BaumaticメーカーBDI652の使用説明書/サービス説明書
ページ先へ移動 of 44
BDI652 60 cm Fully integrated full height dishwasher.
USER MANUAL FOR YOUR BAUMATIC BDI652 60 cm Fully integrated full height dishwasher NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance.
3 Contents E n v i r o n m e n t a l n o t e 4 Important safety information 5 – 7 S p e c i f i c a t i o n s 8 - 9 Product and aperture di mensions 8 P r o d u c t s p e c i f i c a t i o n s 8 Ene.
ENVIRONMENTAL NOTE Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be undertake n by a competent person.
IMPORTANT SAFETY INFORMATION Y o u r s a f e t y i s o f t h e u t m o st importance to Baumatic. Please make sure that you re ad this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line.
6 o Care should be taken not to trap the power supply cable underneath the appliance whilst installing it. o No attempt should be made to al ter or modify the specifications of this appliance. In daily use o This appliance is only design ed to wash normal domestic washloads.
7 Child Safety o Your dishwasher should only be used by adults. You should not allow children in the area of the machine unsupervised. You should not let them touch the cont rols or play with the appliance. o It could be possible for a child or pet to gain access to the dishwasher if the door is left open.
8 Specifications Product dimensions Height: 820 - 850 mm Width: 595 mm Depth: 560 mm Aperture dimensions Height: 820 mm (min) Width: 600 mm Depth: 590 mm (min) Product specifications o 14 Place settin.
Electrical details Rated voltage : 230 Vac 50 Hz Supply connection : 13 A (double pole switched fused outlet with 3 m m c o n t a c t g a p ) Optional extra o DWD600SS- Stainless steel door with mark .
Control panel 1) Program indicator neons 2) Program selection button 3) Rinse aid and salt indicator neons 4) ½ load indicator neon 5) ½ load button 6) LED display 7) Delay start button 8) ON/OFF in.
Filling with dishwasher salt IMPORTANT: You should only use salt that is specially designed for use in a dishwasher. If any other type of salt is used in the appliance (in particul ar table salt), it will damage the water softener. o Ideally you should fill the water so ftener with salt, just before you are about to run a wash program.
o IMPORTANT: You do not need to pour 1 litre of water into the container when you subsequently fill the water softener with salt. Setting the water softener level It is possible to regulate the amount of salt that the water softener will release during a wash cycle.
Filling with rinse aid The rinse aid is released during the final rinse and it helps to prevent water from forming droplets on your dishes. These droplets will lead to sp ots and streaks being left on items after the wash program has completed. o Your dishwasher is designed to utilise liquid rinse aid.
o You should continue to adjust the rinse aid level upwards until you get no water spots. o If you get cloudiness or streakin g on your dishes, the rinse aid level is set too high and it is causing foaming during the wash cycle. Turn the arrow clockwise an d lower the setting to the next number.
Loading the upper basket The upper basket is most suited to washing delicate and light dishware, such as glasses, coffee & tea cups, saucers, plates, bowls and shallow pans (that are not heavily soiled). 1. Cups 2. Small serving bowl 3. Large serving bowl 4.
Maximum height of dishes (upper basket) Maximum height of dishes (lower basket) With upper basket raised 19 cm 30 cm With upper basket lowered 24 cm 25 cm I M P O R T A N T : C a r e s h o u l d b e t a k e n t o m a k e s u r e t h a t t h e s p r a y arms can move freely when item s have been loaded into the baskets.
The cutlery basket Cutlery should be placed inside of the cutlery basket. The cutlery basket should then be placed in th e appropriate position in the lower basket. 17 1. Forks 2. Soup spoons 3. Dessert spoons 4. Teaspoons 5. Knives 6. Serving spoon 7.
o Do not allow glasses to touch in side the dishwasher, otherwise damage may occur. o Small objects can be placed inside of the cutlery basket. The following items are NOT suitable for washing inside a dishwasher:- o Cutlery with a handle of mother-o f-pearl, wood, horn or china.
Program table Program Wash program Wash program information Description of cycle Detergent (pre/main) Program times Normal (*) For normally soiled loads, such as pots, plates, glasses and lightly soiled pans.
20 o Push the top and bottom baskets fully back into position. o Add detergent o Turn the appliance on by using the ON/OFF button. o IMPORTANT: Wait for 5 seconds before pressing the program selection button, ot herwise the appliance may not function correctly.
21 At the end of a wash program o The time display will flash for 8 seconds and a buzzer will sound. o If you have used the delay start mode, the time display will flash for 8 seconds but the buzzer will not sound. o Open the door of the appliance. o Use the ON/OFF button to switch the dishwasher off and unload the dishwasher.
Setting a half load The half load option means that the lower spray arm does not run. IMPORTANT: You should only load items in the upper basket when using the half load option. o Check whether the appliance needs ri nse aid or salt adding to it. o Pull out the top basket, and then lo ad it in accordance with the loading instructions.
o The neon indicates that you need to add dishwasher salt to the appliance. You should follow the procedure outlined on page 11. Cleaning and maintenance IMPORTANT: The appliance should be disconnected from your mains supply before commencing any cleaning process.
