BaumaticメーカーBT26の使用説明書/サービス説明書
ページ先へ移動 of 28
.
1 User Manual for your Baumatic BT26SS Cooker Hood 60 cm Chimney Hood in Stainless Steel NOTE : This User Instruction Man ual contains imp ortant information, including safety & installation points, w hich will enable you to get the most out of your appliance.
2 YOUR COOKER HOOD’S SPECIFICATIONS ….……………..………….3 IMPORTANT SAFETY INFO RMATION……………………………….…4-5 CARING FOR THE ENVI RONMENT…………………………………………6 USING YOUR COOKER HOOD……………………………….
3 Congratulations on purchasing a Baumatic Cooker Hood! To fully enjoy using your app liance long into the future, please firstly familiarise yours elf with its specifications, safety advice and operational in structions included in this manual. You will also need this manual to ensure that your Cooker Hood has been installed properly.
4 o Any installation work must be carried out by a qualified electrician or competent person. o The hood must be installed in accordance with the installation instructions and all measurements followed.
5 o Ensure the ducting for the extractor function has the same diameter as the outlet hole all the way through. o Keep young children from using, playing with or tampering with the cooker hood. Older children and infirm persons should be supervised if they are using the cooker hood.
6 Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be under taken by a competent person.
7 To use your cooker hood: 1) Make sure it has been properly installed. 2) Find the CONTROL PANEL. It is located centrally at the front of the canopy. 3) The CONTROL PANEL contains keys as shown in the Figure below. These perform separate functions. You will need to understand what the keys do before you attempt to use your cooker hood.
8 SPECIAL FUNCTIONS : Your Baumatic Cooker Hood also has advanced features. These are: a) Reminder to clean t he Metal Grease Filters After every 30 hours of use, your cooker hood’s microprocessor will alert you to clean the metal grease filters. It does this by showing a flashing ‘A’ on the display for 5 seconds .
9 IMPORTANT! : Before cleaning, always ensure that you have switched your cooker hood OFF at the omni-polar switch, set at the wall from t he cable: Cleaning  Clean the external p arts with mild liquid deterg ents on a damp cloth.  Never use abrasive powder, corrosive solvents or brushes.
10 First remove the grille by pu lling down on it. Undo the side catches. You can now clean the anti -grease filter grilles. 9 Soak them for about one hour in hot water with a grease-loosening detergent then rinse off thoroughly with hot water. 9 Repeat the process if needed .
11 a) Changing the light bulb 9 Before changing the light bulb, ensure th at the appliance is not live (i.e., ensure that you have switched it off so that it’s in the ‘0’ position). 9 Remove the metal anti-grease filters (se e Figure 2 below) and find the old bulbs located in the light fixture up inside the exposed canopy.
12 _____________________________________________ _________________________________________ Installing / Changing the Carbon Filter . Your Baumatic Cooker Hood uses CARBON FILT ERS to purify the air for the air recirculation function. You will find two filters t hat will attach to both sides of the fan motor (please see fi gures at bottom of page).
13 Before installation and usage, read all t he instructions and ma ke sure that the voltage (V) and th e frequency (Hz) indicated on th e identification p late (found inside your Cooker Hood) and all the dat a inside the ap pliance are exactly the same as the voltage and frequency in your home.
14 : The cooker hood must not be fitted above stoves with a radiant top plate. : We recommend that at least two people install this hood. NOTE: Your Baumatic Cooker Hood shou ld only be fitted on a wall. Do NOT position it any less tha n 700 mm (70 cm) above the hob.
15 ------------------ ---------------------------------------- ---------------- 3) Using a drill bit with a 6 mm diameter, make holes in the wall where you have marked these positions (see below).
16 ------------------------------ -------------------------------------------- ----------------- ------------------------------ -------------------------------------------- ----------------- 6) (EXTRACTION F UNCTION ONLY) Conne ct the coupling to the top of the cooker hood (see below).
17 FITTING THE PIPE – Once your Cooker Hood has been installed, you can now fit the pipe. 1) Take the two casing s ‘A’ and ‘B’: 2) Rest the bottom of the casing ‘A’ on the top of the hood, taking care to position the tabs of the casing correctly on the back of the hood as shown as p art ‘X’ in Figure 4 at right.
18 6) Take the fixing bracket ‘G’ (Fig . 4 – prev ious page), centre it with respect to the mark you pr eviously made, keeping it in contact with the ceiling, and then ma rk the a nchoring hol es (‘H’). 7) Using a drill bit with a 6mm di ameter, make two holes on the fixing marks you previously mad e (see below).
19 EXTRACTION OPERATION – Installation Instructions  Ensure that you have fitted the union (‘N’) to the upper part of the hood using the packaged t wo screws supplied inside the packing (Fig. 1 – on r ight). Using a 125 mm diameter pipe, connect the union (N) on the upper part of the hood (see Fig.
20 * Note on what to do if your Cooker Hood is the version that comes with a BRACKET. Please note that your cooker hood may include a lower bracket. If this is the case, you will need to have it installed as such. This will mean a slight change in how the cooker hood is to be installed from the process shown on page 14.
21 If something has gone wrong with your Cooker Hood, checking against this chart might keep you from having to call for service. Symptom Solution The cooker hood will not start! • Check that the hood is connected to the electricity supply. • Check that the fan speed control is set properly.
22 BAUMATIC LTD. - CONDITIONS OF GUARANTEE. Dear Customer, The conditions of guarantee which apply to your Baumatic a ppliance are as follo ws: This product is guaranteed for 12 months from the date of original purchase. Baumatic Ltd will repair any defect that arises due to faulty materi als or workmanship free of charge during this period.
23 Baumatic Ltd Make-up for your kit chen Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephon e +44 118 933 6900 Sales Fax +44 118 9.
24.
25.
26.
27.
デバイスBaumatic BT26の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Baumatic BT26をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはBaumatic BT26の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Baumatic BT26の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Baumatic BT26で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Baumatic BT26を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はBaumatic BT26の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Baumatic BT26に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちBaumatic BT26デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
