Brinkmannメーカー2610 Seriesの使用説明書/サービス説明書
ページ先へ移動 of 32
OFF HIGH LOW OFF HIGH LOW OFF HIGH LOW OFF HIGH LOW MAXIMUM SIDE BURNER LOAD = 15 lbs. 1. Read and follow all warnings and instructions in owner’s manual before lighting. 2. Open lid before lighting burner. 3. Make sure all control knobs are in the OFF position.
WE W ANT Y OU T O ASSEMBLE AND USE Y OUR GRILL AS SAFEL Y AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS T O A TTRA CT Y OUR A TTENTION T O POSSIBLE HAZARDS AS Y OU ASSEMBLE AND USE Y OUR GRILL.
2 W ARNING • Never use natural gas in a unit designed f or liquid propane gas. • Never use c harcoal briquets or lighter fluid in a gas grill. • Leak test all connections before fir st use, e ven if grill was pur c hased full y assemb led and after each tank refill.
CYLINDER SPECIFICA TIONS: When purchasing or e xchanging a cylinder for y our gas grill, it must be constr ucted and marked in accordance with the specifications f or LP gas cylinders of the U.
4 The cylinder must also be equipped with: • A shut-off v alve terminating in a T ype 1 gas cylinder valv e outlet. • A T ype 1 v alve that pre vents gas flo w until a positive seal is obtained. • An arrangement f or vapor withdr awal. • A collar to protect the cylinder shut-off v alve.
W ARNING FILLING THE LP GAS CYLINDER: • Allow onl y qualified LP gas dealers to properl y fill or repair your LP gas cylinder . • New tanks should be pur g ed prior to filling; inform LP gas dealer if y ou are using a new tank. • DO NO T allow the cylinder to be filled be yond 80% capacity .
6 W ARNING • Never use y our grill without leak testing all gas connections and hoses. See the section on "Leak T esting" in this manual for pr oper procedures. The pressure regulator and hose assembl y supplied with your gas grill is designed to work with an LP gas supply c ylinder .
LEAK TESTING: T o prevent fire or explosion hazar d: • DO NO T smoke or permit ignition sources in the area while conducting a leak test. • P erform test OUTDOORS only in a well ventilated area. • Never perf orm a leak test with a match or open flame.
W ARNING 8 6. Check each place listed (A -K) f or growing b ubbles which indicates a leak. 7. T ur n OFF gas supply at cylinder valv e. 8. T ur n on control knobs to release gas pressure in hose. 9. T ur n control knobs to OFF position. 10. Tighten any leaking connections.
LIGHTING INSTR UCTIONS: Follow the instructions e xactly . 1. OPEN THE GRILL LID before attempting to light a b urner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all b urner control knobs and the cylinder v alve are turned to the OFF position.
LIGHTING THE SIDE BURNER: 1. Open lid to the side bur ner before lighting. 2. T ur n on the side burner by pressing in and rotating the control knob to the HIGH position. 3. Press and hold the igniter button on the main control panel f or 3-5 seconds until the burner ignites.
11 OPERA TING THE GRILL: Never use Char coal or Lighter Fluid inside your Gas Grill. Read and follo w all warnings and instructions contained in the preceding sections of this manual.
R O TISSERIE COOKING: • Y our grill was pre-drilled from factory to include mounting holes for a Brinkmann rotisserie (sold separately). Do not use a rotisserie not specifically manuf actured for this g r ill. • Read and f ollow all instructions provided with the rotisserie.
TRANSPOR TING AND ST ORA GE: • Never mo ve a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder v alve is shut off. After moving the grill chec k that all gas connections are free of leaks. Refer to instructions for leak test on pa g e 7 of this manual.
CLEANING AND MAINTENANCE: • F or safe grilling and peak perf or mance of your g r ill, perf or m these checks at least twice per y ear or after e xtended per iods of storage . HARD W ARE • Be sure to tighten up all hardware (n uts, bolts, scre ws, etc.
TR OUBLE SHOO TING: Prob lem: P ossible Causes: • Burner will not light 1. Chec k LP cylinder fuel lev el. 2. Bad electrode spark. Check to see if the g r ill will “ match light. ” (See Page 9) Electrode or collector ma y need adjustment. 3. Burner may not be properly seated.
16 • T o protect your g r ill from excessiv e r ust, the unit must be kept clean and co vered at all times when not in use. A grill cov er may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717. • W ash cooking grills and heat shields with hot, soapy w ater , r inse well and dry .
ASSEMBL Y INSTRUCTIONS READ ALL SAFETY W ARNINGS & ASSEMBL Y INSTRUCTIONS CAREFULL Y BEFORE ASSEMBLING OR OPERA TING Y OUR GRILL. WE RECOMMEND TWO PEOPLE W ORK T OGETHER WHEN ASSEMBLING THIS UNIT .
