CoregaメーカーCG-WLAPGMNの使用説明書/サービス説明書
ページ先へ移動 of 39
User Manual Wireless108M Acc ess P oint CG-WLAPGMN.
.
WLAPGMN User Manual 1 1 C ontents Regulatory Compliance............................................................................................... 2 1. Product Introduction...........................................................................
WLAPGMN User Manual 2 2 2 2 2 FC C Interference Sta tement This device complies with P art 15 of FCC rule. Operation is subject to the following two conditions: • This device may not cause harmful interference. • This device must accept any int erference received , including inter ference that may cause undesired operation.
3 3 3 WLAPGMN User Manual 3 3 corega WLAPGMN is a high speed Wireless Access P oint, which support IEEE 802.11b/g standard with speed up to 108 Mbps provide higher data rate and through is suitable f or user who has high speed transmission requirement.
WLAPGMN User Manual 4 4 4 1. LAN LED (Green) On: Connected Blink: T ransmitting or receiving data OFF: Disconnected 2. WLAN LED (Green) ON: Connected Blink: T ransmitting or receiving data OFF: Disconnected 3. Power LED(Gr een) Indicate power configura tion 4.
5 5 WLAPGMN User Manual 5 2.1 Envir onment Requirements • A computer has configured TCP/IP • An availabe RJ-45 port on an Ethernet Hub/Switch/Router/Modem • A WLAN adapter which compliance with IEEE802.11g , IEEE802.11b, or IEEE802.11 standard.
WLAPGMN User Manual 6 6 6 2.3 Connect to WL AN adapter First at all, you ha ve to prepare a WLAN adapter which has been installed in computer , and verify the setting of the WLAN adapter are the same .
7 7 WLAPGMN User Manual 7 This section lead you to configure the settings of wireless LAN adapt ers installed in other computers to connect with WLAPGMN.
WLAPGMN User Manual 8 8 3. Setting completed, it is available t o sur f on internet through WLAPGMN. 3.2 Setting up the Centr ino in W in-XP(SP2) OS 1. From the [Start Menu], selec t [Settings] -> [Control P anel]-> [Net- work]->double click [ Wireless network connection].
9 WLAPGMN User Manual 9 3. If the WLAPGMN has not enable the security function, it will show up below screen, click [Connect Anyway] to con tinue. * Note: 1. “ corega” is the default ESSID of WLAPGMN, once ESSID in WLAPGMN has been changed, the ESSID in WLAN adapter has to be changed, too .
WLAPGMN User Manual 10 10 10 3.3 Setting up corega WLAN adapter Follo wing steps were taken corega WLCB54GS for instanc e: 1. Double click icon on system tra y , and it will show up the utility screen. If there’ s no icon appears on syst em tray , please press [Start] => [Programs]=>[corega C G-WL CB54GS]=> [ Wireless LAN Utility].
11 11 WLAPGMN User Manual 11 This section take Windows XP f or instance. Before starting, you hav e to set up TCP/IP and w eb browser first. The steps as below: Step1.
WLAPGMN User Manual 12 12 3. Select b oth [Use the f ollowing IP address] and [Use the follo w- ing DNS server addresses] (Recommended). Enter the IP address between 192.168.1.1~192.168.254 range (exc ept 192.168.1.230); submask is 255.255.255.0=>click [Advanc ed].
13 WLAPGMN User Manual 13 2. Click [Connections] tab=>select [LAN Settings]. 3. Please uncheck the three items in below screen (don ’t select any- one)=> click [OK].
WLAPGMN User Manual 14 14 4. Please click [OK] to close the [Internet Options] screen. Step3. Setting Utility Program T o make sure successful setting, please exit the virus and firewall pro- gram before setting the products. After setting completed , they can be opened again.
15 WLAPGMN User Manual 15 Y ou are now in the utility program for setting , details as below : 4.1 Status 1. Select [Stauts], it will display all status for c orega WLAPGMN. 4.2 W izard ( Q uick Installation) This section will lead you quick installation.
WLAPGMN User Manual 16 16 2. Y ou will see [SSID] and [Channel] in the following screen, you may change it or not, but recommanded to change it to make sure the security . ＊ Note: the default SSID(ESSID) is "corega", and default channel is 6.
17 WLAPGMN User Manual 17 4. Setting completed, please press [Reboot] for saving the changes . 5. It will show up Saving screen, few seconds later , it will return to re-login prompt box. 6. Change the same ESSID for all WLAN adapters which connected to WLAPGMN.
WLAPGMN User Manual 18 18 Item Description MAC Address Display corega WLAPGMN’ s Mac address Get IP From There are 2 selections: Manual and DHCP * Default is [Manual]. IP Address Default is [192.168.1.230]. Subnet Mask Default is [255.255.255.0]. Default Gateway Default is [192.
19 WLAPGMN User Manual 19 Beacon Interval (20-1000) Default is [100], recommanded don't change it. DTIM (1-255) Default is [1], recommand don't change it. Fragmen tation Length (256~2346) Enter even numbers. Default is [2346], recommanded don't change it.
