YeomanメーカーYM-CKWDWH-Lの使用説明書/サービス説明書
ページ先へ移動 of 20
Solid Fuel Cooker INST ALLA TION & OPERA TING INSTRUCTIONS Models YM-CKWDWH-R / YM-CKWDBL-R YM-CKWDGR-R / YM-CKWDPB-R / YM-CKWDWH-L YM-CKWDBL-L / YM-CKWDGR-L / YM-CKWDPB-L F or use in Great Britain and Eire This product is suitable for use in the stated countries.
2 Commissioning Data 3 T echnical Specification 4 SITE REQUIREMENTS Solid Fuel Cooker Dimensions 5 Hearth Dimensions 5 Walls adjacent to Hearths 5 PRE-INST ALLA TION CHECKS Flue or Chimney 7 Additiona.
3 FOR YOUR RECORDS YEOMAN DEALER APPLIANCE W AS PURCHASED FROM Name: ......................................................................................................................................................................................
TECHNICAL SPECIFICA TION Model 3 Solid fuel cooker Nominal heat output All fuels KW 7.5 Flue draught @ nominal heat output All fuels m m Wg 1.00 inch Wg 0.
5 SOLID FUEL COOKER DIMENSIONS (Right hand cooker shown) Additional information covering the installation the Solid fuel cooker may be found in the following British Standard: BS8303. Before installation of this product please read these instructions fully .
6 SITE REQUIREMENTS HEARTH DIMENSIONS The appliance must stand on a constructional hearth with the minimum dimensions as shown in diagram below . If you are fitting the appliance into an existing hearth setting check that it complies with the current construction regulations and is the minimum sizes shown.
SITE REQUIREMENTS 7 Location of hearth or Solid fuel cooker Solid, non combustible material Thickness (W) height (A) Where the hearth abuts a wall and the solid fuel cooker is not more than 50mm from .
8 I t is important that adequate ventilation exists and the Flue or C himney system that is to be used is in good working condition. Products of combustion that enter the room could be a serious health risk.
9 Model Solid fuel cooker Additional ventilation mm 2 1375 cm 2 13.75 sq. inch 2.125 2.2 Extractor fans or cooker hoods should not be placed in the same room or space as the appliance. 2.3 If any of these checks reveal problems do not proceed with the fitting of the appliance until they have been rectified.
10 1.5 Decide it the installation is to be top, rear or side flue exit, and fit and seal, with fire cement, the flue collar and blanking plate to suit. The flue collar attaches to the cooker backplate or top plate with fixings supplied. The blanking plates are fixed to the unused flue outlets with fixings supplied.
11 1 .15 Connect a flue pipe 612mm long (Stovax part no 4501 ( 5” pipe)) by inserting it into the flue spigot and sealing using fire cement. 2. COMMISSIONING 2.1 Before lighting the Solid fuel cooker , check the following items: a ) Fit of internal parts (firegrate, firebricks, baffles, a nd log retainer).
INST ALLA TION INSTRUCTIONS 12 2.9 Record serial number in user instructions . This number will be required when ordering spare parts and making warranty claims.
USER INSTRUCTIONS 13 1. GENERAL 1 .1 This cook er is designed for domestic use and should only be used for this purpose, and in accordance with the manufacturers operating instructions.
USER INSTRUCTIONS 14 3 .3 During this time the cooker may give off some u npleasant odours, and we recommend that you keep the room well ventilated during this period to avoid a build-up of fumes. 4. BURNING WOOD 4.1 Open the air control to maximum . 4.
USER INSTRUCTIONS 15 5 .5 As the fire becomes established adjust the a ir control t o g ive the oven temperature you require. 5.6 Close flue by-pass control. 5.7 Before re -fuelling the cooker it is advisable to first de- ash the firebed, using the riddling grate system or a suitable poker .
USER INSTRUCTIONS 16 9.2 De -ash the firebed using the operating tool to riddle the grate and clear ash. 9.3 As heat can remain in the ash for a long period after use care must be taken when removing and carrying the full ashpan. W e suggest that the ashpan be carried using gloved hands, or the ash is placed directly in to a Stovax ash caddie.
MAINTENANCE and SER VICING 17 1. GENERAL CLEANING 1 .1 W e would recommend that your Solid fuel cook er be cleaned fully on a regular basis, according to the level of use. A ttention should be given to cleaning the flueways and removing ash. Regular cleaning and preventive maintenance will help give many years of safe use.
MAINTENANCE and SER VICING 18 4 .9 Lightly oil the door catch mechanism and hinge pins. A void getting oil on to the door seals, glass and enamel. 4.10 T o refresh painted finishes it is possible to re -paint using Stovax Thermolac paint. 4.11 Use only genuine Stovax replacement parts to keep your appliance in safe and efficient working order .
NOTES 19.
YEOMAN STOVES A division of Stovax Ltd F alcon Road, Sowton Industrial Estate, Exeter , EX2 7LF T el 01392 . 474500 F ax 01392 . 219932 www .yeoman- stoves.
デバイスYeoman YM-CKWDWH-Lの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Yeoman YM-CKWDWH-Lをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはYeoman YM-CKWDWH-Lの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Yeoman YM-CKWDWH-Lの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Yeoman YM-CKWDWH-Lで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Yeoman YM-CKWDWH-Lを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はYeoman YM-CKWDWH-Lの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Yeoman YM-CKWDWH-Lに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちYeoman YM-CKWDWH-Lデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
