United States Stoveメーカー1800GCの使用説明書/サービス説明書
ページ先へ移動 of 20
Installation/Operator's Manual # 851502 Installation/Operator's Manual # 851502 Installation/Operator's Manual # 851502 Installation/Operator's Manual # 851502 Installation/Operato.
TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS Introduction ....................................................................................................... 3 Locating Your Furnace ....................
INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION Thank you for your purchase of a U.S. Stove Woodburning furnace. Your decision to buy a Hotblast Furnace was undoubt- edly reached after much careful thought and consideration. We are very proud you chose the U.
NOTE: Type of chimney: Class A All-Fuel also referred to as Low-Heat appliance type chimney per Uniform Mechanical Code: Chimney, low-heat appliance type is a factory built, masonry or metal chimney s.
When constructing a single wall smoke pipe, the following When constructing a single wall smoke pipe, the following When constructing a single wall smoke pipe, the following When constructing a single wall smoke pipe, the following When constructing a single wall smoke pipe, the following guidelines must be observed.
EXISTING FURNACE (if used) HOTBLAST FURNACE HOT AIR PLENUM 2" MIN. 1" MIN. 1" MIN. HOT AIR DUCT MINIMUM CLEARANCES TO COMBUSTIBLES (2.54 cm) 6' (182.
FUEL DOOR ILLUSTRATION ASH DOOR ILLUSTRATION LOCK WASHER HEX NUTS ASSEMBL ASSEMBL ASSEMBL ASSEMBL ASSEMBL Y INSTR Y INSTR Y INSTR Y INSTR Y INSTR UCTIONS UCTIONS UCTIONS UCTIONS UCTIONS COMBUSTION AIR COMBUSTION AIR COMBUSTION AIR COMBUSTION AIR COMBUSTION AIR All fires need air (specifically oxygen) to burn.
BRICK INSTALLATION BRICK INSTALLATION BRICK INSTALLATION BRICK INSTALLATION BRICK INSTALLATION (PRE-INSTALLED AT FACTORY) (PRE-INSTALLED AT FACTORY) (PRE-INSTALLED AT FACTORY) (PRE-INSTALLED AT FACTORY) (PRE-INSTALLED AT FACTORY) NOTE: Prior to operation, be sure to remove brick retaining strips.
1 1 1 1 1 2 2 2 2 2 3 3 3 3 3 ATTACHING SLIDE BAFFLE ROD EXTENSION ATTACHING SLIDE BAFFLE ROD EXTENSION ATTACHING SLIDE BAFFLE ROD EXTENSION ATTACHING SLIDE BAFFLE ROD EXTENSION ATTACHING SLIDE BAFFLE.
SPIN DRAFT CAP 1/2" X 2-1/2" CARRIAGE BOLT 1/2" LOCK NUT INSTALLING ASH DOOR SPIN DRAFT INSTALLING ASH DOOR SPIN DRAFT INSTALLING ASH DOOR SPIN DRAFT INSTALLING ASH DOOR SPIN DRAFT INSTALLING ASH DOOR SPIN DRAFT 1. Screw spin draft onto 1/2" x 2-1/2" carriage bolt.
WIRING DIAGRAM FOR SERIES INSTALLATION WITH EXISTING ELECTRIC FURNACE BLACK TO BE ADDED BLUE BLACK WHITE BLACK MAIN POWER 110 VOLT BLUE FROM LIMIT BLACK BLACK TO BE ADDED HOTBLAST LIMIT CONTROL MUST P.
WIRING DIAGRAM FOR SERIES INSTALLATION WITH EXISTING GAS OR OIL FURNACE LH POINTER (FAN OFF) 100 CENTER POINTER (FAN ON) 150 RH POINTER (LIMIT OPENS) 200 SAFETY STOP SETTING LIMIT CONTROL 50 150 100 2.
TESTING AND OPERA TESTING AND OPERA TESTING AND OPERA TESTING AND OPERA TESTING AND OPERA TING PR TING PR TING PR TING PR TING PR OCEDURES OCEDURES OCEDURES OCEDURES OCEDURES TESTING: TESTING: TESTING: TESTING: TESTING: 1.
! The furnace is designed to burn air dried wood and coal at a predetermined firing rate. Over firing could result in damage to the heat exchanger and cause dangerous operation. Over firing occurs when the ash door is left open during operation or a highly volatile fuel, i.
TR TR TR TR TR OUBLE SHOO OUBLE SHOO OUBLE SHOO OUBLE SHOO OUBLE SHOO TING AND PR TING AND PR TING AND PR TING AND PR TING AND PR OBLEM SOL OBLEM SOL OBLEM SOL OBLEM SOL OBLEM SOL VING VING VING VING VING 1. Problem: 1. Problem: 1. Problem: 1. Problem: 1.
P P P P P AR AR AR AR AR TS LIST TS LIST TS LIST TS LIST TS LIST MODEL 1600/1800 ITEM ITEM ITEM ITEM ITEM DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION PART# PART# PART# PART# PART# 26 T.
ITEM ITEM ITEM ITEM ITEM DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION MODEL MODEL MODEL MODEL MODEL PART# PART# PART# PART# PART# 11 Full Brick BOTH 89066 12 Full Brick 1600 23887 13 Sl.
MO MO MO MO MO T T T T T ORIZED NA ORIZED NA ORIZED NA ORIZED NA ORIZED NA TURAL DRAFT P TURAL DRAFT P TURAL DRAFT P TURAL DRAFT P TURAL DRAFT P AR AR AR AR AR TS LIST TS LIST TS LIST TS LIST TS LIST .
INST INST INST INST INST ALLA ALLA ALLA ALLA ALLA TION OF OPTIONAL EQ TION OF OPTIONAL EQ TION OF OPTIONAL EQ TION OF OPTIONAL EQ TION OF OPTIONAL EQ UIPMENT UIPMENT UIPMENT UIPMENT UIPMENT INSTALLING.
HO HO HO HO HO W W W W W T T T T T O ORDER REP O ORDER REP O ORDER REP O ORDER REP O ORDER REP AIR P AIR P AIR P AIR P AIR P AR AR AR AR AR TS TS TS TS TS THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU TO ORDER REPAIR PARTS CORRECTLY.
デバイスUnited States Stove 1800GCの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
United States Stove 1800GCをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはUnited States Stove 1800GCの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。United States Stove 1800GCの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。United States Stove 1800GCで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
United States Stove 1800GCを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はUnited States Stove 1800GCの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、United States Stove 1800GCに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちUnited States Stove 1800GCデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
