TeacメーカーCD-RW900CDの使用説明書/サービス説明書
ページ先へ移動 of 32
CD-RW900 CD Rewritable Recor der D00892620A » OWNER'S MANUAL Professional.
1-Intr oduction 2 T ASCAM CD-RW900 Important Safety Pr ecautions The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
1-Intr oduction T ASCAM CD-RW900 3 Important Safety Instructions 1 Read these instructions. 2 Keep these instructions. 3 Heed all warnings. 4 Follow all instructions. 5 Do not use this apparatus near water . 6 Clean only with dry cloth. 7 Do not block any ventilation openings.
1-Intr oduction 4 T ASCAM CD-RW900 Safety Information This product has been designed and manufactur ed according to FDA r egulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product.
1-Intr oduction T ASCAM CD-RW900 5 Contents 1 − Introduction About this manual .................................................. 6 Supplied accessories ............................................. 6 Rack-mounting the unit .........................
6 T ASCAM CD-RW900 Rack-mounting the unit If you are mounting the unit in a rack, leave 1U of space above it and 4 inch (10cm) or more of space at the r ear . Use the rack-mounting kit to mount the unit in a stan- dard 19-inch equipment rack, as shown in this section.
T ASCAM CD-RW900 7 1 − Intr oduction In this maanual, we use the term “recor dable” disc to describe a CD-R or CD-RW disc that has not been nalized, i.e. further recor ding is possible on the disc. “Recordable” discs Although audio data may be written on a CD-R or CD- RW disc, a standard CD player will not be able to r ead the data (i.
1-Intr oduction 8 T ASCAM CD-RW900 1 − Intr oduction The CD-RW900 has been designed for the playback of CD-DA format discs and MP3 files recor ded in ISO9660 format: In addition to ordinary 5-inch and 3-inch CDs, it can also play properly r ecorded CD-R and CD-RW discs.
1-Intr oduction T ASCAM CD-RW900 9 Inserting batteries 1. Open the lid. 2. Conrm +/- polarity , and insert two AAA batteries. 3. Close the lid. 1 − Intr oduction Never use a stabilizer or printab.
10 T ASCAM CD-RW900 Front panel 2 4 3 5 7 8 0 q w 6 9 1 e r t y u i o p a s d f g 1 POWER switch The power switch is used to switch the unit on and off.
1-Intr oduction T ASCAM CD-RW900 11 Rear panel h ANALOG INPUT (L, R) These RCA jacks accept analog audio signals from suitably-equipped units (−10 dBV , unbalanced). j ANALOG OUT (L, R) These RCA jacks output ana- log audio signals (at −10 dBV levels, unbalanced) to suitably-equipped units).
1-Intr oduction 12 T ASCAM CD-RW900 0 STOP key Use this key to stop playback or recor d- ing. q READY key Use this key to stands by playback or recor ding. w SYNC REC key Use this key to turn synchronized recor ding on and off (see “Synchr onized recording” on page 23 for details).
1-Intr oduction T ASCAM CD-RW900 13 3 − Menu operation Menu configuration The menus are congur ed as shown below . Please see the refer ence page for more details of each menu. The various settings and editing operations possible with the CD-RW900 are performed thr ough menu op- tions shown on the display .
14 T ASCAM CD-RW900 3−Menu operation appear . If the sub-menu PLA Y MODE is selected, the menu item shows up like this: NOTE Return to the sub-menu option selection screen, press the ESCAPE key on the front panel or the CLEAR key on the remote control.
T ASCAM CD-RW900 15 4−Playback operations The CD-RW900 can be used to play back CDs (includ- ing CD-R and CD-RW discs that have been recor ded and nalized on other types of recor der), as well as CD-R discs and CD-RW discs that have been recor ded on the unit.
16 T ASCAM CD-RW900 T rack sear ch 1 Press the ∆ / ˚ search key continuously on the front panel, or the SEARCH ∆ / ˚ key on the remote contr ol. 2 T o stop the search function, simply release the ∆ / ˚ or the SEARCH k e y . NOTE The search function does not operate with MP3 discs.
1-Intr oduction T ASCAM CD-RW900 17 Playback modes There ar e four differ ent playback modes. The selected mode will be indicated on the left of the display .
18 T ASCAM CD-RW900 NOTE The indicator ashes when a disc is not loaded into the unit. 4 Set the timer to the desir ed time. Consult the timer’ s operation manual for details. At the set time, the power to the CD-RW900 will be turned on, and playback will automatically begin.
