Cobra Electronicsメーカー29 LTD CHRの使用説明書/サービス説明書
ページ先へ移動 of 21
H o w t o U s e Y o u r C o b r a 2 9 L T D C H R Cont ents Fea tures ..................................................................................................1 The CB Story ....................................................................
Installation Installation Location 3 2 Mounting and Connection Mounting and C onnection Hold the radio with the mounting bracket in the exact desired location. If there is no interference, remov e the bracket and use it as a template to mark the location f or the mounting screws.
Installation Installation 5 4 Note Connecting to an accessory fuse prevents the unit from being left on accidentally , and also permits operating the unit without running the engine. Note In positive ground vehicles the red wire goes to the chassis and the black wire is connected to the ignition switch.
Ignition Noise Interference Antennas Use of a mobile receiv er at low signal lev els is normally limited by the presence of electrical noise. The primary source of noise in automobiles is from the alternator and ignition syst em. T ypically , when signal lev el is adequat e, the background noise does not present a serious problem.
The CB/P A button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the power cord , antenna and microphone are connected to their proper connectors before starting. Setting Channel Selec tor 2 1 Ro ta t e th e On / Off V olu me kn ob cl oc kwi se t o a normal listening level.
Operation Operation Calibrate For SWR (Standing W ave Ratio) 11 10 Note Antenna Indicator LED will illuminate when T X if SWR is high. Note Calibration must be made in an open area (never in a gar age). V ehicle doors must be closed. No one should be standing near the antenna.
Operation 13 Operation 12 Note The reading will be slightly higher on Channels 1 and 40 compared to Channel 20. Note When switched to SWR position the meter needle should ideally be as far to the left as possible. Anything over 3 is not acceptable. The antenna indicator will light.
The S/RF-SWR-CAL switch must be in the S/RF position to read the meter . Operation 15 Operation 14 1 S-Meter S-Meter Swings proportionately to strength of incoming signal when receiving .
Operation Operation 17 16 RF Gain Control Bright/Dim Switch RF Gain Contr ol The RF Gain is used to optimize recepti on in strong or weak signal areas .
F ull clockwise rotation closes the gate allowing only very strong signals to enter . F ull counter clockwise rotation opens the “ gate ” allowing all signals in. T o achieve the Desired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise .
Setting Dynamike® This controls the micr ophone sensitivity (outgoing audio level). T o T ransmit 21 T o T ransmit T ransmit T alkBack 20 Setting Dynamike® Caution! Be sure the antenna is properly connected to the radio befor e transmitting .
Operation Operation RF Meter 23 22 External Speaker RF Meter This meter swings proportionately to the RF output (outgoing signal) while transmitting . External Speaker The external speaker jack is used for remote receiver monit oring. The S/RF-SWR-CAL switch must be in the S/RF position.
Operation Operation P A (Public Address) 25 24 P A (Public A ddress) Connect an external P A speaker to the P A jack on the rear panel. Set CB/P A switch to P A position. Push and hold microphone button and speak in a normal voice. Y our voice will now transmit on the P A speaker .
T emporary Mobile Set-Up 27 Base Station Operation (From 120V AC House Current) T emporary Mobile Set-Up T emporary Mobile Operation F or temporary mobile operation you may w ant to purchase an optional automobile pow er adapter from your COBRA dealer .
How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 29 28 The FC C gives these examples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: P ermitted Example Message Y es “ T ornado sighted six miles nor th of town.
How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 31 30 Code Meaning 10-29 Time is up for contact 10-30 Does not conform to FC C rules 10-33 Emergency traffic 10-34 T rouble at this station 10-3.
29 L TD CHR Specifications Frequency Ranges 33 32 G ENERAL C h a n n e l s ..........................C B -4 0 C H Frequency Range . . . . . . . . . . . . . . . . . . CB - 26.965 to 27.405 MHz F requency T olerance . . . . . . . . . . . . . . . 0.005 % Frequency Control .
Optional Accessories 35 Replacement DC P ower Cord For in v ehicle use 426-002-N-001 Replacement Mounting Brack et For in v ehicle use 251-353-9-001 Replacement Thumb Screws For in v ehicle use 634-08.
36 Optional Accessories cont. 4 Pin Replacement Dynamic Microphone HG M73 4 Pin Noise Canceling Microphone HG M77 Dynamic External Speaker HG S100 Noise Canceling External Speaker HG S300 Noise Cancel.
The Citizens Band lies between the shortwave broadcast and 10-meter Amateur r adio bands, and was established by law in 1949. The C lass D two-way c ommunications service was opened in 1959. (CB also includes a Class A citizens band and Class C remote con trol frequencies.
426- 002- N-0 01 Repl ace ment D C P ow er Co rd 251- 353- 9-0 01 Replac eme nt Mou nti ng Br acket 634-081-9-001 Replacement Thumb Screws 741-080-9-001 Replacement Microphone Bracket HG A1000 21” B.
デバイスCobra Electronics 29 LTD CHRの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Cobra Electronics 29 LTD CHRをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCobra Electronics 29 LTD CHRの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Cobra Electronics 29 LTD CHRの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Cobra Electronics 29 LTD CHRで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Cobra Electronics 29 LTD CHRを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCobra Electronics 29 LTD CHRの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Cobra Electronics 29 LTD CHRに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCobra Electronics 29 LTD CHRデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。