Texas InstrumentsメーカーTPA3008D2の使用説明書/サービス説明書
ページ先へ移動 of 31
www.ti.com FEATURES DESCRIPTION APPLICATIONS 10 µ F 220 nF 220 nF PVCC PVCC 220 nF 220 nF PVCC PVCC 220 pF Left Differential Inputs Right Differential Inputs Shutdown/Mute Gain Control BSLP PVCCL PVC.
www.ti.com ABSOLUTE MAXIMUM RATINGS DISSIPATION RATING TABLE RECOMMENDED OPERATING CONDITIONS TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 These devices have limited built-in ESD protection.
www.ti.com AVAILABLE OPTIONS DC ELECTRICAL CHARACTERISTICS AC ELECTRICAL CHARACTERISTICS TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 T A PACKAGED DEVICE 48-PIN HTQFP (PHP) (1) -40 ° C to 85 ° C TPA3008D2PHP (1) The PHP package is available taped and reeled.
www.ti.com Biases and References TTL Input Buf fer (VCC Compl) Start-up and Protection Logic SC Detect Thermal VDDok RINP RINN Ramp Generator COSC ROSC VCCok 5-V LDO A VCC A VDD A VDD VDD and PWM Mode Logic Gain Adj. Gain Control Deglitch and PWM Mode Logic Gain Adj.
www.ti.com 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 48 47 46 45 44 43 42 41 40 39 38 37 1 2 3 4 5 6 7 8 9 10 1 1 12 BSRN PVCCR PVCCR ROUTN ROUTN PGNDR PGNDR ROUTP ROUTP .
www.ti.com TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 TERMINAL FUNCTIONS PIN NAME PIN NUMBER I/O DESCRIPTION AGND 26, 30 - Analog ground for digital/analog cells in core AV CC 33 - High-voltage analog power supply, not connected internally to PVCCR or PVCCL 5-V Regulated output for use by internal cells and GAIN0, GAIN1 pins only.
www.ti.com TYPICAL CHARACTERISTICS 0.01 20 20 k 100 1 k 10 k THD+N −T otal Harmonic Distortion + Noise − % V CC = 18 V , R L = 16 Gain = 21.6 dB f − Frequency − Hz 10 0.1 P O = 2.5 W P O = 0.5 W P O = 1 W 1 0.005 10 0.01 0.1 20 20 k 100 1 k 10 k P O = 2.
www.ti.com 0.005 10 0.01 0.1 20 20 k 100 1 k 10 k P O = 5 W THD+N −T otal Harmonic Distortion + Noise − % V CC = 18 V , R L = 8 , Gain = 21.6 dB f − Frequency − Hz P O = 1 W P O = 2.5 W 1 0.01 0.1 10 20 20 k 100 1 k 10 k THD+N −T otal Harmonic Distortion + Noise − % V CC = 12 V , R L = 8 Gain = 21.
www.ti.com 28 24 20 16 10 100 1k Gain − dB 32 36 f − Frequency − Hz 40 10k 12 8 4 0 80k V CC = 12 V , R L = 8 Ω, Gain = 32 dB 33 kHz, RC LPF Gain Phase Phase − 50 0 100 −150 −100 −.
www.ti.com 0 10 20 30 40 50 60 70 80 90 100 0 1 2 3 4 5 6 7 8 9 10 Efficiency − % 16 8 P O − T otal Output Power − W 1 1 12 V CC = 12 V , LC Filter , Resistive Load, Stereo Operation 0 0.2 0.4 0.6 0.8 1 1.2 1.4 0 2 4 6 8 10 12 P O − T otal Output Power − W 1.
www.ti.com −70 −60 −50 −40 −30 −20 −10 0 100 1 k 10 k 20 V CC = 12 V , Gain = 15.6 dB, R L = 8 Output Referred f − Frequency − Hz CMRR − Common-Mode Rejection Ratio − dB 20 k TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 COMMON-MODE REJECTION RATIO vs FREQUENCY Figure 15.
www.ti.com APPLICATION INFORMATION 220 nF 220 nF PVCC PVCC 220 nF 220 nF PVCC PVCC 220 pF Right Differential Inputs Shutdown/Mute BSLP PVCCL PVCCL LOUTP LOUTP PGNDL PGNDL LOUTN LOUTN PVCCL PVCCL BSLN .