Cleaning the filters For best performance and results, the entire filter assembly should be thoroughly cleaned regularly (ide ally after each wash cycle). 1. Turn the coarse filter anti-clockwise and then lift it upwards. Rinse out this section under a tap to remove any food debris that remains in it.
Cleaning the spray arms The spray arms should be cleaned regularly, to prevent hard water deposits from clogging the spray arm jets and bearings. o To remove the spray arm, unscr ew the nut and take out the washer that sits on top of the spray arm. o Gently pull upwards to remove the spray arm.
Cleaning the door o To clean the edge around the outs ide of the door, you should use a soft, damp cloth only. o To prevent water from penetratin g the door lock or electrical components, DO NOT use a spray cleaner of any kind. o DO NOT use any abrasive cleaner or scouring pads on the inner or outer surfaces, as they may cause damage to them.
E4 o The machine has sensed water in the base. 9 Check that the outlet hose is not kinked or crushed. 9 Check that there are no blockages in the drain hose or the drainage system that the appliance is connected to. 9 The drain pipe may be placed in t oo high a position or incorrectly.
28 T A FAULT HAS BEEN General tro E CAUSES WHAT TO DO IF AN ENGINEER ATTEND S DURING THE GUARANTEE PERIOD AND FINDS THA CAUSED BY AN ITEM ON THE ERROR CODE LIST, WHICH COULD HAVE BEEN CLEARED BY THE CUSTOMER. THEN YOU MAY BE LIABLE FOR THE COST OF THE SERVICE CALL.
29 ior colourant was used Stained tub inter Detergent with Use a detergent without colourant. Dishes are not fully dried Rinse aid dispenser is empty aid ispenser is filled with rinse aid. Make sure that the rinse d Dishes and pans are not Improper progr am program.
30 nstallation I IMPORTANT: THIS INSTALLATION MUST BE COMPLETED BY A SUITAB LY QUALIFIED PERSON. BAUMATIC ONLY SANCTI ON THE INSTALLATION GIVEN IN THIS INSTRUCTION MANUAL.
31 Installation stages 2. Adjusting the tension of the door spring. e power supply 6. Applying the condensation strip ture door kilograms. The maximum thickn ess of the furniture door plate supp lied with the appliance to mark up and then drill out the necessary holes in the furniture door.
32 upper hooks onto the o Attach the lower the . the dishwasher door, ensuring locate into the slots on the so it locks into place on the o Open the dishwasher door covers that are located on either side of dge. the tightly into the o Attach the furniture door.
33 o IMPORTANT: You should make sure that the screws supplied are appropriate for the thickness of your furniture door. f the door spring o The door of the dishwasher is hed to springs.
34 djusting the positi on of the plinth ou can make an adjustment to the po sition and height of the plinth if equired, by following the process below:- o o left and o height A Y r Unscrew the two screws and re move the plinth from the dishwasher. Use the two screws to adjust the distance between the right hand plinth tabs.
35 nect the app liance to your mains existing water inlet hose. The inlet hose supplied with th e dishwasher is the ONLY one DO NOT CONNECT THE WATER INLET HOSE TO A HOT A The inlet hose will be located inside the cabinet of the dishwasher. Connect the water inlet hose to a threaded water tap that has a ua top.
36 onnecting to the water outlet 9 our drain pipe. C Secure the drain hose, so that it cannot move whilst the dishwasher is in use. 9 Place the end of the drain hose on your drain pipe. Push it a short way down into y 9 IMPORTANT: Do not insert the drain hose too deeply into the pipe, as this may cause siphoning.
37 9 Consult th de of the drop down door BEFORE making the electrical connections. OVE THE RATING PLATE AS THE INFORMATION ON IT IS IMPORTANT. he appliance must be placed into an earthed and insulated socket. be replaced by a suitably qualified person.
o The condensation strip will be located inside of your dishwasher. 38 sticking the strip to it. aper away from the strip. the worktop. ld result in damage to your worktop.
39 Levelling the appliance d i s h w a s h e r m u s t b e l e v e l f o r i t t o o p e r a t e properly. o Make sure that the dishwasher is supported whilst it is being levelled, otherwise it may tip over. o The rear feet can be adjusted by using the adjusted using a Use a spirit level to check that the appliance is level.
40 ecuring the dishwasher be secure d to the worktop, this can be done in one of two ways:- - Secure the dishwasher to the underside of the worktop by using two wood screws.
41 IMPORTANT: If your app liance appears not to be operating correctly, then you should disconnect it TO REPAIR THE APPLIANCE OURSELF. l e a s e n o t e t h a t i f a n e n g i n e e r i s asked to at.
United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Customer Care Telephone (0118) 933 6911 Customer Care Fax (0118) 986 9124 Spares Telephone (01235) 4372 44 Advice Line Telephone (0118) 933 6933 E-mail: sales@baumatic.
2.
3 3.
デバイスBaumatic BDI652の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Baumatic BDI652をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはBaumatic BDI652の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Baumatic BDI652の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Baumatic BDI652で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Baumatic BDI652を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はBaumatic BDI652の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Baumatic BDI652に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちBaumatic BDI652デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
