BehringerメーカーMX3282Aの使用説明書/サービス説明書
ページ先へ移動 of 33
EURODESK ® MX3282A www.behringer.com Version 1.1 M a r ch 2 0 0 1 Users Manual ENGLISH.
2 EURODESK MX3282A This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature.
3 EURODESK MX3282A FOREWORD Dear Customer, Welcome to the team of EURODESK users and thank you very much for expressing your confidence in BEHRINGER products by purchasing the MX3282A.
4 EURODESK MX3282A MX3282A EURODESK ® Professional 32-channel 8-bus recording & live-mixing console in ultra low-noise design s 32 microphone/line inputs, 24 mono and 4 stereo s Ultra low-noise, .
5 EURODESK MX3282A T ABLE OF CONTENTS 1 . THE MANUAL .......................................................................................................................... 7 1. 1 Wa r ra n ty .......................................................
6 EURODESK MX3282A 10. APPLICA TI ON S .................................................................................................................... 23 10.1 Keyboard Submixi ng ...................................................................
7 EURODESK MX3282A 1. THE MANUAL 1. THE MANUAL Thank you for expressing your confidence in us and our work by purchasing the EURODESK MX3282A. Our first task in writing this manual is to make you feel comfortable with the special terms that are used to describe your EURODESK MX3282A and its proper use.
8 EURODESK MX3282A 2. EURODESK OVERVIEW 2.1 Architecture The MX3282A is a conventional split console. By this we mean that the inputs and outputs occupy separate areas of the board. This makes for easier visualization of signal path compared to an in-line design, which uses combined input/output channels.
9 EURODESK MX3282A + The master clip LEDs (+22 dBu) should never be allowed to illuminate. If they do, reduce either the MAIN MIX fader or the group(s) and/or channel fader(s), or (as a last resort) the channel input gain(s). Maybe its time to do a round of PFL metering.
10 EURODESK MX3282A In addition to switchable Solo/PFL metering, a couple of channel LEDs ( / ) illuminate when a signal is present (-20 dB), or if a channel is going into overload. These LEDs are particularly useful when using extreme EQ settings, or adding a dynamics processor via an insert.
11 EURODESK MX3282A Level to the group and main left and right busses is ultimately determined by the channel fader . This is designed to give a smooth logarithmic taper of a type more usually associated with megabuck consoles. The low level performance particularly is far smoother than that of a normal budget fader.
12 EURODESK MX3282A 5 . SUBGROUPS AND INSERTS 5 . 1 Subgroups The principal routes to multitrack are via the subgroup outputs. There are eight mono (or four stereo) subgroups.
13 EURODESK MX3282A Fig. 5.2: Inserting an external EQ/dynamics processor post channel EQ In this arrangement you might find that compression tends to soften the perceived amount of (especially treble) EQ applied. The solution here is to apply more EQ.
14 EURODESK MX3282A + EURODESK insert points are, of course, simultaneously inputs and outputs. For goodness sake, get them onto a patchbay, where they can appear as independent sockets, and do away with all these fiddly Y-teads that always seem to be the first to get knotted in the flightcase (see section 9: PATCHBAY).
15 EURODESK MX3282A + There is no absolute reason why the send from aux 1 should feed into a processor whose outputs are sent to the aux return 1. The processor could just as easily be patched into the aux return 3, or even a pair of channels.
16 EURODESK MX3282A With the MON/CT R LEVEL control fully clockwise, your 2-track input will be matched to the semi- professional level -10 dBV. For higher output recording sources (e.
17 EURODESK MX3282A + Care should be taken NOT to plug mics into the console (or stagebox) while the phantom power is on. Also mute the monitor / PA speakers when turning phantom power on or off. Allow 1 minute after powering up for the system to equilibrate before setting input gains.
18 EURODESK MX3282A Fig. 7.1: Different plugs (overview) 7. CONNECTIONS.
19 EURODESK MX3282A 8. SETTING UP 8. 1 Selecting Inputs 1) Mono channels accept mic or line inputs. If you are using the mic input, make sure nothing is connected to the line input (and vice-versa). Please note that mic inputs are many times more sensitive than line inputs! + Do not connect mics with phantom power switched on.
