Houston, Texas 77099 WWW.ROSE.COM.
デバイスRose electronic CRK-2DFSPD1Dの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Rose electronic CRK-2DFSPD1Dをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRose electronic CRK-2DFSPD1Dの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Rose electronic CRK-2DFSPD1Dの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Rose electronic CRK-2DFSPD1Dで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Rose electronic CRK-2DFSPD1Dを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRose electronic CRK-2DFSPD1Dの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Rose electronic CRK-2DFSPD1Dに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRose electronic CRK-2DFSPD1Dデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。