D-LinkメーカーDFE-500TXの使用説明書/サービス説明書
ページ先へ移動 of 26
Model DFE-500TX Fast Ethernet Adapter for PCI Bus User’s Guide Rev. 06 (May, 1997) 6DE-E50-0TX-.06 Printed in Taiwan RECYCLABLE.
Table of Contents 1. INTRODUCTION ............................................................ 1 ABOUT FAST ETHERNET ............................................. 1 ABOUT AUTONEGOTIATION ........................................ 2 ABOUT PCI BUS .......
1 1 Introduction Thank you for choosing D-Link DFE-500TX, the value leader among Fast Ethernet adapters for PCI − Bus personal computers. This Introduction chapter will be useful if you are new to Fast Ethernet and other new technology featured by the DFE-500TX.
DFE-500TX Ethernet PC Card User's Guide 2 The DFE-500TX Adapter does not support the 100Base-T4 subtype. To provide compatibility in tr a ditional 10Mbps Ethernet environments (where, for example.
DFE-500TX Ethernet PC Card User's Guide 3 Startup communication between the two devices o c curs when both devices are power-on, the cable connection between them is good, and the Network Operating System software is running.
DFE-500TX Ethernet PC Card User's Guide 4 throughput by reducing latency (waiting for CPU service) during trans mi s sions and receptions. Features Designed for versatility and performance, the D.
DFE-500TX Ethernet PC Card User's Guide 5 • Five LED indicators : 100Mbps/10Mbps , Full/Half Duplex , Link , Active , and Collision • Drivers for all leading Network Operating Systems.
2 2 Installation Installation of a DFE-500TX Ethernet Adapter requires hardware installation first, then software installation. Unpack and Inspect CAUTION : Under ordinary circumstances, a DFE-500TX card will not be affected by static charge as may be received through your body during handling of the unit.
DFE-500TX Ethernet PC Card User's Guide 8 Install the Adapter 1. Shut down the computer, unplug its power cord, and remove the chassis cover. 2. If your order does not include the Boot ROM option, go ahead to Step 3.
DFE-500TX Ethernet PC Card User's Guide 9 Connect the Network Cable Category 5 UTP cable is good enough to qualify under both the Fast Ethernet cabling rules and the trad i tional Ethernet cabling rules. The maximum individual cable run between any station and its supporting hub is 100m.
DFE-500TX Ethernet PC Card User's Guide 10 Connecting for 10Mbps Ethernet Category 3, Category 4, and Category 5 UTP cable , as well as EIA/TIA - 568 100-ohm STP cable, all qualify under Ethernet c a bling rules. The maximum cable run between the DFE-500TX and the supporting hub is 300 ft.
DFE-500TX Ethernet PC Card User's Guide 11 Verification/Diagnostic Program This test program verifies configuration of the DFE-500TX as set by the installation procedure, and assists with isolation of any faults in operation.
DFE-500TX Ethernet PC Card User's Guide 12 2. Key <RETURN> to bring up the Configuration Data screen. Review the reported configuration data before proceeding to Step 3. 3. The Configuration Data screen also features a Diagnostic Menu. Follow the cues at the foot of the screen to select and run the Adapter Basic Diagnostic program.
DFE-500TX Ethernet PC Card User's Guide 13 In the Controller Loopback test, test signals are generated at the rate of 100Mbps, and are intercepted and reflected at the MAC level without reaching the network cable .
DFE-500TX Ethernet PC Card User's Guide 14 5. Remove the DFE-500TX Software Diskette from your station's (the primary station's) diskette drive, and insert it into an available drive of a second station on your LAN. At the DOS prompt (here shown as > ), key in: > A: DIAGDIAG500.
DFE-500TX Ethernet PC Card User's Guide 15 other boards, or improper installation. In the event that any of the verification/diagnostic tests fails, review the following trouble shooting list. 1. Ascertain that the adapter card is fully and firmly seated in the slot connector.
A A Troubleshooting If you experience any problems with the adapter, first ascertain that the appropriate driver is loaded, that the proper grade of cable is employed for the network connection, and that the supporting hub is properly qualified for the application (such as 10BASE-T or 100Base-TX).
DFE-500TX Ethernet PC Card User's Guide Specifications Network Type: • Ethernet 100Base-TX Ethernet IEEE 802.3u standard for 100Mbps baseband CSMA/CD local area network • Ethernet 10BASE-T Ethernet IEEE 802.
DFE-500TX Ethernet PC Card User's Guide Operating: 0 ° to 55 ° C, (32 ° to 131 ° F) Humidity: 10% to 90% non-condensing Power Consumption: 1.05W (Max.) PCB Layer: 4 layers Device Drivers* • D-Link TCP/IP for DOS • NDIS driver • Novell Netware 3.
DFE-500TX Ethernet PC Card User's Guide 2 Error! Style not defined. Active LED, 6; 18 autonegotiation, 2 - 4; 5; 19 BIOS Program, 8; 17 Boot ROM, 7; 8 cabling, 2; 3; 5; 9; 10; 12; 15; 17; 18 CMOS.
Offices U.S.A. D-LINK SYSTEMS, INC. 5 Musick Irvine, CA 92618 USA TEL: 1-714-455-1688 FAX: 1-714-455-2521 CANADA D-LINK CANADA, INC. 2180 Dunwin Drive, Unit # 6, Mississauga Ontario, L5L 5M8, Canada TEL: 1-905-828-0260 FAX: 1-905-828-5669 U.K. D-LINK (EUROPE) LTD.
Subject to the terms and conditions set forth herein, D-Link S ystems, Inc. (“D-Link”) provides this Limited Warranty: • Only to the person or entity that origina lly purchased the product from .
Link in writing, the replacement Software is provided onl y to the original licensee, and is subject to the terms and conditions of the lic ense granted by D-Link for the Software. Replacement Software will be warranted for the remainder of the or iginal Warranty Period and is subject to the same limitations and excl usions.
repair or service in any way that is not c ontemplated in the documentation for t he product , or if the model or serial number has been al tered, tampered with, defaced or removed; Initial installati.
CE Mark Warning: This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user ma y be required to take adequate measures. FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Registration Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights..
デバイスD-Link DFE-500TXの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
D-Link DFE-500TXをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはD-Link DFE-500TXの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。D-Link DFE-500TXの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。D-Link DFE-500TXで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
D-Link DFE-500TXを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はD-Link DFE-500TXの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、D-Link DFE-500TXに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちD-Link DFE-500TXデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
