SoundCraftメーカーSpirit Folio Rac Pacの使用説明書/サービス説明書
ページ先へ移動 of 23
1 4 4 1 1 2 GRPS 3 4 MIX.
Introduction Thank you for buying a SPIRIT FOLIO RAC PAC mi xer, brought to you with pride by the SPIRIT team of Peter, Graham, Martin, Ian, Stuart, Pe ter, George, Colin, James, Chris, Mukesh, Andy, Cand y and Simon.
ConnectORS Left Signal Right Signal Ground Headphones Signal (+ve) Ground Sense (-ve) Screen Signal (+ve) Gnd/Screen Gnd/Screen Signal Send Signal Return Gnd/Screen Tip Ring Sleeve Inserts Mix Outputs.
ConNections - Input Channels R SPIRIT FOLIO RAC PAC 3.
CONNECTIONS - MASTER SECTION R 4 SPIRIT FOLIO RAC PAC.
INITIAL SETTING UP You will probab ly use your SPIRIT FOLIO RAC PAC with a wide range of diffe rent types of sound source, and these will be at varying signal levels . It is important to set the GAIN of the inputs corre ctly to give the best performa nce.
SETTING UP FOR RECORDING While the connections to the FOLIO RAC PAC for PA work are quite straig htforward, recor ding is rather more demanding bec ause the mixer is not only required to mix down input signals but also to pr ovide a monitor mix for artists to hear previously rec orded tracks when overdubbing new parts.
THE CONTROLS IN DETAIL MONO INPUT CHANNELS 1-10 1 TRIM The TRIM control sets how much of the source signal is sent to the rest o f the mixer. Too high, and the signal will distort as it overload s the channel and causes clippi ng.
3 EQUALISER The Equaliser (EQ) allows precis e manipulation of the sound, particularly to improve the sound of microphone sources where the original signa l is often far from ideal due to poor acoust .
Aux 3 and 4 are always PO ST-FADE, ideal for Effects where it is us eful for the Aux Send to fade up and down with the fader. For flexibility, the Master Section AUX2 PRE switch allows you to switch AU X 2 from post- to pre-fade across the whole mixer as re quired.
5-6 13 14 1 2 3 4 5 6 7 STEREO INPUT CHANNELs 11-14 These inputs accept 3-pole A gaug e (TRS) jacks. Use these inputs for sources such as keyboards, drum ma chines, synths, tape machines or as returns from processi ng units.
5-6 13 14 1 2 3 4 5 6 7 4B A L A N C E This control sets the amount of the channel signal feeding the pairs of Groups, allowing you to balance the source in the stereo ima ge. When the control is turned fully right or left you feed only that side of the signal to the Groups selected by the Routing switc h (see be low).
1 4 4 1 1 2 3 4 5 STEREO RETURNS There are four Ster eo Returns, which have simila r controls but diffe rent routing configurat ions to provide the max imum flexibilit y. Each Return has an unbalanced stereo input on 3-pole A gauge (TRS) ja cks.
1 4 4 1 1 2 GRPS 3 4 MIX 11 10 7 4 6 3 2 1 12 5 9 8 SPIRIT FOLIO RAC PAC 13.
MASTER SECTION 1 GROUP FADERS Four Group FADERS set the overall level of the Groups, allowing the combined control of a selected numb er of input sources. The Groups may feed exter nal equipment directly through the ground compensated Group output jacks, or may be mixe d together to the stereo Mix output (see below).
1 4 4 1 1 2 GRPS 3 4 MIX 11 10 7 4 6 3 2 1 12 5 9 8 SPIRIT FOLIO RAC PAC 15.
AUXILIARY MAS TERS The Master section houses the summing amplifier s for each of the Auxiliar y Send , and feeds the signal via ground compensated output amp l ifiers to the Auxiliary O utput jacks.
R Applications Multitrack Recording This example illustrates how Rac Pac may be set up for multitra ck recording to eight tracks. Individ ual instrument or vocal tracks are recorded on Di gital Multitracks by connecting the channel Direct Outputs to the tape inputs.
Stereo Public Address In this basic PA set-up, va rious sources a re connected to the inputs, microphones to Mic inputs and keyboa rds etc. to Line inputs. Note that some guitars will not produce sufficient level for a direct connection, and will re quire a Direct Injection (DI) box connected via the microphone input.
Relocating the connector panel The connector panel is fitted as standard to the rear of the frame, allowing the mixer to be used as a fre e-standing, desktop unit.
Technical Specification Output Noise Typical Group Output, Input faders down -87dBu Group fader down -92dBu Mix output with groups routed to mix -83dBu Mix fader down -98dBu Aux Noise Typical, inpu t sends down -85dBu E.I.N. 150R source -129dBu Distortion Mic gain 30dB, to group output @ 14dBu < 0.
GloSSARY AFL (After Fade Listen) a function that allows the operator to monitor the post-fade signal in a channel independently of the main mix. Balance the relative levels of the lef t and right channels of a stereo sign al.
3 1 2 MONO INPUT CHANNELS (1-10) STEREO INPUT CHANNELS (1 1-14) TYPICAL STEREO RETURN (A-D) ▲ ▲ ➚ ➚ ➚ ➚ ➚ ➚ ➚ ➚ MASTER SECTION System Block Diagram 22 SPIRIT FOLIO RAC PAC.
デバイスSoundCraft Spirit Folio Rac Pacの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
SoundCraft Spirit Folio Rac Pacをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSoundCraft Spirit Folio Rac Pacの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。SoundCraft Spirit Folio Rac Pacの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。SoundCraft Spirit Folio Rac Pacで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
SoundCraft Spirit Folio Rac Pacを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSoundCraft Spirit Folio Rac Pacの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、SoundCraft Spirit Folio Rac Pacに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSoundCraft Spirit Folio Rac Pacデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
