WeberメーカーLP Gas Barbecueの使用説明書/サービス説明書
ページ先へ移動 of 36
W E B E R W E B E R Serial Number Please use this number in registering your warranty and any correspondence with the factory . Owner’ s Manual W ARNING: Do not try to light this appliance without reading "Lighting" instructions section of this manual.
D ANGER Failure to f ollow the Dangers, W arnings and Cautions contained in this Owner’ s Manual may result in serious bodil y injury or death, or in a fire or an explosion causing damage to property . W ARNINGS Do not store a spare or disconnected LP tank under or near this barbecue .
3 Weber-Stephen Products Co. (W eber) hereby warrants to the ORIGINAL PURCHASER of this Weber Gas Barbecue that it will be free of defects in material and workmanship from the date of purchase as foll.
© 1997 Weber . Weber , , Genesis, Flavorizer and Crossover are registered U.S. trademarks; Perma-Mount, Gas Catcher , FlameCheck, Steam-N-Chips, Spider Stopper , and W arm-Up are U.S. trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL 60067-6266.
5 Contents WARNINGS ................................................................ 2 W arranty & Patents .................................................. 3-4 General Instructions .................................................... 6 Assembly .
6 General Instructions Y our Weber Gas Barbecue is a portable outdoor cooking appliance. With the Weber Gas Barbecue you can grill, barbecue, roast and bake with results that are difficult to duplicate with indoor kitchen appliances. The closed lid and Flavorizer Bars produce that "outdoor" flavor in the food.
7 Step 1 Check package contents Cooking box (assembly) Lid (assembly) LP tank LP tank filler adapter Bottom tray T wo cooking grates Control panel Assembl y T ools needed Regular screwdriver Phillips screwdriver Hammer 7/16 inch open-end or an adjustable wrench Pliers Block of wood Supplies needed Y our LP tank is shipped empty for safety .
Left frame Right frame Wheel frame Caster frame T wo frame connectors Work table Swing table assembly Support rod Axle T wo accessory trays W arming rack W arm-Up Basket Five long Flavorizer Bars Eigh.
T wo plastic buttons (actual size) 1/4-20 keps nut T wo 1/4-20 wing nuts (actual size) Eighteen 1/4 inch nylon washers T wo hair pin cotters T wo wheel hubcaps T wo Phillips screws/washers Check conte.
10 Figure 1 W E B E R W E B E R Figure 2 Leg tabs Frame tabs (a) (b) Right frame Left frame Step 2 Assemble wheels Y ou will need: axle, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood. Place one end of the axle on the block of wood (or other protected surface).
11 Figure 3 Dimples to the inside Fuel scale decal Figure 4 Step 4 Continue frame assembly Y ou will need: caster frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Place the caster frame onto the tabs of the left frame with the dimple to the inside.
12 Figure 7 Burner tubes Frame brace Figure 6 View from rear of barbecue Plastic buttons (a) (b) Spacer bracket Keps nut Ta b Frame cross piece Nylon washer Bolt Slide the cooking box to the left within the frame.
13 Guide screw (a) (b) (c) Wing nuts View from behind cooking box Figure 9 Y our Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment: a) Do the valves fit into the ends of the burners? Figure 9 (a).
14 Figure 13 View from front left View from front right F E F E Figure 11 Figure 12 Cross brace T ank panel tabs Slots in frame brace Frame brace Step 10 Install tank panel assembly Y ou will need: tank panel assembly , 1/4-20 x 1 1/4 inch bolt, 1/4-20 hex nut, nylon washer and a 7/16 inch wrench.
15 Figure 14 Igniter lock nut Keyhole in frame brace Small part of keyhole in frame brace Frame brace Frame brace (a) (b) (c) Step 12 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter . This was done to f actory test the ignition system.
16 Figure 16 T ank lock wing nut Figure 17 F E Step 14 Fill LP tank Note - The LP tank manuf acturer is responsible f or the materials, workmanship and performance of the tank. If the tank has a def ect, malfunctions, or you ha ve a question regarding the tank, call the tank manuf acturer's customer ser vice center .
17 Figure 18 T urn so regulator vent does not collect water Hose Quick disconnect engaged V alve handwheel close clockwise T ank valve Collar Male fitting Pressure relief valve T ank Regulator Regulator vent (a) (b) (c) Route the hose so it will not interfere with the scale indicator rod.
18 (a) Figure 20 (c) (d) (b) Figure 21 Figure 22 Check: a) Hose to manifold connection. Figure 20 (a). b) Regulator to tank connection. Figure 20 (b). W ARNING: : If there is a leak at connection (a) , retighten the fitting with a wrench and rechec k for leaks with soap and water solution.