www.ti.com CLASS-D OPERATION Traditional Class-D Modulation Scheme 0 V −12 V +12 V Current OUTP Differential V oltage Across Load OUTN TPA3008D2 Modulation Scheme TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 APPLICATION INFORMATION (continued) This section focuses on the class-D operation of the TPA3008D2.
www.ti.com 0 V −12 V +12 V Current OUTP OUTN Differential V oltage Across Load 0 V −12 V +12 V Current OUTP OUTN Differential V oltage Across Load Output = 0 V Output > 0 V Efficiency: LC Filte.
www.ti.com Effects of Applying a Square Wave Into a Speaker Efficiency (t heoretical, %) R L R L r ds(on) 100% 8 (8 1.3) 100% 86% (1) P (total) P O Efficiency 8.5 W 0.86 9.88 W (2) Other losses P (tot al) (measured) P (total) (theoretical) 10.
www.ti.com 0.1 µ F 0.1 µ F 0.47 µ F 33 µ H 33 µ H OUTP OUTN L 1 L 2 C 1 C 2 C 3 1 nF Ferrite Chip Bead OUTP OUTN Ferrite Chip Bead 1 nF Gain setting via GAIN0 and GAIN1 inputs INPUT RESISTANCE TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 APPLICATION INFORMATION (continued) Figure 19.
www.ti.com C i IN Z i Z f Inpu t Signal f 1 2 Z i C i (5) INPUT CAPACITOR, C I f c 1 2 Z i C i −3 dB f c (6) C i 1 2 Z i f c (7) Power Supply Decoupling,C S TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 The -3-dB frequency can be calculated using Equation 5.
www.ti.com BSN and BSP Capacitors VCLAMP Capacitors Internal Regulated 5-V Supply (AV DD ) Differential Input SHUTDOWN OPERATION USING LOW-ESR CAPACITORS TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 The full H-bridge output stages use only NMOS transistors.
www.ti.com SHORT-CIRCUIT PROTECTION AND AUTOMATIC RECOVERY FEATURE THERMAL PROTECTION PRINTED-CIRCUIT BOARD (PCB) LAYOUT TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 The TPA3008D2 has short-c.
www.ti.com BASIC MEASUREMENT SYSTEM TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 This application note focuses on methods that use the basic equipment listed below: • Audio analyzer or spec.
www.ti.com Analyzer 20 Hz − 20 kHz (a) Basic Class−AB AP A Signal Generator Power Supply Analyzer 20 Hz − 20 kHz R L (b) Filter-Free and T raditional Class-D Class-D AP A Signal Generator Power .
www.ti.com C IN Audio Power Amplifier Generator Low−Pass RC Filter C IN R GEN R GEN R IN R IN V GEN R OUT R OUT Analyzer R ANA R ANA C ANA Low−Pass RC Filter R L C ANA T wisted-Pair Wire Evaluation Module T wisted-Pair Wire CLASS-D RC LOW-PASS FILTER TPA3008D2 SLOS435A – MAY 2004 – REVISED JULY 2004 Figure 22.
www.ti.com R FIL T R L R FIL T C FIL T V L = V IN V OUT R ANA C ANA R ANA C ANA C FIL T T o AP A GND AP Analyzer Input RC Low-Pass Filters Load V OUT V IN R ANA R ANA R FILT 1 .
.
PACKAGING INFORMATION Orderable Device Status (1) Package Type Package Drawing Pins Package Qty Eco Plan (2) Lead/Ball Finish MSL Peak Temp (3) TPA3008D2PHP ACTIVE HTQFP PHP 48 250 Green (RoHS & n.
TAPE AND REEL BOX INFORMATION Device Package Pins Site Reel Diameter (mm) Reel Width (mm) A0 (mm) B0 (mm) K0 (mm) P1 (mm) W (mm) Pin1 Quadrant TPA3008D2PHPR PHP 48 SITE 60 330 16 9.
Device Package Pins Site Length (mm) Width (mm) Height (mm) TPA3008D2PHPR PHP 48 SITE 60 346.0 346.0 33.0 PACKAGE MATERIALS INFORMATION www.ti.com 5-Oct-2007 Pack Materials-Page 2.
.
.
.
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice.
デバイスTexas Instruments TPA3008D2の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Texas Instruments TPA3008D2をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはTexas Instruments TPA3008D2の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Texas Instruments TPA3008D2の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Texas Instruments TPA3008D2で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Texas Instruments TPA3008D2を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はTexas Instruments TPA3008D2の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Texas Instruments TPA3008D2に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちTexas Instruments TPA3008D2デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
