Soleus AirメーカーSG-WAC-12HCEの使用説明書/サービス説明書
ページ先へ移動 of 20
Model SG-W AC-12HCE Electronic Heat & Cool Window A/C Operating Instructions.
Thank you for choosing a Soleus Air powered by Gree Air Cond itioner. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new air conditioner.
Recommended Ground Method For your personal safety, this air conditioner must be grou nded. This air conditioner is equipped with a 3 prong powe r supply cord with a grounded plug. To mini mize the possibility of electrical shock, the cord must be plugged into a 3 prong outlet and grounded in accordance with all local codes and ordi nances.
P ARTS LIST T OOLS NEEDED • Large Flathead Screwdriver • Tape Measurer • Adjustable Wrench or Pliers • Pencil • Level • Socket Wrenches • Phillips Head Screwdriver Non-Hardware Packing L.
SPEC IFICA TIONS • Noise level is measured at a distance of 3.28 ft away from the front of the unit in cooling mode. • Power consum ption is measur ed when the fan runs at the highe st speed setting. • These specifications are for reference onl y.
INST ALLA TION & ASSEMBL Y INSTRUCTIONS Window Preparation Please read all instructions prio r to installing your air c onditioner. Two people are recommen ded to install this product. If a new electrical outlet is require d, have the outlet insta lled by a qualified electrician before installing the unit.
INST ALLA TION & ASSEMBL Y INST RUCTIONS - WINDOW MOUNTING REMOVE CHASSIS 1. Pull down the front panel and remove the filter (FIG. 1 below) 2. Lift the front panel upwards to remove and place to the side. 3. Locate the four faceplate screws and remove.
INST ALLA TION & ASSEMBL Y INST RUCTIONS - WINDOW MOUNTING REMOVE CHASSIS 6. Remove the shipping screws from the top of the unit and the sides of the cabinet if installed (FIG 6 & 7). 7. Hold the cabinet while pulling on the base handl e to carefu lly remove the unit.
ASSEMBL Y & INST ALLA TION (CONT .) 9 7. Attach foam adhesive seal along the bottom of the cur- tain bottom channel. FIG 9 Placing the Cabinet Inside the Window 1. Open the window and plac e the cabinet in the middle of the window sill. 2. Make sure the bottom rail is se ated over the window sill as shown below.
ASSEMBL Y & INST ALLA TION (CONT .) 10 Extend the Accordion Panels 1. Carefully raise the window to expose the accordion panel and panel frame. Loosen the locki ng screws so the accordion panels slide easily. Pre-drill 3/32” hole s if needed. 2.
ASSEMBL Y & INST ALLA TION (CONT .) 11 Installing the Chassis into the Cabinet 1. Team lift (two people) the air conditione r chassis and carefully slide it into the cabinet. Let the front of the air conditioner hang out approximately 6”. 2. CAUTION: DO NOT PUS H ON THE CONTROLS OR FINNED COILS.
ASSEMBL Y & INST ALLA TION - THRU-THE-W ALL (CONT .) 12 Carefully measure and cut an openi ng with the following dimensions depending on your mod el (FIG. 1 & 2). WIDTH “X” = inside model plus twice the thickness of the framing material used.
ASSEMBL Y & INST ALLA TION - THRU-THE-W ALL (CONT .) 13 Refer to the SUPPORT BRACKET ASSEMBLY in the WINDOW MOUNTING section to assemble the sup port brackets. A wooden strip nailed to the outside wall sh ould be used in conjunction with the angled si ll support brack- ets.
14 USING YOUR AIR CONDITIONER Electronic Control Panel & Remote Control 1. Power Button: Turns the air conditioner on and off 2. Digital Display: Displays the current room tem- perature or the amount of time left on the timer. Shows the Set Temp when setting the tempera- ture.
15 USING YOUR AIR CONDITIONER (Cont.) • Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions.
16 USING YOUR AIR CONDITIONER (Cont.) • Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions.
17 CARE AND CLEANING Clean your air conditioner to keep it looking new and to minimize dust build up. Air Filter Cleaning The air filter should be checked at least once every month to see if it needs cleaning. Trapped particles and dust can bui ld up in the filter and may decrease airflow as well as cause the cooling coils to accumulate frost.
PROBLEM The Air Conditioner will not start POSSIBLE CAUSES The air conditioner is unplu gged The fuse is blown/circuit breaker is tripped. Power Failure The current interrupter device is tripped.
PROBLEM Water is dripping outside POSSIBLE CAUSES Hot and Humid weather. SOLUTIONS • This is normal TROUBLESHOOTING (CONT .) Water is dripping inside the room The air conditioner is not correctly tilted outside. • For proper water drainage, make sure the air conditioner is slightly tilted downward from the front of the unit to the rear.
W ARRANTY One Year Limited Warranty Soleus International, Inc. warrants the accompanying Soleus Air Powered by Gree Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE ( 1) year from the date of original retail purchase in the United States.
デバイスSoleus Air SG-WAC-12HCEの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Soleus Air SG-WAC-12HCEをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSoleus Air SG-WAC-12HCEの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Soleus Air SG-WAC-12HCEの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Soleus Air SG-WAC-12HCEで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Soleus Air SG-WAC-12HCEを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSoleus Air SG-WAC-12HCEの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Soleus Air SG-WAC-12HCEに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSoleus Air SG-WAC-12HCEデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
