ZephyrメーカーESL-M90ASの使用説明書/サービス説明書
ページ先へ移動 of 23
JAN06.0101.
2 PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING . INST AL LA TION MUST COMPL Y WITH ALL LOCAL CODES. IMP ORT ANT : Save these Instructions for the Local Electrical Inspector s use. INS T ALLER: Please leave these Instructions with this unit for the owner .
3 www .zephyronline.com T able of Content s Import ant safet y Notice ..................................................................... 4 Electrical & Installa tion requir ements ............................................. 5 Electrical requirements .
4 Import ant safety Notice CAUTION: FOR GENERAL VENTILA TING USE ONL Y . DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MA TERIALS OR VA P O R S . W ARNING T O REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, O R INJURY T O PERSONS, OBSER VE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer .
5 www .zephyronline.com Electrical & Inst allation requirement s ELECTRICAL REQUIREMENTS Important: Observe all governing codes and ordinances. It is the customers responsibility: T o co nt act a qualified electrical inst all er .
6 List of Materials PARTS SUPPLIED: Blower unit housing Hood canopy Met al filter x 1 Halogen light bulb x 2 Duct covers Remote Control Duct Cover support bracket (3 pieces.
7 www .zephyronline.com 1/2" 2"min 8" 7/16* Side Cabinet Side Cabinet 35" 7/16 min. cabinets opening wid ths 24" to 32" bottom of canopy to cooking surface ceiling Center.
8 Ducting version Non-vented (recirculating) version B B B Pipe Pipe Pipe F-H- G Inst allation Instructions Closely follow the instructions set out in this manual. All responsibility , for any eventu al inc onve nien ces, damage s or fires caused by not comp lyin g with the instru ctio ns in this manual, is declined.
9 www .zephyronline.com Inst allation - Ductwork Calculation Sheet 3 1/4 x 10 Rect., straight 6 Round,, straight 7", 8 Round,, straight 3 1/4 x 10 Rect.90° elbow 3 1/4 x 10 Rect.45° elbow 3 1/4 x 10 Rect.90° flat elbow 3 1/4 x 10 Rect.
10 Inst allation Assembling the duct cover support bracket (3 pa r t s ) : The three par t s should be fixed with 4 screws, the support extension is a djustable and should correspond to the internal width of the upper duct cover . = = X Duct cover support bracket X Upper Duct cover 1.
11 www .zephyronline.com 10. Determine the required height for the conduit and cut a 1-1/4" (3.2 cm) hole at this location. Run wires through hole according the National Electrical Code or CSA S t andards and local codes and ordinances.
12 d. Fasten the hood to the motor unit using 6 screws from the bottom (release the grease filter to access fixing points. 15. Hang hood with the 2 mounting hooks. W ARNING Excessive Weight Hazard - Use two or more people to move and install range hood.
13 www .zephyronline.com 19. Electrical connection W ARNING Electrical Shock Hazard W arning: T urn off power circuit at the service panel before wiring this unit.
14 Inst allation 22. Install duct cover with 2 screws first on duct cover support bracket, then slide the duct lower section towards the bottom. 23. Fit co ntrol bal l wi th it s m olex plug on its housing and twist in place. a 15 ° OK! b c 24. Perform connection between plates from control ball and from electronic box.
15 www .zephyronline.com Description of the hood 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp (position and nr . of lamps m ay v ary ) 5 Hood canopy 6 Duct cover 7 Air.
16 Description of the hood - Control Ball CONTROLS Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to l eave in operation during cooking and for another 15 minutes approximately after terminating cooking.
17 www .zephyronline.com Description of the hood - Remote Control USING THE REMOTE CONTROL This device complies with p art 15 of the FCC Rules. Operation is subject to the following two conditions: (1.
18 Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply . CLEANING The cooker hood should be cleaned regularly internally and externally . For cleaning use a cloth moistened with a neutral liquid detergents.
19 www .zephyronline.com T rouble Shooting Af ter inst allation, the unit doesnt work? Light works, but motor is not turning. The unit is vibrating. The motor is working, but the light s are not. The hood is not venting out properly . Met al filter is vibrating.
20 W arranty T O O BT AIN SERVICE UNDER W ARRANTY : or any Service Related Questions, please call: 1-888-880-8368 S taple your receipt here. Proof of the original purchase date is needed to obtain ser vic e under the warranty . T O O B T AIN SERVICE UNDER W ARRANTY : Y ou must present proof of original purchase date.
21 www .zephyronline.com List of Part s and Accessories Part Description Part# Part Description Part# Ductless Recirculating Kit charcoal replacement filter duct cover extension kit internal blower - .
22.
23 www .zephyronline.com.
デバイスZephyr ESL-M90ASの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Zephyr ESL-M90ASをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはZephyr ESL-M90ASの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Zephyr ESL-M90ASの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Zephyr ESL-M90ASで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Zephyr ESL-M90ASを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はZephyr ESL-M90ASの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Zephyr ESL-M90ASに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちZephyr ESL-M90ASデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。