Weberメーカー700 LXの使用説明書/サービス説明書
ページ先へ移動 of 36
W E B E R W E B E R Serial Number Please use this number in registering your warranty and any correspondence with the factory . Owner’ s Manual National Association PROPANE GAS ® SPIRIT ™ 700 LX Series LP Gas Barbecue W ARNING: Do not try to light this appliance without reading "Lighting" instructions section of this manual.
D ANGER Failure to f ollow the Dangers, W arnings and Cautions contained in this Owner’ s Manual may result in serious bodil y injury or death, or in a fire or an explosion causing damage to property . W ARNINGS Do not store a spare or disconnected LP tank under or near this barbecue.
3 Weber-Stephen Products Co. (W eber) hereby warrants to the ORIGINAL PURCHASER of this Weber Gas Barbecue that it will be free of defects in material and workmanship from the date of purchase as foll.
© 1999 Weber . Weber , , Flavorizer and Crossover are registered U.S. trademarks; Spirit, Gas Catcher , FlameCheck, and Spider Stopper are U.S. trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL 60067-6266. U.S.A. Weber Gas Barbecues are covered under the following patent nos.
5 Contents WARNINGS ................................................................ 2 W arranty & Patents .................................................. 3-4 General Instructions .................................................... 6 Assembly .
6 General Instructions Y our Weber Gas Barbecue is a portable outdoor cooking appliance. With the Weber Gas Barbecue you can grill, barbecue, roast and bake with results that are difficult to duplicate with indoor kitchen appliances. The closed lid and Flavorizer Bars produce that "outdoor" flavor in the food.
7 Step 1 Check package contents Cooking box (assembly) Lid (assembly) LP tank Bottom tray Cooking grates (2) LP tank filler adapter Control panel Assembl y T ools needed Hammer 7/16 inch open-end or an adjustable wrench Pliers Block of wood Phillips screwdriver Supplies needed Y our LP tank is shipped empty for safety .
Left frame Right frame Wheel frame Leg frame Frame connector Work table Swing table assembly Support rod Accessory racks (2) W arming rack Flavorizer Bars (5) T ank panel assembly Front panel Catch pa.
Plastic buttons (2) (actual size) 1/4-20 wing nuts (2) (actual size) 1/4 inch nylon washers (1 1) Hair pin cotters (2) Wheel hubcaps (2) 1/4-20 keps nut T wo Phillips screws/washers Check contents of .
10 Figure 1 W E B E R W E B E R Figure 2 Leg tabs Frame tabs (a) (b) Right frame Left frame Step 2 Assemble wheel frame Y ou will need: wheel frame, two wheels, two wheel hubcaps, hammer and a block of wood. Set one end of wheel frame on the block of wood (or other hard, protected surface).
11 Figure 3 Figure 4 Figure 5 View from rear of barbecue Dimples to the inside Fuel scale decal Plastic buttons Step 4 Continue frame assembly Y ou will need: leg frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.
Guide screw (a) (b) (c) Wing nuts View from behind cooking box Figure 8 12 Figure 6 Burner tubes Frame brace (a) (b) Spacer bracket Keps nut Ta b Frame cross piece Nylon washer Bolt Slide the cooking box to the left within the frame. Put the washer on the bolt.
Frame brace Manifold bracket 13 Figure 9 Figure 10 Figure 11 Frame connector Cross brace T ank panel tabs Slots in frame brace Frame brace Step 8 Install manifold bracket Y ou will need: manifold bracket Hook the bracket onto the manifold at the center burner valve.
14 Figure 12 View from front left View from front right F E F E Figure 13 Igniter lock nut Keyhole in frame brace Small part of keyhole in frame brace Frame brace Frame brace (a) (b) (c) Step 10 Add fuel scale assembly Y ou will need: fuel scale assembly , two 1/4-20 wing nuts and two nylon washers.
15 F E F E F E Figure 14 T ank lock wing nut (a) (b) Scale setting wing nut Step 12 Set LP fuel scale Y ou will need: LP tank (empty). Note - F or accuracy , the fuel scale must be set with an empty tank. We utilize various LP tank manufacturers. Some of the tanks we receive have differing top collar assemblies.
16 Figure 17 T urn so regulator vent does not collect water Hose T ank lock wing nut Quick disconnect engaged V alve handwheel close clockwise T ank valve Collar Male fitting Pressure relief valve T ank Regulator Regulator vent (a) (b) (c) Figure 16 Figure 15 F E Route the hose so it will not interfere with the scale indicator rod.
17 Figure 18 (a) Figure 19 (c) (d) (b) Step 16 Check for gas leaks D ANGER Do not use an open flame to chec k for gas leaks. Be sure there are no sparks or open flames in the area while y ou check for leaks. This will result in a fire or explosion whic h can cause serious bodily injury or death and damage to property .
