Cisco SystemsメーカーOL-1911-05の使用説明書/サービス説明書
ページ先へ移動 of 30
CHAPTER 24-1 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 24 Configuring ATM Router Module Interfaces This chapter describes steps required to conf igure the A TM router modul.
24-2 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Overview of the ATM Router Module Overview of the ATM Router Module The A TM router module allows you to inte grate Layer 3 routing and A TM switching within a single chassis.
24-3 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Overview of the ATM Router Module Figur e 24-2 A TM Router Module T raf .
24-4 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Overview of the ATM Router Module • IP fragmentation support. • IP 6-path load balancing support. • Supports O AM-based PVC management.
24-5 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Hardware and Software Restrictions of the ATM Router Module Catalyst 8510.
24-6 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Hardware and Software Restrictions of the ATM Router Module Catalyst 8540.
24-7 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Hardware and Software Restrictions of the ATM Router Module Catalyst 8540.
24-8 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Hardware and Software Restrictions of the ATM Router Module Catalyst 8540.
24-9 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring ATM Router Module Interfaces • IP fragmentation. • IP 6-path load balancing. Note The A TM router module is only supported on A TM switches which ha ve a multiservice A TM switch processor installed.
24-10 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring ATM Router Module Interfaces Default ATM Router Module Inter.
24-11 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR) Con.
24-12 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR) Exa.
24-13 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR) Router 1 ATM Interface Router1# configure terminal Router1(config)# interface atm 2/0 Router1(config-if)# ip address 1.
24-14 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR) Router 1 ATM Interface Router1# configure terminal Router1(config)# interface atm 2/0 Router1(config-if)# ip address 1.
24-15 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR) LAN.
24-16 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Multiprotocol Encapsulation over ATM Router 2 Ethernet Inter.
24-17 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Multiprotocol Encapsulation over ATM Note T raff ic shaping and policing are not supported on the A TM router module interfaces; for traff ic shaping and policing on A TM connections, use VP tunnels.
24-18 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Multiprotocol Encapsulation over ATM Multiprotocol Encapsula.
24-19 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Classical IP over ATM in a PVC Environment Ethernet Router RouterB# configure terminal RouterB(config)# ipx routing RouterB(config)# interface fastethernet 2/0 RouterB(config-if)# ip address 20.
24-20 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Classical IP over ATM in an SVC Environment For a detailed description of the role and operation of the A TM ARP server , refer to the Guide to ATM T echnology.
24-21 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Classical IP over ATM in an SVC Environment NSAP Address Example Figure 24-7 shows three A TM switch routers and a router connected using classical IP over A TM.
24-22 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Classical IP over ATM in an SVC Environment Configuring as a.
24-23 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Classical IP over ATM in an SVC Environment Displaying the I.
24-24 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Bridging Configuring Bridging All PVCs conf igured on A TM router module interfaces are used for bridging.
24-25 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Bridging Switch(config)# interface atm 3/0/0 Switch(config-i.
24-26 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring Bridging Example In the following e xample only PVC 2, 200 i.
24-27 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces Configuring IP Multicast Configuring IP Multicast T o conf igure IP mult.
24-28 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces About Rate Limiting Rate limiting can be applied to indi vidual interfaces.
24-29 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces About Rate Limiting Example The following is an e xample of how to conf igure rate limiting on your switch router: Router# configure terminal Enter configuration commands, one per line.
24-30 ATM and Layer 3 Switch Router Software Configuration Guide OL-1911-05 Chapter 24 Configuring ATM Router Module Interfaces About Rate Limiting.
デバイスCisco Systems OL-1911-05の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Cisco Systems OL-1911-05をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCisco Systems OL-1911-05の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Cisco Systems OL-1911-05の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Cisco Systems OL-1911-05で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Cisco Systems OL-1911-05を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCisco Systems OL-1911-05の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Cisco Systems OL-1911-05に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCisco Systems OL-1911-05デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。