ClarionメーカーModel RK1の使用説明書/サービス説明書
ページ先へ移動 of 27
Model RK1 ➤ O O w w n n e e r r ’ ’ s s G G u u i i d d e e.
i limited lifetime consumer warranty This U ngo P ro Security system is warranted against defects in material and workmanship . The main unit is cover ed by this limited lifetime warranty . This Limited Lifetime W arranty applies to U ngo P ro Security systems that have been installed by an authoriz ed U ngo P ro Security dealer .
ii T O USE OF THE PR ODUCT . BECAUSE SOME ST A TES DO NOT ALL O W LIMIT A TIONS ON HO W LONG AN IMPLIED W ARRANTY L ASTS OR EX CLU- SIONS OR LIMIT A TIONS OF INCIDENT AL OR CONSEQUENTIAL DAMAGES, THE ABO VE LIMIT A TIONS OR EX CLUSIONS MA Y NO T APPL Y T O YOU.
1 table of contents limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i standard configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what is included . . . . . . .
2 standar d configuration controls the Lock/Panic ON/Panic OFF function. controls the Unlock function. controls Silent Lock/Unlock and an Auxiliary Output . controls remote engine start . / controls Timer mode. + controls T urbo/Short Run . + controls Channel 4 output.
3 what is included z Control module z Receiver/antenna z T wo four -button r emotes z Blue status LED indicator light z Push-button Override switch z Shut-down toggle switch important information Congratulations on the purchase of your r emote engine start keyless entry system.
4 FCC/ID notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful inter- ference, and (2) This device must accept any interfer ence received, including interference that may cause undesirable operation.
5 standard configuration Button The lock and panic functions are contr olled by pressing on the remote for one second. Button The unlock function is controlled by pr essing on the remote for one second. Button Silent Lock/Unlock and an optional auxiliary function are contr olled by this button in conjunction with the or button.
6 using your system warning! safety first The following safety warnings must be observed at all times: z Due to the complexity of this system, installation of this product must only be performed by an authorized dealer . z When properly installed, this system can start the vehicle via a com- mand signal from the r emote.
7 gear . This testing should be performed by an authorized dealer in accor- dance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear , cease remote engine start operation imme- diately and consult with the authorized dealer to fix the problem.
8 locking Pressing for one second locks the doors (if the door locks are con- nected) and activates the starter kill. The horn will honk (if connected) and the parking lights will flash once to confirm arming of the system. While the system is locked, the status LED will flash once per second.
9 unlocking Pressing for one second unlocks the doors (if connected). The horn will honk twice (if connected) and the parking lights will flash twice to confirm unlocking of the system. The optional Starter Kill will be deac- tivated. The status LED will turn off, unless the system is programmed for Passive Mode.
10 override mode Y ou can prevent your system from automatically activating the Starter Kill and locking the doors by using override mode. This is very useful when washing the vehicle or having it serviced.
11 remote engine start This feature allows you to r emotely start and run your vehicle for a pro- grammable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system.
12 When you are r eady to drive the vehicle: 1. Insert the ignition key and turn it to the RUN (not the ST ART) po- sition. 2. Press the brake pedal. N N o o t t e e : : If the brake pedal is pressed before the key is in the ON posi- tion, the engine will shut down.
13 take-over mode The Override take-over feature allows the vehicle to r emain running after the key has been removed fr om the ignition. This feature is use- ful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the cli- mate controls on.
14 3. Press and r elease the and buttons at the same time. 4. The lights will flash to indicate the remote engine start has entered short run turbo mode. 5. T ur n off the key , the engine will keep running. 6. Exit and secure the vehicle. 7. The engine will turn off after the programmed run time.
6. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. starter anti-grind circuity Whenever the vehicle is remote engine started, advanced anti-grind cir- cuitry prevents the starter fr om engaging, even if the key is turned to the start position.
16 power -up This system will store its curr ent state to non-volatile memory . If power is lost and then reconnected the system will r ecall the stored state fr om memory .
z Ignition switch-controlled door -locking on or off. With this feature on, the doors will lock 3 seconds after the ignition key is turned on, and unlock when the ignition key is turned off. z Passive Locking or Active Locking (doors lock only with the remote).
18 glossary of terms Control Unit: The “brain” of your system. Usually hidden underneath the dash area of the vehicle. It houses the micr oprocessor which mon- itors your vehicle and controls all system functions.
19 convenience expansions Listed below are some of the many expansion options available for use with your system. Some options may requir e additional parts and/or labor . Please consult with your dealer for a complete list of options available for use with this system.
20 Power Window Control: Power window contr ol can be provided by one of two systems. The firsts system provides contr ol that will roll up two windows automatically when the system is armed, or roll two win- dows down by using the remote. The second system will r oll two win- dows both up and down.
21 notes.
22.
23 QUICK REFERENCE GUIDE: T o lock using your remote ■ T o lock th e system press for on e second . The d oors will lock (if con- nected). Th e LED will begin to flash. The Starter Kill will pr event th e vehicle’s starter fr om crankin g if it has been installed .
Get Started Get Protected Ungo Pro Security 661 W . Redondo Beach Blvd. Gardena, Ca. 90247 800-GO-CLARION © 2003 Directed Electr onics, In c. - All ri ghts r eserved GRK1 10-03.
デバイスClarion Model RK1の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Clarion Model RK1をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはClarion Model RK1の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Clarion Model RK1の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Clarion Model RK1で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Clarion Model RK1を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はClarion Model RK1の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Clarion Model RK1に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちClarion Model RK1デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。