WesloメーカーWLTL19507.0の使用説明書/サービス説明書
ページ先へ移動 of 28
USER'S MANUAL Serial Number Decal Model No. WLTL19507.0 Serial No. CAUTION Read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. QUESTIONS? As a manufacturer, we are com- mitted to providing complete cus- tomer satisfaction.
T ABLE OF CONTENTS WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 1. Before beginning any exercise program, con- sult your physician. This is especially impor- tant for persons over the age of 35 or persons with pre-existing health problems. 2. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions.
4 20. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 16.) You must be able to safely lift 45 lbs. (20 kg) t o raise, lower, or move the treadmill.
5 Thank you for selecting the new WESLO ® 225 GTX treadmill. The 225 GTX treadmill combines advanced technology with innovative design to make your work- outs at home more effective and enjoyable. And w hen y ou’re not exercising, the 225 G TX tre admil l can be folded up, requiring less than half the floor space of other treadmills.
6 ASSEMBL Y T o hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed.
7 2. Slide the two Wheel Housings (62) onto the Base (52) with the head of the M10 x 62m m Bolts (35) on the out- side as shown. Attach each Wheel Housing with two M6 x 58m m Bolts (6), two M6 Washers (11), and two M6 Nuts (15). 2 52 6 11 62 15 11 6 62 35 35 15 1.
8 3. With the help of a second person, ra is e t he Up rig hts (53, 54) so the Base (52) is flat on the floor as shown. N ext, position the front of the treadmill Frame (51) be- tween the Upr ig hts. See the inset drawing. Locate the wire inside of the lower end of the Right Upright (54).
9 6. Hold the Console (91) near the Right Upright (54 ). Touch the Right Handrail to discharge any static. Insert the end of the Wire Harness (98) into the hole in the bottom of the Right Handrail (55) and out of the large hole in the side. Next, Insert the end of the Wire Harness through the two looped plastic ties.
9. Carefully lower the Handrails (55, 56) to the floor. Center the Frame (51) between the Handrails, and tighten the four M10 x 58mm Bolts (2) (see step 1). Then, raise the Handrails back to the vertical position. See the inset drawing. A ttach the Latch Assembly (50) to the Left Upright (53) with two M4.
1 1 OPERA TION AND ADJUSTMENT T HE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high- performance lubricant. IMPORTANT: Never apply sil- icone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear.
12 FEATURES OF THE CONSOLE The treadmill console offers a selection of features designed to make your workouts more effective. When the manual mode of the console is selected, the speed of the treadmill can be changed with the touch o fa button. As you exercise, the displays will provide continuous exercise feedback.
13 HOW TO TURN ON THE POWER I MPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- p erature before turning on the power. If you do not do this, the console displays or other electrical components may become damaged.
The lower right dis- play —The lower right d isplay can show the speed of the walking b elt and the approxi- mate number of calories that you have burned.
15 If the speed setting is too high or too low during the workout, you can manually override the setting by p ressing the Faster and Slower buttons. H owever, when the current segment of the workout ends, t he treadmill will automatically adjust to the speed setting for the next segment.
16 HOW T O FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE U nplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill. 1. Hold the metal frame firmly in the location shown by the arrow at the right.
HOW TO LOWER THE TREADMILL FOR USE 1. Hold the upper end of the treadmill with your right hand as shown. Using your left hand, pull the latch knob to the left and hold it. Next, lower the frame until it is past the latch pin. Then, slowly release the latch knob.
18 TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on SOLUTION: a.
19 PROBLEM: The walking belt slows when walked on S OLUTION: a . Use only a single-outlet surge suppressor that meets all the specifications described on page 11. b . If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged.
20 These guidelines will help you to plan your exercise program. For detailed exercise information, obtain a reputable book or consult your physician. Remember, proper nutrition and adequate rest are essential for successful results.
SUGGESTED STRETCHES T he correct form for several basic stretches is shown at the right. Move slowly as you stretch—never bounce. 1 . Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible.
P ART LIST—Model No. WL TL19507.0 R 0807A Key No. Qty. Description Key No. Qty. Description 1 2 M10 x 110mm Bolt 2 4 M10 x 58mm Bolt 3 4 M8 x 70mm Bolt 4 4 M4.2 x 19mm Screw 5 2 M5 x 16mm Screw 6 4 M6 x 58mm Bolt 7 6 M4.2 x 16mm Screw 8 1 Rear Roller 9 2 M10 Star Washer 10 4 M8 Star Washer 11 4 M6 Washer 12 2 M5 Star Washer 13 4 M8.
95 1 Front Roller/Pulley 96 1 Motor Belt 9 7 1 Reed Switch 98 1 Wire Harness 9 9 1 Magnet 100 1 Walking Platform 101 1 Walking Belt * – 4" Red Wire, M/F * – 4" Blue Wire, 2F * – 10" Blue Wire, 2F * – User’s Manual *These parts are not illustrated.
78 17 81 100 51 27 101 67 28 99 97 21 83 78 94 45 45 29 31 46 25 21 21 25 25 25 25 29 25 25 96 25 77 77 41 64 41 95 68 61 60 37 22 28 18 46 19 8 37 37 69 40 32 46 43 43 69 40 46 32 43 43 42 19 42 27 41 46 33 33 64 1 36 36 82 77 41 77 41 33 33 74 74 EXPLODED DRA WING A—Model No.
EXPLODED DRA WING B—Model No. WL TL19507.0 R 0807A 34 38 44 79 34 30 59 38 57 87 21 21 21 42 42 85 66 84 24 20 41 41 20 20 21 58 39 39 49 20 88 41 41 24 20 65 47 47 47 47 47 89 73 72 21 90 25.
54 52 35 70 35 16 23 53 14 1 9 98 1 23 14 9 63 26 75 3 63 26 63 26 26 63 7 50 71 71 16 70 71 71 63 26 98 75 76 56 76 55 76 41 41 41 92 48 3 4 5 6 10 10 10 10 3 3 11 6 12 13 13 13 13 15 26 63 62 62 5 12 48 4 11 15 16 16 2 2 11 15 15 11 76 14 14 EXPLODED DRA WING C—Model No.
86 93 7 7 7 7 91 80 21 21 EXPLODED DRA WING D—Model No. WL TL19507.0 R 0807A 27.
Part No. 255854 R0807A Printed in China © 2007 ICON IP, Inc. ORDERING REPLACEMENT P ARTS To order replacement parts, please see the front cover of this manual.
デバイスWeslo WLTL19507.0の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Weslo WLTL19507.0をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはWeslo WLTL19507.0の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Weslo WLTL19507.0の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Weslo WLTL19507.0で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Weslo WLTL19507.0を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はWeslo WLTL19507.0の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Weslo WLTL19507.0に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちWeslo WLTL19507.0デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
