Velodyne AcousticsメーカーSC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICの使用説明書/サービス説明書
ページ先へ移動 of 26
SubContr actor ™ Series Amplifier / Sub w oofer s USER’S MANUAL SC-1250 Amplifier , SC-8, SC-10, SC-12, SC-15, SC-IW , SC-IF , SC-IC Subwoofers.
I . www .velodyne.com SubContractor User’s Manual Caution!.
II . www .velodyne.com SubContractor User’s Manual A ttention!.
III . www .velodyne.com SubContractor User’s Manual V orsicht!.
IV . www .velodyne.com SubContractor User’s Manual A ttenzione!.
V . www .velodyne.com SubContractor User’s Manual C ongratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Product Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Congratulations 1 . www .velodyne.com SubContractor User’s Manual C ongratulations on your purchase of a V elodyne SubContractor Series subwoofer . This system represents the state-of-the-ar t in low frequency reproduction. Read and follow the instructions below to insure safe and proper system operation.
2 . www .velodyne.com SubContractor User’s Manual SC-8, SC-10, SC-12, SC-15, SC-IW , SC-IF/IC Subwoofers S C-8: - 8” (6.5” piston diameter) subwoofer - 2.
S C-IF/SC-IC (In-Floor/In-Ceiling): - 12” (9.7” piston diameter) subwoofer - 3” high temperature inside/outside voice coil - Oversized spider for linearity at high excursion - High-excursion EPD.
4 . www .velodyne.com SubContractor User’s Manual ( 5) Low-Pass Crossover Use these up and down buttons to select the high-frequency range at which you wish to cut o ff the signal to the subwoofer . The frequency is indicated on the LED display briefly , then the display rever ts to showing the subwoofer’ s volume.
5 . www .velodyne.com SubContractor User’s Manual ( 9) Thru Jacks (See Figure 3A) These RCA connectors are for passing along the same signal that goes into your subwoofer t oa second “daisy-chained” subwoofer . The signal from these RCA connectors is the same as the input signal.
6 . www .velodyne.com SubContractor User’s Manual O ption 2 Figure 3B: Stereo Line-Level Connection..
7 . www .velodyne.com SubContractor User’s Manual ( 11) Balanced XLR LFE Input (See Figure 4) This XLR input jack receives the balanced LFE signal from your receiver or processor . Figure 4: Balanced Line-Level Connection. (12) Mic Input Connect the supplied micr ophone for the Auto-EQ featur e to this mini-jack.
8 . www .velodyne.com SubContractor User’s Manual ( 16) Auto ON/OFF Switch Use this switch to select between auto-on active and auto-on inactive (constant on) operation.
9 . www .velodyne.com SubContractor User’s Manual ( 18) Speaker Level Input T er minals (See Figure 5) Connect these input terminals to the speaker output terminals of your amplifier or receiver . I f you use this method of connection, when you go to the receiver speaker set up menu, make sure you select the “large” speaker option.
10 . www .velodyne.com SubContractor User’s Manual Y ou should set the crossover frequency to obtain a smooth and seamless transition from the subwoofer(s) to the main speakers in your system.
A Word About Subwoofer Placement Subwoofers operate at extremely low frequencies, which are primarily omni-directional. Keep in m ind that frequency response and output level can be drastically influenced by placement, depending on the acoustic proper ties of the listening room.
12 . www .velodyne.com SubContractor User’s Manual T his section addresses day-to-day usage of your SC-1250 amplifier . Remote Control The features of the SC-1250 remote control are listed below . • POWER — This button forces your SC-1250 unit into standby mode.
13 . www .velodyne.com SubContractor User’s Manual • PRESETS — T here are 4 presets, consisting of Movies, R&B – Rock, Jazz – Classical, and Games. As a preset is chosen, the preset is shown on the numeric LED as P1 for preset 1, P 2 for preset 2, etc.
14 . www .velodyne.com SubContractor User’s Manual E ach preset has its own characteristics with respect to subsonic filter , volume differential and a single equalizer (EQ) in order to optimize the listening mode for the preset.
15 . www .velodyne.com SubContractor User’s Manual TROUBLESHOOTING AND SERVICE B efore seeking ser vice for your amplifier or subwoofer , please re-check all systems. Following is a simple troubleshooting guide to assist you. 1. V erify that the unit is plugged in and power outlet used is active.
16 www .velodyne.com SubContractor User’s Manual Specifications.
17 . www .velodyne.com SubContractor User’s Manual Appendix A: RS-232 Serial Overview and Commands Introduction This document outlines V elodyne’ s SubContractor (SC) RS - 232 protocol specification. This protocol indicates how SC products receive run - time commands from devices such as Creston Universal Remote Controls.
18 . www .velodyne.com SubContractor User’s Manual R S232 Commands Activity Command Acceptable Example(s) Comments Format n V alues V olume Control #VOnn$, 00 – 80 #VO25$, Sets volume to a value, .
19 . www .velodyne.com SubContractor User’s Manual Other Velodyne Sub woofer Pr oducts: Digital Drive 18 12 Signature Edition DD Series DD-10 DD-12 DD-15 DD-18 DLS-R Series DLS - 3500R DLS - 3750R D.
20 . www .velodyne.com SubContractor User’s Manual V elodyne Acoustics, Inc. 345 Digital Drive Morgan Hill, CA 95037 408.465.2800 voice 408.779.9227 fax 408.779.9208 ser vice fax www .velodyne.com Ser vice E - mail: ser vice@velodyne.com Product E - mail: help@velodyne.
デバイスVelodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Velodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはVelodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Velodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Velodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Velodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はVelodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Velodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちVelodyne Acoustics SC-1250, SC-8, SC-10, SC-12, SC-15, SC-IW, SC-IF, SC-ICデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