(Proof of purchase will be required.) Inspect contents of the bo x to ensure all par ts are included and undamaged. 1 FOR MISSING P ARTS, PLEASE CALL CUST OMER SER VICE A T 1-800-527-0717.
19 8 M6 X 12mm bolts 8 M6 X 20mm bolts 14 M6 X 60mm bolts 1 AA /1.5V Alkaline batter y P AR TS CARD CONTENTS Make sure y ou hav e all items listed under P ARTS LIST and P ARTS B A G CONTENTS bef ore you begin the installation process . Y our P ar ts Bag will include: M6 X 12mm bolts M6 X 20mm bolts M6 X 60mm bolts AA /1.
Choose a good, cleared assembly area and get a friend to help you put your g r ill together . La y cardboard down to protect g r ill finish and assembly area. Step 1 Assemble bottom cart panel and right side car t panel assembly by using f our M6 X 60mm bolts (hand tighten only at this point).
Note: With the help of a friend, turn the cart over , try to minimize the stress to the side panels. Step 3 Attach locking casters to the bottom of the car t. Tighten caster bolts securely using he x nut wrench provided in par ts pac k. Note: With the help of a friend, turn the cart to its upright position.
22 Step 5 Place tank tra y assembly o ver v ent holes in bottom car t panel and secure using f our M6 X 12mm bolts. T ank tra y should slide in and out of car t freely . Step 6 Install door brac ket using the f our #10 X 1/2 ” self taping screws . Mak e sure door stop is set tow ard back of car t.
23 Step 7 Inser t right side door , placing lower piv ot into the pivot hole on bottom car t panel, then align door with car t frame . Depress spring pin located on top edge of door and slide door tow ard side car t panel until spr ing pin locks into hole in door br ack et.
Note: When performing Step 9, Lift grill body fr om front and rear panels to av oid injury to hands and fingers. Step 9 With the help of a friend, place grill body assembly on g r ill car t. Gr ill body will rest between upper side sections of car t. Align front edge of grill body assembly with front edges of car t frame legs.
25 Step 10 Attach side burner assembly to g r ill body assembly b y inser ting four M6 X 20mm bolts through the holes in the side burner assembly and into holes of grill body assembly . Tighten all four bolts . Install side burner grate and control knob .
Step 13 Attach side table/ice b uck et assembly to g r ill body assemb ly by inser ting f our M6 X 20mm bolts through the holes in the side table/ice b uck et assembly and into holes of grill body assembly . Tighten all f our bolts. Step 14 Inser t tool dra wer into front opening under control panel by dropping roller wheels into side channels.
Step 15 Inser t grill bottom into opening on backside of g r ill. Make sure to slide tra y onto trac ks as illustrated. Step 16 Slide grease tra y into grease tr ay brac ket located under grill bottom on backside of g r ill. Step 17 Hang stainless steel buc ket in cut- out of left side table/ice b uck et assembly .
28 Step 19 Place the stainless steel heat shields on low er lev el of grill body assembly directly abo ve b ur ners. Step 20 Place stainless steel cooking grills on suppor t ribs directly above stainless steel heat shields. Step 21 Place warming rack in slots abo ve cast iron cooking grills.
PROFESSIONAL SHISH-KABOB SKEWERS These heavy-duty , 18" shish-kabob skew ers are extra-long f or fab ulous restaurant style kabobs. Made of rust resistant stainless steel to last f or years. SET OF 12 812-2904-0 ACCESSORIES 29 RIB RA CK Chrome-plated rac k can greatly increase the cooking capacity of your g r ill.
ACCESSORIES LOOK FOR THESE AND O THER BRINKMANN A CCESSORIES A T Y OUR LOCAL RET AILER WHERE SMOKERS ARE SOLD , OR ORDER DIRECT BY CALLING 1-800-468-5252. THE UL TIMA TE 5-PIECE BBQ TOOL SET Yo u ’ ll be the envy of y our fello w outdoor chefs with this ultimate BBQ tool set.
140-2610-1 8/02, 12/03 W ARRANTY ©2002 The Brinkmann Cor poration Dallas, T e xas 75244 U .S.A www .brinkmanncor p .com The Brinkmann Cor poration warr ants to the or iginal purchaser that the Brinkm.
デバイスBrinkmann 2610 Seriesの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Brinkmann 2610 Seriesをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはBrinkmann 2610 Seriesの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Brinkmann 2610 Seriesの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Brinkmann 2610 Seriesで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Brinkmann 2610 Seriesを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はBrinkmann 2610 Seriesの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Brinkmann 2610 Seriesに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちBrinkmann 2610 Seriesデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
