SmegメーカーCIR34XSの使用説明書/サービス説明書
ページ先へ移動 of 24
Contents 3 1 INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 4 2 POSITIONING OF THE HOB _____________________________________ 6 3 GAS CONNECT ION ___________________________________________.
Introduction 4 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WH OLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEF ORE USING THE COOKING HOB.
Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST NOT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING.
Instructions for the installer 6 2 POSITIONING OF THE HOB It is the law that all gas a ppli ances are installed by authorised persons . Clearance around the applia nce must comply with the requirements of AS5601. The following operation requires build i ng and/or carpentry work so must be carried out by a competent tradesman.
Instructions for the installer 7 Bracket ‘ A ’ in the 1st slot Bracket ‘ A ’ in the 2nd slot Bracket ‘ B ’ Short sides Long sides 2.2 Fixing 90 cm hobs on 60 cm base unit If a 90 cm hob is.
Instructions for the installer 8 60 cm 90 cm hob hob A 35 105 B 65 50 C 30 50 D 85 75 2.3 Clearance above and around domestic appliances Extract from AS560 1.
Instructions for the installer 9 REQUIREMENTS 1 Overhead clearances – (Measureme nt A ) Range hoods and exha ust fans shall be installed i n accordance with the manufacturer’s instructions.
Instructions for the installer 10 2.4 Room ventilation Caution – This hob may only be insta lled and operated in rooms permanently ventilated in accordance with current reg ulations. For proper operation of a gas ap pliance it is essential for the air nec essary for combustion of the gas to be able to flow natur ally into the room.
Instructions for the installer 11 3 GAS CONNECTION This appliance is suitable for installation with Nat ural Gas or ULPG (propane). Refer to page 12 for the relevant burner pressure an d appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator su pplied must be fitted to the gas inlet.
Instructions for the installer 12 4 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the pow er line conform to the data shown on the plate l ocated under the casing.
Instructions for the installer 13 5 ADAPTATI ON TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been adjusted for natural gas at a pressure of 1.0 kPa. For functioning with other types of gas the nozzl es must be replaced and the primary air adjusted.
Instructions for the installer 14 5.2 Removing the hob (models with built-i n control panel) 1. Remove the knobs, the gri ddles, the burner caps, the flam e caps and the two rear plugs; 2. Remove the screws “A” which fix the burner supports; 3. Raise the hob, sliding it off the ignition plugs and/ or the thermocouples and the gas tap rods; 5.
Instructions for the installer 15 5.4 Adjustment for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the unit to work back with this type of gas, after it has been adjusted for ULPG, perform the same operations described i n paragraph “5.
Instructions for the installer 16 6 FINAL OPERATIONS Having carried out the ab ove adjustments, reassemble the ap pliance following, backwards, the instructions in par agraph “ 5.1 Removing the control pane l / 5.2 Removing the hob”. 6.1 Adjustment of minimum for natural gas Light the burner and take it to the minimum .
Instructions for the installer 17 6.2 Arrangement of burners on the hob (hobs with separable control panel). 60 cm hobs BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid large 5. Wok 90 cm hobs BURNERS 1. Auxiliary 2. Semirapid 3. Rapid 4. Fish burner 5.
Instructions for the installer 18 6.3 Arrangement of bur ners on the hob (hobs with built- in control panel). 60 cm hobs BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid 5. Wok 6.4 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn.
Instructions for the user 19 7 USING THE HOB Before turning on the burners, make sure that the burn er rings, caps and grids have been fitted correctly. In the wok burner, notch A must be aligned with pin B . Grid C provided is intended for use with wok s (Chinese pans).
Instructions for the user 20 7.3 Diameter of containers Burners Ø min. and max . (en cm.) Auxiliary 12-14 Semirapid 16-20 Rapid 22-26 Rapid large 22-26 Wok 22-34 Fish burner Special oval-shaped vessels 7.4 Electric elements 7.4.1 Turning on electric elements Hobs may be fitted with an electric element of various diameter.
Instructions for the user 21 WARNING When switching on the electric element for the first time, or if the electric element has not been used for a long time, to remove any humidity from the insulating material it should be d ried out by placing the electric element on p osition 1 for 30 minutes.
Instructions for the user 22 8 CLEANING AND MAINTENANCE Before any intervention, disc onnect the power supply of the device. 8.1 Cleaning Clean the cooking top regularl y every time you use it, obviously after it has cooled.
Instructions for the user 23 8.2.2 The electric element After use, to make sure that the surf aces are clean and long lasting, the electric element must be treat ed with specific cleaning pr oducts which are available on the m arket. This necessary operati on prevents oxidisation (rust formation).
Instructions for the user 24 9 PROBLEMS AND CAUSES Each of the following cases is caus ed by a n abnormal operation of the appliance and shoul d be dealt with by a authorised persons: ple ase contact your local dea ler or Service Center in cas e you detect any of these malfunctioning.
.
914771851/ C.
デバイスSmeg CIR34XSの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Smeg CIR34XSをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSmeg CIR34XSの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Smeg CIR34XSの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Smeg CIR34XSで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Smeg CIR34XSを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSmeg CIR34XSの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Smeg CIR34XSに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSmeg CIR34XSデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。