WLAPGMN User Manual 20 20 Item Specification Authentication Once choosing WEP must select [Shared Key]; choosing WP A will directly click [OK] to go next step. * Default is [Open System]. V aild Key Select one of default WEP Key groups F irst~F ourth.
21 WLAPGMN User Manual 21 2. Enter 9~63 characters in [PassPhr ase]->select [Cipher T ype], once configure completed , click [Apply]. * Note: 1. Group Key Update Interval: enter a number to indicate the key exchanged per minute . 2. If any setting has been changed, you hav e to click [Reboot]- >[Restart] to save the changes.
WLAPGMN User Manual 22 22 2. Enter 9~63 characters in [P assPhrase]->select [Cipher T ype], setting [Security Ser ver Settings] table, once configure complet ed, click [Apply]. * Note: If any setting has been changed , you have to click [Reboot]- >[Restart] to save the changes.
23 WLAPGMN User Manual 23 Item Description Control Disable: Disable the mac address filter function. Accept:Only connect with the mac address which list the table. Reject:Only conntect with the mac address which list the table. MAC Address Enter the mac address of the WLAN adapter which connected with computer .
WLAPGMN User Manual 24 24 Hub/Switch Internet 2. P to MP Bridge Mode: each one set the same channel, different ESSID Click[Advanc ed]->[Configuration]->[AP Mode]->[PtMP Bridge]- >enter Mac Address in [Remote AP MA C Address], once configure completed , click [Apply].
25 WLAPGMN User Manual 25 3. Repeater Mode: each one set the same ESSID Click[Advanc ed]->[Configuration]->[AP Mode]->[AP Repeater]- >enter Mac Address in [Root AP MA C Address]->configure [Sit e Survey], once configure completed, click [Apply].
WLAPGMN User Manual 26 26 * Note: If any setting has been changed , you have to click [Reboot]- >[Restart] to save the changes. Hub/Switch Internet <WLAN Partition> Click[Advanc ed]->[Configuration]->[ WLAN Partition]->check the box, once configure completed , click [Apply].
27 WLAPGMN User Manual 27 * Note: If any setting has been changed , you have to click [Reboot]- >[Restart] to save the changes. <Device Information> Click[Advanc ed]->[Configuration]->[Device Inf ormation]->setting [System Name], once configure complet ed, click [Apply].
WLAPGMN User Manual 28 28 <Misc> Click[Advanc ed]->[Management]-[Misc], once configure c ompleted, click [Apply]. * Note: If any setting has been changed , you have to click [Reboot]- >[Restart] to save the changes.
29 WLAPGMN User Manual 29 1. Click [Advanced]->[Maintenanc e]->[Restar t Syst em]->all new set- tings will be saved . 2. It will show up the Saving screen, several seconds later , it will return to re-login screen. * Note: • This function is the same as [Reboot].
WLAPGMN User Manual 30 30 30 4.4 Statistics The screen displays the sta tistics of throughput. 4.5 Reboot 1. Click [Reboot]->click [Restar t], all new settings will be saved . 2. It will show up the Saving screen, severl seconds later , it will return to re-login screen.
31 31 WLAPGMN User Manual 31 There are 2 wa ys for solving your problems: (1) First , please see following “F AQ” t o check your problem. (2) Please go to http://www .corega-asia.c om, click “Suppor ts ”=>select “Online Customer Support” , => fill in the form, =>click “submit” .
WLAPGMN User Manual 32 32 fire glass wall or door . It is to say to a void the barriers between WLAPGMN and Wireless LAN adapter . 2. Shor ten the distance between WLAPGMN and WLAN adapters.
33 WLAPGMN User Manual 33 * Once you for get the password or want to r eturn to initial status, please run this function. * Details please refer to [chapter 5.
WLAPGMN User Manual 34 34 34 Standard WLAN:IEEE802.11 IEEE802.11b IEEE802.11g LAN: IEEE802.3 IEEE802.3u IEEE802.3x LAN Interface 100BASE-TX/10BASE-T×1 RJ-45 por t Frequency Band 2.4~2.5 GHz T ransmission method DS-SS/OFDM M odulation system IEEE 802.
35 35 WLAPGMN User Manual 35 corega K.K. designs , develops and markets professional networking products that address the specific needs of small and medium enterprises and home user ’ s easy-to-use, qualit y and reliable services of networking solutions requirements.
.
www .corega-asia.com PN : S30-UM8201-00 Rev .A 7F ., No. 10, Lane 345, Y angGuang St. Nei-Hu Chiu, T aipei City 114, T aiwan R.O.C. TE L : + 88 6-2 - 87 5 1- 9 16 4 F A X: +8 8 6- 2 -8 7 51 - 91 74 corega T aiwan Inc.
デバイスCorega CG-WLAPGMNの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Corega CG-WLAPGMNをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCorega CG-WLAPGMNの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Corega CG-WLAPGMNの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Corega CG-WLAPGMNで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Corega CG-WLAPGMNを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCorega CG-WLAPGMNの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Corega CG-WLAPGMNに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCorega CG-WLAPGMNデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
