Troy-Biltメーカーtb25ghtの使用説明書/サービス説明書
ページ先へ移動 of 22
U.S.A. Imported by: MTD LLC P .O. Box 361131 Cleveland, OH 44136-0019 Made in China / Hecho en China STOP ALTO For problems or questions, DO NOT return this product to the store.
3 SP ARK ARRESTOR NOTE NOTE: For users on U.S. Forest Land and in the states of Califor nia, Maine, Or egon and W ashington. All U.S. For est Land and the state of Califor nia (Public Resources Codes .
3 SP ARK ARRESTOR NOTE NOTE: For users on U.S. Forest Land and in the states of Califor nia, Maine, Or egon and W ashington. All U.S. For est Land and the state of Califor nia (Public Resources Codes .
RULES FOR SAFE OPERA TION WHA T T O DO READ Y OUR USER MANU AL AND ALL SUPPLEMENTS (IF ANY ENCLOSED) THOROUGHL Y BEFORE OPERA T- ING Y OUR UNIT . 1. WEAR CLOSE FITTING, TOUGH WORK CLO THING that will .
RULES FOR SAFE OPERA TION WHA T T O DO READ Y OUR USER MANU AL AND ALL SUPPLEMENTS (IF ANY ENCLOSED) THOROUGHL Y BEFORE OPERA T- ING Y OUR UNIT . 1. WEAR CLOSE FITTING, TOUGH WORK CLO THING that will .
RULES FOR SAFE OPERA TION KNOW YOUR HEDGE TRIMMER HEDGE TRIMMER COMPONENTS 1. Blades 2. Saf ety Guard 3. F ront Handle 4. Primer Bulb 5. Fuel Cap 6. ON-OFF Switch 7. Throttle Lock 8. Choke Le v er 9. Air Filter Co ver 10. Spark Plug 11. Star ter Handle 12.
RULES FOR SAFE OPERA TION KNOW YOUR HEDGE TRIMMER HEDGE TRIMMER COMPONENTS 1. Blades 2. Saf ety Guard 3. F ront Handle 4. Primer Bulb 5. Fuel Cap 6. ON-OFF Switch 7. Throttle Lock 8. Choke Le v er 9. Air Filter Co ver 10. Spark Plug 11. Star ter Handle 12.
ST ARTING A COLD ENGINE (Above 55˚F) Mix the bottle of 2-cycle oil (included) with 1 gallon of unleaded gasoline (less than 30 days old). Combine them in a separate container using a 40:1 ratio . Pour into fuel tank. 1. Mov e on/off ignition s witch to the “R UN (I) ” position.
ST ARTING A COLD ENGINE (Above 55˚F) Mix the bottle of 2-cycle oil (included) with 1 gallon of unleaded gasoline (less than 30 days old). Combine them in a separate container using a 40:1 ratio . Pour into fuel tank. 1. Mov e on/off ignition s witch to the “R UN (I) ” position.
TRIMMING INSTRUCTIONS ST AR TING/STOPPING INSTRUCTIONS 10 11 W ARM ENGINE ST ART 1. Move ignition s witch to the “R UN (I)” position. 2. Place choke in P AR TIAL CHOKE “ ” position (Figure 8 ). 3. Grasp throttle handle fir mly , depress safety trigger , and squeeze throttle trigger to FULL position.
TRIMMING INSTRUCTIONS ST AR TING/STOPPING INSTRUCTIONS 10 11 W ARM ENGINE ST ART 1. Move ignition s witch to the “R UN (I)” position. 2. Place choke in P AR TIAL CHOKE “ ” position (Figure 8 ). 3. Grasp throttle handle fir mly , depress safety trigger , and squeeze throttle trigger to FULL position.
MAINTENANCE AND REP AIR INSTRUCTIONS MAINTENANCE SCHEDULE Perform these requir ed maintenance pr ocedures at the fr e- quency stated in the table. These pr ocedur es should also be a part of any seasonal tune-up.
MAINTENANCE AND REP AIR INSTRUCTIONS MAINTENANCE SCHEDULE Perform these requir ed maintenance pr ocedures at the fr e- quency stated in the table. These pr ocedur es should also be a part of any seasonal tune-up.
ST ORING A UNIT F ailure to follow these steps ma y cause v arnish to f orm in the carb uretor and difficult starting or per manent damage f ollowing stor age. 1. P erform all the general maintenance recommended in the Maintenance Section of your User Man ual.
ST ORING A UNIT F ailure to follow these steps ma y cause v arnish to f orm in the carb uretor and difficult starting or per manent damage f ollowing stor age. 1. P erform all the general maintenance recommended in the Maintenance Section of your User Man ual.
TROUBLESHOOTING CAUSE ACTION 1. Incorrectly gapped spark plug 1. Clean/gap or replace plug 2. Plugged spark arrestor 2. Clean or replace spark arr estor 3. Dir ty air filter 3. Clean or r eplace air filter CAUSE ACTION 1. Incor r ect carbur etor mixtur e adjustment setting 1.
TROUBLESHOOTING CAUSE ACTION 1. Incorrectly gapped spark plug 1. Clean/gap or replace plug 2. Plugged spark arrestor 2. Clean or replace spark arr estor 3. Dir ty air filter 3. Clean or r eplace air filter CAUSE ACTION 1. Incor r ect carbur etor mixtur e adjustment setting 1.
19 P AR TS LIST 18 California / EP A Emission Control W arranty Statement Y our W arranty Rights and Obligations The Califor nia Air Resources Board, The Envir onmental Pr otection Agency and T roy Bilt ar e pleased to explain the emission control system warranty on your 2005 and later small of f-r oad engine.
19 P AR TS LIST 18 California / EP A Emission Control W arranty Statement Y our W arranty Rights and Obligations The Califor nia Air Resources Board, The Envir onmental Pr otection Agency and T roy Bilt ar e pleased to explain the emission control system warranty on your 2005 and later small of f-r oad engine.
MANUF ACTURER’S LIMITED W ARRANTY FOR: No implied warranty , including any implied warranty of merchantability or fitness for a particular purpose, applies after the applicable period of express written warranty above as to the parts as identified.
.
U.S.A. Imported by: MTD LLC P .O. Box 361131 Cleveland, OH 44136-0019 Made in China / Hecho en China STOP ALTO For problems or questions, DO NOT return this product to the store.
デバイスTroy-Bilt tb25ghtの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Troy-Bilt tb25ghtをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはTroy-Bilt tb25ghtの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Troy-Bilt tb25ghtの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Troy-Bilt tb25ghtで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Troy-Bilt tb25ghtを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はTroy-Bilt tb25ghtの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Troy-Bilt tb25ghtに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちTroy-Bilt tb25ghtデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
