Searsメーカー831.23953.0の使用説明書/サービス説明書
ページ先へ移動 of 28
Model No. 831.23953.0 Serial No. Write the serial number in the space above for reference. Serial Number Decal (under frame) • Assembly • Operation • Maintenance • Part List and Drawing Sears, Roebuck and Co.
TABLE OF CONTENTS WARNING DECAL PLACEMENT ............................................................... 2 IMPORTANT PRECAUTIONS .................................................................. 3 BEFORE YOU BEGIN ...................................
iMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious oiury, read all important precautions and instructions in this manual and all warnings on your elliptical before using your elliptical. Sears assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
BEFORE YOU BEGIN Thank you for selecting the revolutionary PROFORM ® 395 E elliptical. The 395 E elliptical provides an impres- sive selection of features designed to make your workouts at home more effective and enjoyable.
PART iDENTiFiCATiON CHART Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly.
ASSEMBLY Assembly requires two persons. Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you complete all assembly steps.
3. 3 Orient the Upright (2) and the Shield Cover (37) as shown. Slide the Shield Cover upward onto the Upright. Have a second person hold the Upright (2) and the Shield Cover (37) near the Frame (1). Locate the wire tie in the lower end of the Upright (2).
. Tip: Avoid pinching the Main Wire (42). Slide the Upright (2) onto the Frame (1). Have a second person hold the Shield Cover (37) out of the way. Attach the Upright (2) with five M10 x 20mm Screws (79) and five M10 Split Washers (78). Tip: Start all the Screws before fully tighten= ing them.
6. 6 The Console (4) can use four D batteries (not included); alkaline batteries are recommended. Do not use old and new batteries together or alkaline, standard, and rechargeable batter- ies together, iMPORTANT: if the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries.
9. Orient the Front Console Cover (32) as shown. Attach the Rear Console Cover (81) around the Upright (2) by pressing the hooks on the Rear Console Cover into the tabs on the Front Console Cover (32). Attach the Front Console Cover (32) to the Upright (2) with two M4 x 16mm Screws (92).
11. Using a small plastic bag to keep your fingers clean, apply a generous amount of the included grease to the axle on the right side of the Upright (2). Slide the Right Upper Body Arm (9) onto the Upright (2). Attach the Right Upper Body Arm (9) with an M8 x 20mm Screw (80) and an M8 Washer (33).
13. Identify a Pivot Cover A (19), which has hooks, and a Pivot Cover B (22), which has tabs. Attach a Pivot Cover A (19) and a Pivot Cover B (22) around the Right Upper Body Arm (9) by pressing the hooks on the Pivot Cover A onto the tabs on the Pivot Cover B.
15. Orient the Front Upright Cover (16) as shown. Attach the Front Upright Cover (16) around the Upright (2) by pressing the hooks on the Front Upright Cover onto the tabs on the Rear Upright Cover (3). 15 16 16. Insert the Accessory Tray (5) into the Rear Upright Cover (3).
18. Identify the Right Pedal (13), which is marked with a "Right" sticker, and orient it as shown. Attach the Right Pedal (13) to the Right Pedal Arm (49) with three M10 x 45mm Screws (75) and three M10 Split Washers (78). Make sure to use the center hole and the two outer holes to attach the Right Pedal.
HOW TO USE THE ELLiPTiCAL HOW TO MOVE THE ELLiPTiCAL Due to the size and weight of the elliptical, moving it requires two persons. Stand in front of the ellipti- cal, hold the upright, and place one foot against one of the front wheels.
CONSOLE DIAGRAM FEATURES OF THE CONSOLE The advanced console offers an array of features designed to make your workouts more effective and enjoyable. When you use the manual mode of the console, you can change the resistance of the pedals with the touch of a button.
HOW TO USE THE MANUAL MODE 1. Turn on the console. Press any button or begin pedaling to turn on the console. When you turn on the console, the display will light. A tone will sound and the console will be ready for use. 2. Select the manual mode. When you turn on the con- sole, the manual mode will be selected automatically.
5. Measure your heart rate if desired. HOW TO USE A PRESET WORKOUT if there are sheets of plastic on the metal Contacts contacts on the handgrip heart rate monitor, remove the plastic, in addition, make sure that your hands are clean. To measure your heart rate, hold the handgrip heart rate monitor with your palms resting against the contacts.
If the resistance level for the current segment is too high or too low, you can manually override the set- ting by pressing the Resistance buttons. However, when the current segment ends, the pedals will automatically adjust to the resistance level for the next segment.
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. iMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the shield cover and the left shield (see the instructions below).
EXERCISE GUiDELiNES These guidelines will help you to plan your exercise program. For detailed exercise information, obtain a reputable book or consult your physician.
SUGGESTED STRETCHES The correct form for several basic stretches is shown at the right. Move slowly as you stretch--never bounce. 1. Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible.
NOTES 24.
PART LIST Model No. 831.23953.0 RllllA Key No. Qty. Description Key No. Qty. Description 1 1 Frame 51 1 Flywheel 2 1 Upright 52 1 Idler 3 1 Rear Upright Cover 53 1 C-magnet 4 1 Console 54 1 Resistance.
t,O 85 30 33 10 29 12 29 4 95 92 31 31 23_-. % 20 79 92 92 16 _ 17 76 21_ 79 13 i 29 84 ,, / ' i 29 ; 78 i 75 11 22 33 80 49 23 m X "U F- 0 m m Z o cL (D Z o oo co i,o co r.
t,O ",4 ! 44 97 18 92 92 92 46 24 86 82 47 47 64 45 48 65 3 38 40 42 50 63 T 92 68 m X "U r'- 0 m m Z W o Z o u1 b.
Your Home For repair--in your home--of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories, and user's manuals that you need to do-it-yourself.
デバイスSears 831.23953.0の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Sears 831.23953.0をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSears 831.23953.0の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Sears 831.23953.0の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Sears 831.23953.0で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Sears 831.23953.0を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSears 831.23953.0の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Sears 831.23953.0に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSears 831.23953.0デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
