SuperiorメーカーVFST-CMP-2の使用説明書/サービス説明書
ページ先へ移動 of 24
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 1 Unvented Decorative Gas Fireplaces P/N 903571 REV. F 03/2005 VFST -CMN-2 VFPF-CMN-2 VFST -CMP-2 VFPF-CMP-2 MODELS ST ANDARD SERIES INST ALLA TION INSTRUCTIONS FOR USE ONLY WITH DECORATIVE TYPE UNVENTED ROOM HEATERS.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 2 Building Supplies Should Include: Framing materials Wall finishing materials Caulking materials (noncombustible) Fireplace surround materials Check the inventory list to be sure that you have all the necessary parts in usable condition.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 3 Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 4 3. Add the BTU/Hr of all the fuel burning appli- ances in the space. Vent-Free heater _______ BTU/Hr Gas appliance #1* _______ BTU/Hr Gas appliance #2.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 5 Minimum clearance to combustibles are: Appliance: each side - ¹⁄₂ ” floor - 0" adjacent wall - 0" ceiling - 37 ¹⁄₂ ” (953 mm) The appliance is shipped with all gas controls and components installed and pre-wired.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 6 VFST FRAMING SPECIFICATIONS VFST APPLIANCE SPECIFICATIONS C A B Gas Line 2 x 4 Wall Framing T op View * ¹⁄₂ " (13mm) Required Air Space Clea.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 7 Figure 6 Figure 7 Figure 8 C A B Gas Line VFPF FRAMING SPECIFICATIONS VFPF APPLIANCE SPECIFICATIONS Gas Line Energy Wall 2 x 4 Outside Wall Drywall Dr.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 8 All appliances have a 3" long ³⁄₈ " NPT nipple installed at the valve. To quickly and easily complete the gas line routing, use the gas flex line kit, Model GFLV.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 9 Finished Wall Details It is sometimes best to frame the appliance after it has been positioned in place. Frame with 2 x 4s or heavier lumber. Always frame in accordance with local building codes. Note: The header may rest on the top spacers but must not be notched to fit around them.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 10 Assembling the Logs WARNING: DO NOT ADD EXTRA LOGS OR ORNAMENTS SUCH AS PINE CONES, VER- MICULITE OR ROCK WOOL. USING THESE ADDED ITEMS CAN CAUSE SOOTING. WARNING: DO NOT PLACE ANY LAVA ROCK ON LOGS OR BURNERS.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 11 Figure 19 OPTIONAL EQUIPMENT An incomparable package of options are avail- able for use with these appliances. These op- tions can both customize the operation of these unique appliances and enhance their beauty and charming appeal.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 12 Optional on Unit Rocker Switch An optional rocker switch kit can be installed directly on all VFST series appliances to provide for On and Off operation in lieu of a wall switch.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 13 ACCESSORIES AND COMPONENTS Forced Air Kit FAB-1100 Remote Control Kit RCL Rocker Switch Kit RS Wall Switch Kit WSK CLEANING AND SERVICING WARNING: TURN OFF THE UNVENTED GAS ROOM HEATER AND ALLOW TO COOL BEFORE CLEANING.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 14 Gas Flex Line Kit GFLV Brass Louvers –Main Panel VF6-BRLK –End Panel VF6-BRLEK Note: Model DAT-6-4 may not be used in conjunction with Model SPK-6. Note: Model DAT-6-1 may not be used in conjunction with Model SPK-6.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 15 1. When igniter button is pressed, there is no spark at ODS/pilot. 2. Heater produces unwanted odors. 3. Heater shuts off in use (ODS operates). 4. Gas odor even when control knob is in “OFF” position.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 16 OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE LIGHTING LIGHTING INSTRUCTIONS 1. Stop! Read the safety information above. 2. Make sure manual shut-off valve is fully open. 3. Locate gas control knob and piezo.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 17 Note: Knob cannot be turned from “PILOT” to “OFF” unless the knob is pushed in slightly. Do not force.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 18 VFST REPLACEMENT PARTS LIST VFST-CMN VFST-CMP No. Description Part No. Qty. Part No. Qty. 1. Valve - Millivolt 903489 1 901917 1 2. Injector, Burner 110389 2 110384 2 3. Pilot 110344 1 901915 1 4. Regulator, Pilot 903218 1 112081 1 5.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 19 REPLACEMENT PARTS – VFST 7 8 6 2 14 1 4 9 10 12 15 13 12 3 16 5 11.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 20 VFPF REPLACEMENT PARTS LIST VFPF-CMN VFPF-CMP No. Description Part No. Qty. Part No. Qty. 1. Valve - Millivolt 903489 1 901917 1 2. Injector, Burner 110389 2 110384 2 3. Pilot 110344 1 901915 1 4. Regulator, Pilot 903218 1 112081 1 5.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 21 REPLACEMENT PARTS – VFPF 15 12 16 20 19 19 9 18 13 12 1 14 3 6 2 1 10 9 17 4 7 8 5 11.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 22.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 23.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 24 Printed in U.S.A. © 1998 by SFC P/N 903571 REV. F 03/2005 Unvented Gas Room Heater Limited Warranty 1 Y ear THE WARRANTY SFC warrants this Unvented Gas Room Heater to be free from defects in materials and workmanship at the time of manufacture.
デバイスSuperior VFST-CMP-2の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Superior VFST-CMP-2をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSuperior VFST-CMP-2の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Superior VFST-CMP-2の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Superior VFST-CMP-2で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Superior VFST-CMP-2を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSuperior VFST-CMP-2の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Superior VFST-CMP-2に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSuperior VFST-CMP-2デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