20 EURODESK MX3282A 8. 4 Desk Normalization All board settings should be set to the normal default condition before or after every session. Usually faders are set to zero (minus infinity) EQs set flat, trimpots and channel aux sends turned fully anticlockwise etc.
21 EURODESK MX3282A 9. 3 Normalled Fig. 9.3: Patchbay mode normalled Here, and in contrast to the half-normalled setup, the signal route of the rear phone jacks is interrupted when you insert a plug both into the upper and lower front jacks.
22 EURODESK MX3282A 1 2 3 4 Fig. 9.5: Example of a studio organization with four patchbays In the first eight modules of patchbay 1 the subgroup outputs are directly connected to the corresponding multitrack inputs. In addition to that it is also possible to record the signals coming from a subgroup on a different track of the multitrack.
23 EURODESK MX3282A In patchbay 3 , modules 1 through 16 are for the channel insert. These modules are half-normalled, so that you have an additional route for the channel signals. The same applies to the insert paths of the subgroups and the master output.
24 EURODESK MX3282A + Try using a compressor and noise gate on vocals, bass guitar and even drums via channel insert. + Effects may be a little over-the-top for a live band (not so for a dance act!). You might want to have 2 effects sends, but six independent cue feeds for on-stage monitoring.
25 EURODESK MX3282A 10.3 8-Track Studio Recording 8-track MIDI project studio with sampler, 8-track recording system, one vocal mic and several effects units. With largely computer-generated dance music you will want to have plenty of line inputs, and an ability to take vocals quickly, efficiently, and with minimal desk disturbance.
26 EURODESK MX3282A Chan nel I npu t Sou rce Sub group /Tr ack Mic /Lin e mon o/st ere o 1 Tape 1 2 Tape 2 Mix L M 3 Tape 3 Mix L M 4 Tape 4 Mix L M 5 Tape 5 Mix L M 6 Tape 6 Mix L M 7 Tape 7 Mix L M .
27 EURODESK MX3282A 10.4 16-Track Studio Recording This set-up is for a multipurpose studio capable of recording live bands. The following layout is for a bass & drum take while other artists also perform guides to give correct feel for the song. Mic channels are used to record to tape, eight tracks at a time (max.
28 EURODESK MX3282A Channe l Inpu t Source Sub gro up/Track Mic/Line mo no/ster e o 1 (Kick D r.) Tape 1 mix* L m 2 (Snar e Dr.) Ta pe 2 mix* L m 3 (Hi-Hat) Tape 3 mix* L m 4 (To m 1) Tape 4 mix* L m 5 (etc.
29 EURODESK MX3282A Check that the input levels to each track are optimized before recording commences. 10.6 Recording Levels When recording to digital, its a good idea to keep the recorders peak meters below 0 dB. Most (not all, esp. samplers) read 0 dB with some headroom left.
30 EURODESK MX3282A A vocal signal can be enhanced by applying a significant boost in the 12 kHz region or higher, above the nasty sibilance region. This is especially effective if youve got a de-esser patched post-EQ.
31 EURODESK MX3282A 13. MODIFICATIONS The following modifications require you to do some soldering. Only attempt that if you are experienced in using an iron on PCBs. Otherwise, refer to qualified personnel. After modification the BEHRINGER warranty becomes discretionary.
32 EURODESK MX3282A 14. SPECIFICATIONS Input channels Mic input Electronically balanced, discrete input configuration Mic E.I.N. (22 Hz - 22 kHz) 129.0 dBu, 150 Ohm source 1 17.
33 EURODESK MX3282A The information contained in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mec.
デバイスBehringer MX3282Aの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Behringer MX3282Aをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはBehringer MX3282Aの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Behringer MX3282Aの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Behringer MX3282Aで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Behringer MX3282Aを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はBehringer MX3282Aの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Behringer MX3282Aに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちBehringer MX3282Aデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
