Weberメーカー42376の使用説明書/サービス説明書
ページ先へ移動 of 16
BUILT-IN LP SIDE BURNER INST ALLA TION/ OWNER'S GUIDE 42376 US 01/10/06 LP YOU MUST READ THIS O WNERS GUIDE BEF ORE OPERA TING YOUR G A S GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open fl ames. 3. Open lid.
2 DANGERS & W ARNINGS DANGER Failure to follow the Dangers, W arnings and Cautions contained in this Owner ’s Manual may result in serious bodily injury or death, or in a fi re or an explosion causing damage to property . W ARNINGS Do not store a spare or disconnected liquid propane cylinder under or near this barbecue.
3 STORA GE AND/ OR NONUSE • The gas must be turned of f at the liquid propane cylinder when the Weber ® gas barbecue is not in use. OPERA TING W ARNING: Only use this barbecue outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area.
4 L OCA TING YOUR BUIL T -IN SIDE BURNER When determining a suitable location for your Built-In Side Burner installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible.
5 MOUNTING THE SIDE BURNER Connect the corrugated gas line to the side burner valve located on the back right hand side of side burner . TEST CONNEC TIONS All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.
6 TYPICAL BULK PROP ANE GAS SUPPL Y INST ALLA TION We recommend that this installation be done by a LICENSED professional. General Specifi cations for Piping Note - Contact your local municipality for building codes regulating outdoor gas grill installations.
7 TYPICAL 20 LP PROP ANE GAS SUPPL Y INST ALLA TION We strongly recommend that you use the Summit ® Built-In T ank Cabinet (#21280) for installations using a 20 lb LP cylinder , mounted remotely in an “island” structure.
8 3). The minimum size of the ventilation hole (s) should not be less than 1/4 inch. d). The remote LP cylinder enclosure should be constructed with non- combustible materials.
9 GAS INSTRUC TIONS FILL LIQUID PROP ANE CYLINDER T o fi ll, take the liquid propane cylinder and fi ller adapter to an R V center or look up gas-propane in the phone book for other sources of liquid propane gas.
10 T o Connect the hose to the cylinder: 3) Remove the plastic dust cover from the valve. 4) Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only . Note: This connection tightens clockwise and will not allow gas to fl ow unless the connection is tight.
11 Check: 3) “T” Connection-to-Hose connections. 4) The hose-to-Regulator connection. W ARNING: If there is a leak at connections (2,3, or 4), turn OFF the gas. DO NOT OPERA TE THE GRILL. Contact Customer Service 1-800-446-1071. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water .
12 LIGHTING THE SIDE BURNER. 1) Open the side burner lid. 2) Check that the side burner valve is turned OFF . (Push knob in and turn clockwise to ensure that it in the off position.) W ARNING: The burner control knob must be in the OFF position before turning on the liquid propane cylinder valve.
13 CROSSOVER ® IGNITION S YSTEM OPERA TIONS If the Crossover ® ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover ® ignition system. • Check that both ignition wires(1,2) are attached properly .
14 PROBLEM CHECK CURE Side Burner does not light. Is gas supply off? T urn supply on. Flame is low in HIGH position. Is the fuel hose bent or kinked? Straighten hose. Is LP fuel low or empty? Refi ll LP cylinder . The excess fl ow safety device, which is part of the barbecue to cylinder connection, may have activated.
15 A TTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country . Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co.
©2003 The following trademarks are registered in the name of W eber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.
デバイスWeber 42376の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Weber 42376をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはWeber 42376の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Weber 42376の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Weber 42376で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Weber 42376を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はWeber 42376の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Weber 42376に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちWeber 42376デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。