18 Figure 20 Figure 21 Figure 23 Figure 22 Figure 24 Bottom tray Finger grip on front edge of bottom tray Finger grip Front side of catch pan holder Step 17 Install Flavorizer Bars and Cooking Grates Y ou will need: five Flavorizer Bars and two cooking grates.
19 Hair pin cotter Hinge pin Figure 25 Figure 26 T ool holders (a) (b) Step 19 Install Lid Y ou will need: lid, two hinge pins and two hair pin cotters. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside.
20 Slot in frame (view from below) Insert one end of the hinge rod into the hole in the frame. Figure 28 (a). Insert the other end into the hole in the swing table end bracket. Figure 28 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube.
21 Step 22 Complete accessory installation Y ou will need: work table, two accessory racks, warming rack, three tubing plugs and thermometer . Set the accessory rack across the bottom braces in front of the frame connector . Figure 29 (a). Set the second accessory rack across the bottom braces in the back of the frame connector .
22 1 3 2 4 7 6 5 8 Figure 1 Crosso ver Ignition System Lighting Summary lighting instructions are on the control panel. W ARNING: The burner contr ol knobs must be in the OFF position before turning on the LP tank v alve .
23 1 3 2 4 5 7 6 8 Figure 2 Manual Lighting Manual Lighting 4) Turn the tank on by turning the tank valve counterclockwise. 5) Strike a match and put the flame into the matchlight hole in the front of the cooking box. W ARNING: Do not lean o ver open barbecue .
24 Cooking W ARNING: Do not move the W eber Gas Barbecue when operating or hot. Y ou can adjust the FRONT , CENTER and BACK burners as desired. The control settings High (H), Medium (M), Low (L), or Off (O) are described in your W eber cookbook. The cookbook uses these notations to describe the settings of the FRONT , CENTER, and BACK burners.
25 Scale setting wing nut T ank lock wing nut T ank valve Collar (a) (b) Figure 3 Refilling the LP tank We recommend that you refill before the scale indicator reaches "E".
26 26 26 Figure 6 Male fitting Regulator Collar Quick disconnect engaged Figure 5 (a) (b) c) Connect the hose to the tank. Route the hose so it does not interfere with the scale indicator rod. Slide back the collar of the quick disconnect on the tank valve.
27 27 27 27 Safe handling tips f or LP Gas ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder , LP gas is a liquid. As the pressure is released the liquid readily vaporizes and becomes gas.
28 28 28 Figure 8 (b) (c) (d) (a) Check: c) V alves to manifold connections. Figure 8 (c). d) The hose to regulator connection. Figure 8 (d). W ARNING: If there is a leak at connections (b), (c) or (d), turn OFF the gas . DO NO T OPERA TE THE B ARBECUE.
29 29 29 Burner inside cooking box Figure 11 Dark blue Light blue T ips occasionally yellowish Figure 9 V enturi Air shutter V enturi fin Weber Spider Stopper Guard Figure 10 Flames Figure 12 Figure 1.
30 30 30 30 e) Remove the manifold bracket and unscrew the two wing nuts that hold the manifold to the cooking box. Pull the manifold and valve assembly out of the burners and carefully set it down.
31 i) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the V enturi fins. There should be no gaps in the seams or in the fit around the burners and valves.
32 32 Prob lem Burners b urn with a yellow or orange flame, in conjunction with the smell of gas. Burners do not light. -or - Burners ha ve a small flickering flame in the HIGH position. -or- Barbecue temperature only reaches 250˚ to 300˚ degrees in the HIGH position.
.
34 34 W E B E R W E B E R 6 1 2 3 4 5 7 9 12 11 10 15-16 23 24 17 26 27 28 29 31 32 33 34 52 53 44 50 48 47 46 45 44 42 41 40 54-55 51 49 30 25 11 35 43 13 14 22 39 38 37 36 57 56 19 18 20 21 8 ® ® .
35 35 1 Lid (assembly) 2 Lid handle 3 W arming rack 4 Flavorizer bars (5) 5 Cooking grates (2) 6 Work table 7 T ubing plugs (7) 8 1/4-20 x 2 inch bolt 9 Spacer bracket 10 Swing table end bracket 1 1 L.
A F INAL W ORD OF T HANKS hank you for choosing a W eber Barbecue. Our family here at W eber has worked hard to produce the highest quality products for your satisfaction.
デバイスWeber 700 LXの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Weber 700 LXをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはWeber 700 LXの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Weber 700 LXの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Weber 700 LXで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Weber 700 LXを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はWeber 700 LXの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Weber 700 LXに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちWeber 700 LXデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