T ASCAM CD-RW900 19 Pitch contr ol function A to B r epeat playback If a specic portion between two points on the disc is specied, that portion can be played back repeatedly . 1 During playback, press the A-B key on the remote control at the beginning of the desir ed portion on the disc.
20 T ASCAM CD-RW900 mp3. 1 mp3. 2 mp3. 3 mp3. 4 mp3. 5 mp3. 6 mp3. 7 mp3. 8 mp3. 9 Playing back MP3 files MP3 les recor ded onto a CD are handled the same way as les are handled in an or dinary PC, with some MP3 les held within a directory . In addition, several directories can be combined into one dir ectory .
1-Intr oduction T ASCAM CD-RW900 21 5−Recor ding The sampling frequency for CDs is 44.1 kHz. The CD- RW900 will always recor d (and play back) CDs at this frequency . However , if recor ding through a digital connection (either coaxial or optical) and the source has been r e- corded at a fr equency other than 44.
1-Intr oduction 22 T ASCAM CD-RW900 5−Recor ding Basic r ecording 1 Load a recor dable disc into the unit. As the disc loaded, the display shows TOC Reading. , with the period ashing. 2 Press the INPUT SELECT key to select a recor ding source (see “Input selection” on page 21).
1-Intr oduction T ASCAM CD-RW900 23 5−Recor ding Advanced r ecording Fade-in and fade-out recor ding At the beginning and end of recor ding, fade-in and fade-out effects can be performed.
1-Intr oduction 24 T ASCAM CD-RW900 When audio signal is not detected more than ve sec- onds, the CD-RW900 automatically will stop recor ding and enters recor d standby mode. NOTE In the Sync 1 mode, if the unit detects the signal which is under the adjusted level over ve secondsd, the Sync recording mode will be canceled.
1-Intr oduction T ASCAM CD-RW900 25 5− Advanced Recor ding Rec mute function The Rec mute function allows instant cut-off of the input signal, and recor ds four seconds of silence on the disc. While recor ding is in progress, pr ess the REC MUTE key on the remote contorl.
26 T ASCAM CD-RW900 Unfinalizing CD-RW discs If a CD-RW disc has been nalized, it is possible to erase the T able of Contents in the following way: 1 W ith the nalized disc loaded and the unit in stop mode, press the ERASE/DEL key on the front panel or the ERASE key on the remote contr ol.
T ASCAM CD-RW900 27 Erasing tracks This operation erases the specied track and all sub- sequent tracks from a r ecorded CD-RW disc. 1 During stop, press the ERASE/DEL key on the front panel or the ERASE key on the remote control. Se- lect the ERASE TRACK? rotating the MUL TI JOG dial or pressing the SKIP keys on the r emote con - trol.
28 T ASCAM CD-RW900 Titles can be given to the disc and the tracks on the disc, using the TEXT EDIT option on the TEXT sub- menu. NOTE After the title is selected and entered on the disc, and TOC lights up on the dis-play , if the power is tur ned off, the TOC will not be recor ded onto the disc, and the titles will not be added.
T ASCAM CD-RW900 29 Keyboar d type setting The CD-RW900 must be set for the type of keyboard being connected. Set the type using the sub-menu KEYBOARD option on the SYSTEM sub-menu. Select US for an English- language keyboard, or J P for a Japanese-language keyboard.
30 T ASCAM CD-RW900 T r oublshooting Symptom Possible cause and remedy There is no power to the unit. Please check the power cord is pr operly plugged in. “Disc Error!” is displayed. The disc may be dirty . Please replace the disc. Playback is not possible.
T ASCAM CD-RW900 31 Specifications Recordable discs CD-R, CD-R-DA, CD-RW , CD-RW-DA (High speed CD-R W is supported) Quantization bit depth 16 bit Sampling frequency 44.1 kHz Frequency r esponse 20 Hz~20 KHz S/N 95 dB 90 dB Dynamic range 95 dB 90 dB Distortion 0.
TEAC CORPORA TION Phone: +81-422-52-5082 www .tascam .com 3-7-3, Nakacho, Musashino-shi, T okyo 180-8550, Japan TEAC AMERICA, INC. Phone: +1-323-726-0303 www .tascam.com 7733 T elegraph Road, Montebello, California 90640 TEAC CANADA L TD. Phone: +1905-890-8008 Facsimile: +1905-890-9888 www .
デバイスTeac CD-RW900CDの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Teac CD-RW900CDをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはTeac CD-RW900CDの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Teac CD-RW900CDの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Teac CD-RW900CDで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Teac CD-RW900CDを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はTeac CD-RW900CDの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Teac CD-RW900CDに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちTeac CD-RW900CDデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
