WinegardメーカーTN-2303の使用説明書/サービス説明書
ページ先へ移動 of 18
Ver. 1.5 4/21/2009 - 1 - TravelNet Data/Voice Cellular Router Installation Guide ATTENTION INSTALLER Parts List: • TravelNet Da ta/Voice Cellular Route rs ( Models TN-2301/T N-2303/TN-2305) • Gree.
Ver. 1.5 4/21/2009 - 2 - TravelNet’s Cellular Router System is Preconfigured And Ready to Install with these Easy Steps Installa tion Instructions: ( Models TN-23 01/TN-2303/TN-2305 ) 1. Install the T ravelNet Rout er and Edimax Rout er equipment in a convenient place such as uppe r cabinet (Velcro works well on the base of the each unit).
Ver. 1.5 4/21/2009 - 3 - Position the a ntennas near the cable entry point. Here the TravelNet unit was located in the front overhead (Figure 1) with the antenn as mounted close by on the roof. Figure 2 Note that the antenna mount s are anchored to t he 7” x 7” aluminum ground plane and that e verything is well sealed.
Ver. 1.5 4/21/2009 - 4 - mounts securely to the ground p lane and coach roof as shown. Secure the antenna cable to the roof as shown. Figure 4 4. Route the 2 antenna cab les to the cable entry hole in the coach roof.
Ver. 1.5 4/21/2009 - 5 - Setup the Tr a velNet Data/Voi ce Ter minal Setting up your Car rier Account. Your TravelNet-DV requires both a data plan for internet service and a voice plan for analog phone service. Locate t he “Account Application” (yel low sheet) in the “End User Env elope”.
Ver. 1.5 4/21/2009 - 6 - 1. Remove Battery Compartment Door on the bottom of the unit. Figure 7 2. Installing the AT&T SIM (Sprint and Verizon users skip to Step 3) Figure 8 Install the SIM Ca rd into the SI M card holder in the batt ery compartment.
Ver. 1.5 4/21/2009 - 7 - 3. Install the Battery & Secure the compartment door. Install the Rechargeable Battery Pack into the battery compartment. Remove the battery compartment door, insert the battery connector into the battery terminal, arrange the battery pack in the compartment, and replace the battery compartment door.
Ver. 1.5 4/21/2009 - 8 - Connect Ethe rnet cable to the Ethernet port on the T ravelNet Network Port (as shown) and to the Edimax W AN port (as shown) Antenna ca bles not shown fo r clarity. Figure 1 2 6. Attach Phone Cable Connect an RJ-11 Phone cable fr om a standard phone to the Phone input (J1 Figure 1 3 7.
Ver. 1.5 4/21/2009 - 9 - 8. Turn on Cell Router Power using switch. Figure 1 4 9. Understanding the LED Lights Figure 1 5 Note : LED’s are tricolored, Green, Amber and Red and this corresponds to the background colors of the table below.
Ver. 1.5 4/21/2009 - 10 - TravelNet Data/V oice (TN-2303) Termin al Setup A cti vate your Sprint TravelNet Data/Voice on the Sprint Network Your TravelNet Data/Voice requires a data plan for internet and a voice plan to hook up the analog phon e. Locate the “Account Application” (yell ow sheet) in the “End User Envelope ”.
Ver. 1.5 4/21/2009 - 11 - Figure 17 1. When all devices are connected an d powered on, use your compute r to connect to the Trav elNet Device Manager . • Launch your W eb browser (Internet Expl orer or Firefox). • Go to the browser’s address bar, ty pe http://192.
Ver. 1.5 4/21/2009 - 12 - Figure 19 • Proceed to Set Up a Wireless WA N Data Connection . TIP : Bookm ark the T ravelNet Device M anager access page ( http: //192.
Ver. 1.5 4/21/2009 - 13 - 5. Click Setup, click W ire less WAN in the Setup m enu. 6. PSD Auto Connect select Alwa y s On 7. Do a hard restart of all ne twork devices in order, f irst the TravelNet Ce llular Router, 2 nd the W iFi Router, and finally laptop.
Ver. 1.5 4/21/2009 - 14 - NOTE; Do not touch the gold-colored areas of your SIM Card. Figure 2 0 2. Install the Rechargeable Ba ttery Pack into the ba ttery compartment . (Fig. 20 above) • _ W ith t he battery compartm ent door open, in sert the battery connec tor into the battery term inal.
Ver. 1.5 4/21/2009 - 15 - • _ In a vehicle environment, groundin g to the frame and bat tery or alternato r can reduce static or buzzing during voice c alls.
Ver. 1.5 4/21/2009 - 16 - Figure 23 WEP Key Set up Parameters Default De scription Key Length 64-bit You can select the WEP key length for encryption, 64-bit or 128-bit.
Ver. 1.5 4/21/2009 - 17 - Use the following proced ure to configure Wi ndows XP with SP 2 for your infrastructure mode wireless network when the wireless networ k adapter supports W ireless Auto Configuration: 1.
Ver. 1.5 4/21/2009 - 18 - 1. Open Connect to a Netw ork by clicking the Start but ton , and then clicking Connect to . 2. In the Show list , click Wireless .
デバイスWinegard TN-2303の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Winegard TN-2303をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはWinegard TN-2303の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Winegard TN-2303の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Winegard TN-2303で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Winegard TN-2303を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はWinegard TN-2303の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Winegard TN-2303に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちWinegard TN-2303デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
