UnidenメーカーUH-052XRの使用説明書/サービス説明書
ページ先へ移動 of 28
UH-052XR Operating Guide.
➤ The UH052XR is splashproof* only when both the antenna and the battery are properly attached. ➤ Do not operate the transmitter of any radio equipment unless all the Radio Frequency (RF) connectors are secured and any open connectors are properly terminated.
Introduction Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 T echnical Support & Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Included in your UH-052XR Package . . . . . . . . .
The UH-052XR is a splash proof, portable two-way UHF-CB radio. It is compact, rugged and fits easily in your hand. This hand held UHF radio will give you consistent, outstanding performance in virtually all conditions and situations.
TECHNICAL SUPPORT AND SERVICE Should you find it desirable or necessary to service your UH-052XR , we suggest you contact the Uniden dealer where you purchase your radio.
INCLUDED IN YOUR UH-052XR P ACKAGE 3 Note: If any of these items are missing from the box, contact your Uniden Dealer . Antenna AC Adaptor (AAD-052S) UH-052XR Wrist Strap Battery BP-052 (7.
A TT ACHING THE ANTENNA Attach the antenna to the UH-052XR following direction as indicated below . Be sure the antenna is firmly seated. A TT ACHING THE BA TTERY P ACK 1. Slide the battery pack onto the bottom of the radio. 2. Use a coin to turn the screw that connects the battery pack to the UH-052XR .
BA TTERY CHARGE INDICA TOR When charging, the CHG icon appears on the display . Note : 1. Transmit Operation is disabled when UH-052XR is being charged. 2. A single tone is emitted by the radio and CHG is displayed to indicate that it has started charging.
➤ When you press any key (except PTT), a short tone sounds. ➤ See the Controls and Indicators page at the back of this operating guide for button and key operations. POWER ON/OFF T o turn the unit ON , rotate the [ON/OFF VOL] clockwise until a “click” is heard.
SQUELCH The squelch is used to eliminate any annoying background noise when there are no signals present. Think of squelch as a gate. T urn [SQ] fully clockwise. This raises the ”Squelch Gate” so high that only the very strong signals can get through.
TO TRANSMIT AND RECEIVE The UH-052XR uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed at the end of this manual. 1. The maximum RF transmit power of UH-052XR is 5 watts. T o switch to low power , press the [1/5W] .
USING A REPEA TER CHANNEL UHF CB Repeaters are used to retransmit or relay your signal. Repeaters will extend the range of your radio and overcome the shielding effect caused by solid obstructions. In normal Simplex operation, your radio transmits on one particular frequency and receives on that same frequency .
TO OPERA TE UH-052XR IN DUPLEX MODE Eg. CH01 is being used in your area for repeater use. Press [DUP] momentarily . The DUP icon appears. Press [DUP] again to deactivate the duplex operation.
Note: 1. If SCAN is deactivated while in an active channel, the UH-052XR will stay on that active channel. If no other channels are active, the UH-052XR will reinstate the starting channel. 2. Pressing [CTCSS] for 1.5 Secs. Will deactivate Open Scanning and activate CTCSS Scanning.
Programming Scan Channels 1. Select which Scanning Mode you wish to use on the channel OS or GS Mode Note: OS is indicated by the absence of the GS icon 2. Select the channel you want to store by pressing [ ▲ ] or [ ▼ ] 3. Press and hold [MEM] for 1.
Programming CTCSS Code 1. Select a desired channel to be used with CTCSS . 2. Press and hold [CTCSS] for 1.5 secs. CTCSS icon blinks. 3. Press [ ▲ ] or [ ▼ ] to select the desired CTCSS code. 4. Press [CTCSS] to save the selected code. CTCSS icon stops blinking.
NOTE: VOX feature will not work without the Headset Microphone. Built in [PTT] of UH-052XR is temporarily disabled, however accidental pressing of [PTT] will cause the unit to transmit briefly . T o activate VOX 1. Press and hold [VOX] for 1.5 secs. “VOX” icon blinks.
➤ POWER SA VE Battery Save feature extends the battery life by switching the receiver circuit power ON and OFF . This feature automatically activates during stand by mode (RX mode without signal). A flashing icon will appear on the display when the battery save feature is ON.
➤ BUSY CHANNEL LOCK-OUT(BCL) This feature prevents accidental transmission on a busy channel. This is recommended on channels where CTCSS is being used. If the channel is “ active ” and the signal is coming from a non or different CTCSS code user the BCL feature will prevent you from transmitting.
➤ BA TTERY LEVEL DISPLA Y The icon in the top right hand corner of the screen indicates the UH-052XR current battery voltage level at all times. The battery level is displayed in 4 levels: LEVEL 4 B.
* Emergency calling for both simplex and duplex operation Please do not use this channel in non-emergency cases. # Back-up Emergency Channel Ch. Freq. Usage Ch. Freq. Usage 01 476.425 Simplex/Duplex 21 476.925 Simplex 02 476.450 Simplex/Duplex 22 476.
• Battery (BP-052) • VOX Headset (VM-052) • Speaker Microphone (SM-050) • AC Adaptor (AAD-052S) • Cigarette Lighter Charger (CL-050) • Battery Eliminator (BE-050) • Standard Headset Microphone (HM-050) OPTIONAL ACCESSORIES Code No. Freq.
General Channels T ransmit 40 (with Duplex Channel Support) Receive 40 Oper . T emp. 0 ˚ C - +55 ˚ C Antenna Flexible Whip Microphone Built-in Electret type Display Liquid Crystal Display Speaker 8 Ω 1 Watt Power Source BP-052 Rechargeable Nickel-cadmium Battery Pack 950mAh, 7.
Charger Std. Power Supply AAD-052S Input 230~240V AC, 50Hz Output 9V , 210 mA Approval No. V/00031 Specifications shown are typical and subject to change without notice.
UNIDEN UH-052XR UHF CB RADIO Australian One Y ear Warranty Note: Please keep your sales docket as it provides evidence of warranty . Warrantor: Uniden Australia Pty Limited ACN 001 865 498 Elements of.
DC9V CHG CTCSS BCL OFF VOL SQ MEM LOCK 1/5W OS/GS DUP SCAN MIC SPKR VOX CTCSS 2 3 1 4 5 7 8 UH-052XR 13 14 15 10 12 9 6 11 17 18 16 CONTROLS & INDICA TORS 23.
1. Antenna 2. Belt Clip 3. PTT (Push-to-talk) Switch 4. Monitor Switch 5. Charging Jack 6. Charging Jack Cover 7. Battery 8. Speaker 9. Lock Key 10. 1/5W Key 11. OS/GS and VOX Key 12. LCD Display 13. On/Off Volume Key 14. Squelch Key 15. Speaker Mic Jack Cover 16.
© 2000 Uniden Australia Pty Limited/Uniden New Zealand Limited Part Code UTZZ01872ZZ.
デバイスUniden UH-052XRの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Uniden UH-052XRをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはUniden UH-052XRの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Uniden UH-052XRの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Uniden UH-052XRで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Uniden UH-052XRを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はUniden UH-052XRの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Uniden UH-052XRに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちUniden UH-052XRデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。