Cobra Electronicsメーカー29 NWの使用説明書/サービス説明書
ページ先へ移動 of 20
H o w to Us e Y o u r C o b r a ® 2 9 N W Conten ts Fea tures ..................................................................................................1 The CB Stor y ..........................................................................
Installation Installation Location 3 2 Mounting and Connection Mounting and Connection Hold the radio with the mounting bracket in the exac t desired location. If there is no interference, remov e the bracket and use it as a template to mark the location for the mounting screws.
Installation Installation 5 4 Note Connecting to an accessory fuse prevents the unit from being left on accidentally , and also permits operating the unit without running the engine. Note In positive ground vehicles the red wire goes to the chassis and the black wire is connected to the ignition switch.
ANT P A.SP . EXT .SP . + POWER – DA TE OF MFG : JUNE 98 FCC ID:BBO3K229LTD COBRA MADE IN CHINA SERIAL NO.: 806135776 PRECISION ENGINEERED PRODUCT OF COBRA ELECTRONICS CORP .
The CB/P A button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the pow er cord, antenna and microphone are connec ted to their proper connectors before star ting.
E RFGAIN SWR CAL S NB/ ANL ANL OFF CB PA CH19 CH9 NOR M AX MIN MAX O SQL DIMMER HI NOR MIN MAX RX/TX ANT 29 NW L TD CLASSIC TONE While holding mic button adjust the SWR CAL k nob so the meter needle swings to the CAL ▼ mark on the meter (located on the r ight).
Rotate the On/Off V olume k nob clockwise the green RX/TX LED will be illuminated. Repeat the same steps two through five on Channel 1 and 40. T his will check SWR for all channels. The S/RF-SWR-CAL switch must be in the S/RF position to read the meter .
When switched to ANL the Automatic Noise Limiter is activated. This helps reduce noise created by the vehicle ’ s elec tronics. When switched to NB/ANL position the RF Noise Blanker is also activated, providing increased noise filtration. When switched to OFF position all noise filtration will be turned off.
F ull clockwise rotation closes the gate allowing only very strong signals to enter . F ull count erclockwise rotation opens the “ gate” allowing all signals in. T o achieve the D esired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise.
Setting Dynamike This controls the microphone sensitivity (outgoing audio level). T o T ransmit 19 T o T ransmit T ransmit 18 Setting Dynamike Caution! Be sure the antenna is properly connected to the radio before transmitting . Prolonged transmitting without an antenna, or a poorly matched antenna, could cause damage to the transmitter .
Operation Operation RF Meter 21 20 External Speaker RF M eter This meter swings propor tionately to the RF output (outgoing signal) while transmitting. External Speaker The external speaker jack is used for remote receiv er monitoring. The S/RF-SWR- CAL switch must be in the S/RF position.
Operation Operation P A (Public Address) 23 22 P A (Public Addr ess) Connect an external P A speaker to the P A jack on the rear panel. Set CB/P A switch to P A position. Push and hold micr ophone button and speak in a normal voice . Y our voice will now transmit Adjust P A speaker volume with the Dynamike control .
T emporar y Mobile Set-Up 25 Base Station Operation (From 120V AC House Current) T emporar y Mobile Set-Up T emporar y M obile Operation F or temporar y mobile operation you may want to purchase an optional cigarette lighter adapter from your COBRA® dealer .
How Y our CB Can Ser ve Y ou How Y our CB Can Ser ve Y ou 27 26 The FCC gives these examples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: P ermitted Example Message Y es “ T ornado sighted six miles nor th of town.
How Y our CB Can Ser ve Y ou How Y our CB Can Ser ve Y ou 29 28 Code Meaning 10-29 Time is up for contact 10-30 Does not conform to FCC rules 10-33 Emergency traffic 10-34 T rouble at this station 10-.
29 NW Specifications Frequency Ranges 31 30 GENERAL CHANNELS . . . . . . . . . . . . . . . . . . . . . . . . CB - 40 CH FREQUENCY RANGE . . . . . . . . . . . . . . . . CB - 26.965 TO 27.405 MHZ FREQUENCY T OLERANCE . . . . . . . . . . . 0.005 % FREQUENCY CONTROL .
Limited T wo Y ear W arranty 33 32 COBRA® ELECTRONICS CORPORA TION warrants that its COBRA® CB Radios, and the com po nent parts thereof , will be free of defects in workmanship and materials for period of two (2) years from the date of first consumer purchase.
35 34 Optional Accessories Accessor y Order Info Optional Accessories Y ou can find quality Cobra products and accessories at your local Cobra dealer , or in the U.S.A., you can order directly from Cobra. See ordering info on pa ge 35. Ordering From U.
SIG 1 3 5 7 9 +30dB 2 3 CAL RF SWR RF DYNAMIKE RFGAIN SWR CAL S/RF SWR CAL NB/ ANL ANL OFF CB PA CH19 CH9 NOR M IN MAX MIN MAX OFF VOL SQL DIMMER HI NOR M IN MAX R X/TX ANT 29 NW LTD CLASSIC TONE The Citizens Band lies between the shor twave broadcast and 10-meter Amateur radio bands, and was established by law in 1949.
ANT P A.SP . EXT .SP . + POWER – DATE OF MFG : JUNE 98 FCC ID:BBO3K229LTD COBRA MADE IN CHINA SERIAL NO.: 806135776 PRECISION ENGINEERED PRODUCT OF COBRA ELECTRONICS CORP . CHICAGO, ILL.60707 Thank you for purchasing the Cobra® 29 NW CB Radio.
デバイスCobra Electronics 29 NWの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Cobra Electronics 29 NWをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCobra Electronics 29 NWの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Cobra Electronics 29 NWの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Cobra Electronics 29 NWで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Cobra Electronics 29 NWを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCobra Electronics 29 NWの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Cobra Electronics 29 NWに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCobra Electronics 29 NWデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。