SonyメーカーCDU924Sの使用説明書/サービス説明書
ページ先へ移動 of 16
CDU924S CD-R Drive Unit User ’s Guide Mode d’emploi Bedienungsanleitung © 1996 by Sony Corporation Rev . 1.0 BKC: 42264600 CDU924S CD-R Drive Unit User ’s Guide.
This unit uses CD-R discs with the following mark. This unit uses CD-ROM discs with the following mark. When you use this unit as a CD player , use compact discs with the following mark. Y ou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Contents Introduction 6 Example of System Setup 7 Location and Function of Parts and Controls 8 Front Panel .............................................................................................................8 Rear Panel .....................
Example of System Setup T o use the CDU924S, at least the following components are necessary . ● Computer (IBM-PC*, HP V ectra**, or compatible equipment) ● CDU924S CD-R Drive Unit ● SCSI host adapter ● Floppy disk drive ● SCSI interface cable (Single ended, 50 pin flat.
Rear Panel 1 Jumper block for SCSI bus Specify assignment of the SCSI bus. 2 T erminators The terminator resistors are inserted into the sockets. Remove the resistors when the SCSI bus is to be terminated externally . Note: Some models are shipped without terminators.
Installing the Drive Unit into the Computer As you go through this section, you may wish to refer to your computer ’ s manual for a more detailed description of how to install internal drives.
Opening the Computer 1 If your computer has its rear side covered by a plastic panel attached with plastic hook pad, pull it of f. 2 Remove the cover mounting screws. 3 Remove the cover of the computer . Installing the Drive Unit into the Computer 13 Remove the jumper to set to OFF , and install the jumper to set to ON.
Connecting the Drive ■ Power-in connector Insert the plug and push it firmly in place. The power supply connector recommended has Molex 8980-3 contacts and a Molex 8981-04P housing. Pin assignment Installing the Drive Unit into the Computer 15 Mounting the Drive 1 Remove the screws and brackets from both sides of the drive spaces.
■ Interface connector 1 Insert one end of the interface cable into the interface connector firmly . 2 Attach the other end of the cable to the host adapter . Installing the Drive Unit into the Computer 17 ■ Frame ground When normally installed, the drive unit is not in contact with the host computer directly and should be grounded.
Reassembling the Computer 1 T uck the cables behind the drives so that they do not come up above the power supply . Check the following before closing the computer: ● Are the connections between the.
Using Discs and Caddies Loading a Caddy with a Disc 1 T o open the caddy lid, press the tabs on the both sides of the caddy at the end opposite to the shutter . 2 Set a disc, with its label upward, in the caddy . Be careful not to touch the recording surface when setting a CD-R disc in the caddy .
Storing Discs and Caddies ● Remove the caddy from the drive unit before moving the drive. ● Do not store the disc and caddy in a location subject to: – high humidity – high temperature – excessive dust – direct sunlight Care of Discs ● Hold the disc by its edge.
In such a case, eject the caddy and re-insert it properly . If the busy indicator remains lit amber , consult your dealer or qualified service personnel. The busy indicator also lights amber during audio play . However , this is not a malfunction. Ejecting a Caddy 1 T urn on the power supply .
Specifications ■ General Host interface SCSI-2, single ended, 50 pin Read Function Acceptable discs: CD-ROM Mode-1 data discs CD-ROM Mode-2 data discs CD-ROM XA discs CD-Audio discs Audio-combined C.
Shock Operating Read: 49 m/s 2 (5 G) at 1 1 ms half sine wave (includes 5 retries) W rite: 4.9 m/s 2 (0.5 G) at 11 ms half sine wave Non-operating 490 m/s 2 (50 G) at 1 1 ms half sine wave T ransportation 76 cm drop (with standard individual package) ■ Dimensions and weight Dimensions 146.
■ Dimension diagram Important Screws must not extend more than 4.0 mm into the side panels or the bottom plate. Specifications 31 ■ Supplied accessory User ’ s Guide (1 each) Disc Caddy OP A-2000 (1 each) ■ Optional accessories CD ROM discs: YHDS-50 “CD-ROM T est Disc T ype 1.
デバイスSony CDU924Sの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Sony CDU924Sをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSony CDU924Sの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Sony CDU924Sの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Sony CDU924Sで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Sony CDU924Sを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSony CDU924Sの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Sony CDU924Sに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSony CDU924Sデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。