19 Figure 24 Figure 23 Figure 25 Bottom tray Finger grip on front edge of bottom tray Finger grip Front side of catch pan holder Step 19 Install the bottom tray Y ou will need: bottom tray , catch pan holder , catch pan and one drip pan. Hook the ends of the catch pan holder into the hole in the bottom tray .
20 Figure 28 Insert in frame brace Control panel Phillips screws/ washers (a) (b) Step 22 Add control panel and burner control knobs Y ou will need: control panel, two Phillips screws/washers, a Phillips screwdriver , and three burner control knobs. Set the control panel in place over both frame braces.
21 Slot in frame (view from below) Insert one end of the hinge rod into the hole in the frame. Figure 30 (a). Insert the other end into the hole in the swing table end bracket. Figure 30 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube.
22 Step 24 Complete accessory installation Y ou will need: W arm- Up B asket, warming rack, work table, accessory rack, three tubing plugs, thermometer and a hammer . Insert one end of the Weber W arm-Up Basket into the hole in the right end of the lid and the other end into the slot in the left end of the lid.
.
24 8 6 2 4 3 1 7 5 Figure 2 Manual Lighting Manual Lighting 4) Turn the tank on by turning the tank valve counterclockwise. 5) Strike a match and put the flame into the matchlight hole in the front of the cooking box. W ARNING: Do not lean over open barbecue.
25 Cooking W ARNING: Do not move the W eber Gas Barbecue when operating or hot. Y ou can adjust the FRONT , CENTER and BACK burners as desired. The control settings High (H), Medium (M), Low (L), or Off (O) are described in your Weber cookbook. The cookbook uses these notations to describe the settings of the FRONT , CENTER, and BACK burners.
26 Scale setting wing nut T ank lock wing nut T ank valve Collar (a) (b) Figure 3 Figure 4 Refilling the LP tank We recommend that you refill before the scale indicator reaches "E".
27 Figure 6 Male fitting Regulator Collar Quick disconnect engaged Figure 5 (a) (b) c) Connect the hose to the tank. Route the hose so it does not interfere with the scale indicator rod. Slide back the collar of the quick disconnect on the tank valve.
28 28 Safe handling tips f or LP Gas ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder , LP gas is a liquid. As the pressure is released the liquid readily vaporizes and becomes gas.
29 Figure 8 (b) (c) (d) (a) c) V alves to manifold connections. Figure 7 (c). d) The hose to regulator connection. Figure 7 (d). W ARNING: If there is a leak at connection (b), (c) or (d), turn OFF the gas . DO NO T OPERA TE THE B ARBECUE. Contact W eber-Stephen Customer Service .
30 Burner inside cooking box Figure 11 Dark blue Light blue T ips occasionally yellowish Figure 9 V enturi Air shutter V enturi fin Weber Spider Stopper Guard Figure 10 Figure 12 Figure 13 General Maintenance W eber Spider Stopper Guards Y our Weber Gas Barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects.
31 e) Remove the manifold bracket and unscrew the two wing nuts that hold the manifold to the cooking box. Pull the manifold and valve assembly out of the burners and carefully set it down. Figure 15. f) Slide the burner assembly out from under the guide screw and washer in the corners of the cooking box.
32 i) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the V enturi fins. There should be no gaps in the seams or in the fit around the burners and valves.
33 Prob lem Burners b urn with a yellow or orange flame, in conjunction with the smell of gas. Burners do not light. -or - Burners ha ve a small flickering flame in the HIGH position. -or - Barbecue temperature only reaches 250˚ to 300˚ degrees in the HIGH position.
34 W E B E R W E B E R 4 1 2 3 7 8 9 11 10 15-16 24 25 17 29 31 32 33 35 61 62 57 58 56 54 52 51 50 49 48 46 45 44 43 59-60 55 53 30 36 37 47 12 14 13 18 19 23 6 5 28 27 26 34 22 11,16 20-21, 11 41 42.
35 1 Left endcap 2 Shroud assembly 3 Lid handle 4 W arm-Up Basket 5 W arming rack 6 Short Flavorizer bars (8) 7 Long Flavorizer bars (5) 8 Cooking grates (2) 9 Work table 10 T ubing plugs (5) 1 1 1/4-.
A F INAL W ORD OF T HANKS hank you for choosing a W eber Barbecue. Our family her e at W eber has worked har d to produce the highest quality products for your satisfaction. While we give much attention to our products, an occasional error may occur .
デバイスWeber LP Gas Barbecueの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Weber LP Gas Barbecueをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはWeber LP Gas Barbecueの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Weber LP Gas Barbecueの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Weber LP Gas Barbecueで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Weber LP Gas Barbecueを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はWeber LP Gas Barbecueの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Weber LP Gas Barbecueに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちWeber LP Gas Barbecueデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
